首页 | 官方网站   微博 | 高级检索  
     

诱导结晶工艺处理含铜废水
引用本文:阎中,熊娅,王凯军,张国臣.诱导结晶工艺处理含铜废水[J].化工学报,2009,60(10):2603-2608.
作者姓名:阎中  熊娅  王凯军  张国臣
作者单位:北京市环境保护科学研究院;清华大学环境科学与工程系
基金项目:国家高技术研究发展计划(863计划) 
摘    要:利用诱导结晶法处理浓度为20、50、100 mg.L-1的含铜废水,稳定运行后去除率皆能达到90%以上。实验连续运行145 d,定期取出结晶产物,通过SEM-EDS测试发现:结晶颗粒逐渐长大,其组成为碱式碳酸铜,分子式推测为CuCO3.Cu(OH)2.xH2O。本文还考察了沉淀剂种类、进药比、水力负荷以及停留时间对诱导结晶工艺处理含铜废水的影响。结果表明:当废水中[Cu2+ ]为20 mg.L-1时,最佳运行条件为:以碳酸钠为沉淀剂,进药比在1~2,水力负荷不高于25 m.h-1。停留时间对结晶工艺的影响不大。

关 键 词:诱导结晶  重金属  含铜废水  影响因素  
收稿时间:2009-4-13
修稿时间:2009-5-22  

Copper removal by induced crystallization from copper-containing wastewater
Abstract:Induced crystallization is employed to treat copper-containing wastewater in this study.The copper removal efficiency can be achieved to 90% when the influent copper concentration is 20 mg.L-1,50 mg.L-1,100 mg.L-1.For a 145 d experiment,it can be found a noticeable crystal growth,which can be speculated as alkaline copper carbonate [CuCO3.Cu(OH)2.xH2O)]as measured by SEM-EDS.Optimized conditions for copper removal efficiency were investigated by varying the type of chemical reagents,the molar ratio of CT to Cu,the hydraulic loading and the hydraulic retention time.The best results were obtained when the chemical reagent is Na2CO3,the molar ratio of CT/Cu is1—2,and the hydraulic loading is not higher than 25 m.h-1.
Keywords:induced crystallization  heavy metals  copper-containing wastewater  affecting factor
本文献已被 万方数据 等数据库收录!
点击此处可从《化工学报》浏览原始摘要信息
点击此处可从《化工学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号