首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到10条相似文献,搜索用时 52 毫秒
1.
 根据某钢厂的环冷机系统回收与利用烧结矿显热的工艺流程,绘制了能流图、火用流图,并建立相关能量评价指标,采用热平衡方法和火用分析方法对环冷机的余热回收利用状况进行研究,分析了余热资源在回收与利用过程中的热量损失、火用量损失、热效率与火用效率。结果表明:环冷机、余热锅炉2个环节的热效率分别为26.78%和45.60%,火用利用效率分别为22.88%和45.08%,环冷机是余热回收与利用的薄弱环节;目前影响余热回收与利用的主要因素是环冷机取热段的漏风问题、第三段冷却废气所携带的显热尚未被利用以及烧结矿层的气固换热过程。  相似文献   

2.
Rare earths-doped oxyfluoride glasses based on germanium oxide and lead fluoride were prepared from commercial raw materials. The glasses with general composition of 50GeO2-(50-x-y)PbO-yPbF2-xLnF3 (Ln=Pr3+-Yb3+), contained different concentrations of optically active dopants (x=0.2 mol.% and 2 mol.%) and PbF2 (y≤15 mol.%). The differential thermal analysis (DTA) was used to determine both thermal characteristic and thermal stability properties of the glasses in the function of the kind of dopant, its concentration, and a glass composition. Characteristic glass temperatures such as glass transition temperature (Tg), glass crystallization temperature (Tc) and temperature corresponding to the maximum of the crystallization rate (Tpc) were evaluated. On the basis of obtained results, the thermal stabilities of glasses under study were evaluated using various thermal stability criteria (Dietzel factor ?T, Saad-Poulain factors H' and S). It was found that the increase in rare earth fluoride contents influenced thermal characteristics when the characteristic temperatures of the individual glass was shifted towards higher values. The effect of the PbF2 content and the kind of rare earth impurity on the glass stability was observed. Absorption spectra of lanthanide-doped glasses were measured at room temperature and used to determine the phenomenological intensity parameters Ωt and next, to estimate radiative properties of lanthanide ions in this matrix. Radiative transition probabilities of luminescent states of Ln3+, branching ratios and radiative lifetimes were determined. The variation of the Ωt along the lanthanide series was presented and discussed.  相似文献   

3.
The amount of Cu coating by chemical plating was investigated based on quadratic regression orthogonal experimental design being adapted to the variation law of temperature,pH value and Ni2+concentration,and the relevant regression equation was expressed as y=2.1609+0.5295×10-3T2-0.0342P2-0.0265N2+0.0023TP+0.0020TH+0.0199PN-0.0959T+0.3814P-0.2073N.The results showed that the deposition rate augmented with the increasing in temperature,pH value and Ni2+concentration.The experimental parameters of the optimal coating were temperature 75 ℃,pH value 8.5 and Ni2+concentration 1.2 g/L.The electrochemical tests indicated that the cycle stability increased from 60.66% to 75.58%,indicating that the treated alloy exhibited better corrosion resistance.  相似文献   

4.
The types,morphologies and distributions of nonmetallic inclusions in Cu-P weathering steels with and without rare earth were analyzed through a quantitative image analyzer,scanning electron microscopy(SEM)and energy dispersive spectroscopy(EDS)attached to SEM.Solid-soluble content of rare earth in the steels was analyzed by non-aqua electroanalysis and ICP.The results showed that rare earth modified the types and the morphologies of inclusions in the weathering steels.The small spherical rare earth oxysulfides and rare earth sulphides replaced the elongated MnS inclusions in the RE weathering steels.The rare earth inclusions dispersedly distributed and most inclusions were smaller than 2 μm in size.The optimum content of RE was 0.0065%-0.016% for 10PCuRE weathering steels containing about0.002% oxygen and 0.004% sulfur.Solid-soluble content of rare earth in steels was(14-20)x 10-6,which can act as a micro-alloying element.The corrosion resistance of 10PCuRE weathering steels and Q235 were studied by dry-wet cyclic immersion test.Their corrosion rates were obtained respectively.The polarization curves and pitting corrosion behaviors of weathering steels with and without rare earth were measured by electrochemical methods.The corrosion resistance of Cu-P weathering steels was improved by adding an appropriate amount of rare earth.Less and fewer rare earth inclusions largely decreased pitting susceptibility and rate of pit propagation.The pitting potential and the resistance against pitting corrosion of the RE weathering steel were significantly improved due to the modification of rare earth to inclusions.  相似文献   

5.
Present-day advanced technologies heavily rely on the exciting magnetic and spectroscopic properties of lanthanide ions. In particular, their ability to generate well-characterized and intense near-infrared (NIR) luminescence is exploited in any modern fiber-optic telecommunication network. In this feature article, we first summarize the whereabouts underlying the design of highly luminescent NIR molecular edifices and materials. We then focus on describing the main trends in three applications related to this spectral range: telecommunications, biosciences, and solar energy conversion. In telecommunications, efforts concentrate presently on getting easily processable polymer-based waveguide amplifiers. Upconversion nanophosphors emitting in the visible after NIR excitation are now ubiquitous in many bioanalyses while their application to bio-imaging is still in its early stages; however, highly sensitive NIR-NIR systems start to be at hand for both in vitro and in vivo imaging, as well as dual probes combining magnetic resonance and optical imaging. Finally, both silicon-based and dye-sensitized solar cells benefit from the downconversion and upconversion capabilities of lanthanide ions to harvest UV and NIR solar light and to boost the overall quantum efficiency of these next-generation devices.  相似文献   

6.
通过对天铁集团高炉现状、风机现状的分析,提出了对热力厂风机升级改造的规划,确定了实施方案.该方案实施后将彻底改变风机渐进式改造的现象,使新高炉的备用机组发挥更大的作用,可增加现有高炉的风压、风量,使现有高炉的产量、冶炼强度进一步提高.  相似文献   

7.
Batch adsorption experiments were conducted for the adsorption of Eu(Ⅲ) ions from aqueous solution by D113 resin. The results indicated that D113 resin could adsorb Eu(Ⅲ) ion effectively from aqueous solution. The adsorption was strongly dependent on pH of the medium with enhanced adsorption as the pH turned from 3.50 to 7.00 and the optimal adsorption condition was in HAc-NaAc medium with pH value of 6.50. The maximum uptake capacity of Eu(Ⅲ) ions was 290.9 mg/g D113 at 298 K, at an initial pH value of 6.50. The overall adsorption process was best described by Lagergren-first-order kinetics. When Freundlich and Langmuir isotherms were tested, the latter had a better fit with the experimental data. The thermodynamic parameters such as free energy (G) which were all negative, indicated that the adsorption of Eu(Ⅲ) ions onto D113 resin was spontaneous and the positive value of enthalpy (H) showed that the adsorption was endothermic in nature. Thomas model was applied to experimental column data to determine the characteristic parameters of column useful for process design. Furthermore, Eu(Ⅲ) could be eluted by using 3.0 mol/L HCl solution and the D113 resin could be regenerated and reused.  相似文献   

8.
Green-emitting Sr2LiSiO4F:Eu2+ and blue-emitting Sr2MgSi2O7:Eu2+ phosphors were synthesized by the conventional high temperature solid-state route,respectively.Their structures and photoluminescenee properties were comparatively investigated.It was found that the mixture phases of Sr2MgSi2O7 and SrF2 were obtained when a part of Sr2+ in Sr2LiSiO4F was replaced by some amount of Mg2+ in order to design the possible SrMgLiSiO4F:Eu2+ phosphor.Based on the photoluminescence analysis,Sr2LiSiO4F:Eu2+ phosphor exhibited a green broad emission band of main peak at 513 nm under the excitation of 365 nm,while the Sr2MgSi2O7:Eu2+ and SrMgLiSiO4F:Eu2+ phosphor showed blue emission centered at 467 nm.The temperature dependent photoluminescence properties and room temperature decay time for the three kinds of phosphors were also discussed in this paper.  相似文献   

9.
Er3+-substituted W-type barium ferrites Ba1-xErx(Zn0.3Co0.7)2Fe16O27(x=0.00,0.05,0.10,0.15,0.20)were synthesized by polymer adsorbent combustion method.Samples were characterized by X-ray diffraction analysis(XRD),X-ray fluorescence(XRF),scanning electron microscopy(SEM)and network analyzer to investigate the relationships among Er3+concentration,crystal structure,surface mcrphology and electromagnetic properties.All the XRD patterns showed pure phase of W-type barium ferrite when x≤0.15,while the impurity phase of ErFeO3 appeared when x=0.20.The pure W-type barium ferrite showed a hexagonal flake shape.In addition,the microwave electromagnetic properties of samples were analyzed in the frequency range of 2-18 GHz.It was indicated that the electromagnetic properties were significantly improved when Er3+doping content was 0.10.The reasons were also discussed using electromagnetic theory.The optimized ferrite exhibited excellent microwave absoption performance.The maximum of reflection loss(RL)reached about-27.4 dB and RL was below-10dB at the frequency range from 8.4 GHz to 18 GHz,when the thickness was 2.6 mm.  相似文献   

10.
Rare earth dements have unique physical, magnetic, luminescent and catalytic properties. They have been successfully used as medicine and probes in luminescent resonance energy transfer (LRET) for bioassays, as well as reagents for diagnosis in magnetic resonance imaging (MRI). In this progress report, we will focus on recent progress on how rare earth amino complexes bind to DNA and change DNA structure, especially on DNA B-Z transition induced by rare earth amino acid complex and its potential impact on Alzheimer's disease (AD).  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号