共查询到20条相似文献,搜索用时 171 毫秒
1.
2.
3.
对机械镀锌原理、优缺点、工艺流程、工艺要点进行了概述,用文内的方法能获取质量合格的厚度达到70μm机械镀锌层。 相似文献
4.
5.
6.
7.
8.
主要介绍了机械镀锌工艺在工程机械燃油箱上的应用,机械镀锌工艺与其他几种镀锌方法在工程机械燃油箱上的应用的比较优势和在应用实践中的实施方法。 相似文献
9.
10.
11.
责任是人应主动承担的角色义务和对其因过失所造成后果应承担的责罚.有两层涵义:一是义务;二是后果.责任心是个体自觉做好分内事务和履行道德义务的心理倾向,是个性心理品质成分中自我特征维度上的重要内容.责任心具有两个方面的涵义:一是角色分内职责;二是角色道德义务.责任心是一种通过责任认知、责任个性和责任适应的动态形式表现出来的静态品质,责任心是责任心过程结构与责任心关系结构相互制约、相互影响的统一体. 相似文献
12.
A series of fracture mechanics tests of a set of random and impact copolymers of polypropylene, in which the ethylene content was varied, is described. The plane strain toughness is found to change from the homopolymer value, but thereafter to be independent of ethylene content. The yield stress of the impact copolymers decreases markedly with ethylene content, while that for random copolymers increases only slightly. This is reflected in toughness values in tension. A comparison with the behavior of other rubber-modified materials is made and it is concluded that crazing is an important mechanism in polypropylene and is perhaps more rate and temperature sensitive than in acrylonitrile-butadiene-styrene (ABS). 相似文献
13.
Two optimization problems are considered. One of them is the problem of the sequence of separation of a ternary mixture in a two-step system for which the energy consumption in processes at given capacities is minimal, and the other is the problem of the optimal distribution of contact surfaces between the first and second steps. For thermal separation systems, the dependence of the maximum possible capacity of the system on the sequence of separation of components is analyzed. 相似文献
14.
15.
16.
针对原富马酸重结晶过程中,漂浮物太多,产品粒度太小,导致重结晶收率低;改进重结晶工艺,使结晶收率达到95%以上,降低劳动强度,节能效果明显,质量明显改善。 相似文献
17.
用比浊法对钛白粉水分散性的测定进行了研究,改进了传统的测定水分散性的方法,建立起稳定、简捷的测量体系,能够运用于钛白粉水分散性的检测,结果令人满意。 相似文献
18.
以多聚甲醛和正丙醛为原料,分别以氨水和氢氧化钠为催化剂,采用两步法合成了三羟甲基乙烷。考察了催化剂种类、催化剂用量、反应温度和反应时间等对三羟甲基乙烷产率的影响,优化了反应条件。在15g多聚甲醛、11mL质量分数98%的正丙醛溶液、40mL蒸馏水、5mL质量分数50%NaOH溶液的反应条件下,于70℃反应1.5h,三羟甲基乙烷产率最高可达95.2%。 相似文献
19.
四乙酰基二硝基六氮杂异伍兹烷分子结构研究 总被引:1,自引:0,他引:1
四乙酰基二硝基六氮杂异伍兹烷(TADNIW)是合成六硝基六氮杂异伍兹烷(HNIW)的中间体。该文用Gaussian 98软件包,采用密度泛函理论B3LYP和标准基组6-31G对所选构型进行了全优化计算,在结构上对TADNIW的键长、键角、二面角、Mu lliken电荷及集居数进行了理论分析,发现笼形化合物的六元环成船式构象,硝基处于桥头,骨架以亚稳态存在。结构分析表明,六元环上N—NO2键相对较稳定,采用一般的硝解条件反应不能进行,作者提出了新的反应机理,即水解-硝化假设:含有酰胺基团的一类化合物在含水的硝化介质中首先发生水解生成相应的仲胺,碱性较强的仲胺再在氮硝化催化剂的作用下,迅速硝化成硝胺。计算得到TADNIW分子总能量为-1 583.375 682 a.u.,前线轨道能量差ΔE(ELUMO-EHOMO)为4.123 eV。计算IR谱图与实验IR谱图对比,误差小于20 cm-1。 相似文献