| 冷却速度对超高强马氏体钢的马氏体相变起始温度和硬度的影响 |
| |
| 引用本文： | 李春辉,李晓源,尉文超,王毛球,吴润.冷却速度对超高强马氏体钢的马氏体相变起始温度和硬度的影响[J].金属热处理,2022,47(7):183-189. |
| |
| 作者姓名： | 李春辉 李晓源 尉文超 王毛球 吴润 |
| |
| 作者单位： | 1.武汉科技大学 材料与冶金学院, 湖北 武汉 430081;2.钢铁研究总院有限公司 特殊钢研究院, 北京 100081 |
| |
| 摘 要： | 采用热膨胀法测量了马氏体试验钢在20~70 ℃/s冷却速度下的马氏体相变起始温度(Ms点温度),并研究了其对试验钢硬度的影响。结果表明,冷却速度的提高可增加奥氏体强度、提高奥氏体的热稳定性,进而降低马氏体相变起始温度。同时,更高的冷却速度容易造成晶格畸变,增大位错密度,还会提高过冷度,细化有效晶粒尺寸,使试验钢的硬度提高。
|
| 关 键 词： | 马氏体钢 冷却速度 Ms点温度 硬度 |
| 收稿时间： | 2022-02-12 |
Effect of cooling rate on martensitic transformation initiation temperature and hardness of super high strength martensitic steel |
| |
| Li Chunhui,Li Xiaoyuan,Yu Wenchao,Wang Maoqiu,Wu Run.Effect of cooling rate on martensitic transformation initiation temperature and hardness of super high strength martensitic steel[J].Heat Treatment of Metals,2022,47(7):183-189. |
| |
| Authors: | Li Chunhui Li Xiaoyuan Yu Wenchao Wang Maoqiu Wu Run |
| |
| Affiliation: | 1. School of Materials and Metallurgy, Wuhan University of Science and Technology, Wuhan Hubei 430081, China;2. Research Institute of Special Steel, Central Iron and Steel Research Institute Co., Ltd., Beijing 100081, China |
| |
| Abstract: | Martensite transformation initiation temperature (Ms temperature) of martensitic steel with cooling rate of 20-70 ℃/s was measured by thermal expansion method, and its effect on hardness of the tested steel was studied. The results show that the increase of cooling rate enhances the strength of austenite, improves the thermal stability of austenite, and then decreases the initiation temperature of martensite transformation. At the same time, a higher cooling rate is more likely to cause lattice distortion, increase the dislocation density, increase the degree of undercooling and refine the effective grain size, which increases the hardness of the tested steel. |
| |
| Keywords: | martensitic steel cooling rate Ms point temperature hardness |
|
| 点击此处可从《金属热处理》浏览原始摘要信息 |
|
点击此处可从《金属热处理》下载全文 |
|
