有机衬底SnO2∶Sb透明导电膜的研究

采用射频磁控溅射法在有机薄膜衬底上制备出SnO2∶Sb透明导电膜,并对薄膜的结构和光电特性以及制备参数对薄膜性能的影响进行了研究.制备的样品为多晶薄膜,并且保持了纯二氧化锡的金红石结构.SnO2∶Sb薄膜中Sb2O3的最佳掺杂比例为6%.适当调节制备参数,可以获得在可见光范围内平均透过率大于85%的有机衬底SnO2∶Sb透明导电薄膜,其电阻率～3.7×10-3Ω·cm,载流子浓度～1.55×1020cm-3,霍耳迁移率～13cm2·V-1·s-1.     

ZnO薄膜的射频磁控溅射制备及性能研究

采用射频磁控溅射法在玻璃衬底上制备出高质量的ZnO薄膜.对薄膜的结构和性能进行了研究.所制备的ZnO是具有六角纤锌矿结构的多晶薄膜,最佳择优取向为(002)方向.ZnO薄膜的霍尔迁移率和载流子浓度分别为8×104m2/(V·s)和11.3×1020 cm-3.     

透明导电薄膜ZnO∶Zr的制备及特性研究

利用直流磁控溅射法在玻璃衬底上制备出了可见光透过率高、电阻率低的ZnO∶Zr(ZZO)透明导电薄膜.讨论了溅射功率对ZZO薄膜结构、形貌及光电性能的影响.研究结果表明,溅射功率对ZZO薄膜的结构和电学性能有很大影响.实验制备的ZZO薄膜为六角纤锌矿结构的多晶薄膜,且具有垂直于衬底方向的c轴择优取向.在溅射功率为115 W时,ZZO薄膜的电阻率具有最小值1.9×10-3 Ω*cm,其霍尔迁移率和载流子浓度分别为18.7 cm2*V-1*s-1和2.07×1020 cm-3.所制备ZZO薄膜样品具有良好的附着性能,其可见光区平均透过率均超过92%.     

ZnO-SnO2透明导电膜的低温制备及性质

在室温下,采用射频磁控溅射法在7059玻璃衬底上制备出ZnO-SnO2透明导电薄膜.制备的薄膜为非晶结构,并且薄膜的电阻率强烈地依赖于溅射气体中的氧分压.薄膜的最小电阻率为7.27×10-3Ω*cm,载流子浓度为4.3×1019cm-3、霍尔迁移率为20.5cm2/(V*s),在可见光范围内的平均透过率达到了90%.     

有机衬底SnO_2∶Sb透明导电膜的研究

采用射频磁控溅射法在有机薄膜衬底上制备出 Sn O2 ∶ Sb透明导电膜 ,并对薄膜的结构和光电特性以及制备参数对薄膜性能的影响进行了研究 .制备的样品为多晶薄膜 ,并且保持了纯二氧化锡的金红石结构 .Sn O2 ∶ Sb薄膜中 Sb2 O3的最佳掺杂比例为 6 % .适当调节制备参数 ,可以获得在可见光范围内平均透过率大于 85 %的有机衬底 Sn O2 ∶ Sb透明导电薄膜 ,其电阻率～ 3.7e- 3Ω· cm ,载流子浓度～ 1.5 5e2 0 cm- 3,霍耳迁移率～ 13cm2 /( V · s )     

有机衬底SnO2：Sb透明导电膜的研究

采用射频磁控溅射法在有机薄膜衬底上制备出SnO2∶Sb透明导电膜,并对薄膜的结构和光电特性以及制备参数对薄膜性能的影响进行了研究.制备的样品为多晶薄膜,并且保持了纯二氧化锡的金红石结构.SnO2∶Sb薄膜中Sb2O3的最佳掺杂比例为6%.适当调节制备参数,可以获得在可见光范围内平均透过率大于85%的有机衬底SnO2∶Sb透明导电薄膜,其电阻率～3.7×10-3Ω·cm,载流子浓度～1.55×1020cm-3,霍耳迁移率～13cm2·V-1·s-1.     

聚合物薄膜晶体管的制备及性能

以硅材料衬底作栅电极,在衬底上依次制备二氧化硅栅介质层、聚合物MEH-PPV薄膜半导体层和金源、漏电极,成功地得到了聚合物薄膜晶体管.器件的制备和测试都是在空气环境中完成.该薄膜晶体管呈现出较好的场效应晶体管饱和特性,器件的载流子迁移率为5.0×10-5 cm2/(V·s),开关电流比大于2×103.通过在氮气氛下对聚合物薄膜进行退火处理以及聚合物薄膜沉膜前对二氧化硅表面修饰可以适当地提高器件的载流子迁移率.     

在柔性衬底上制备透明导电薄膜ZnO:Zr(英文)

采用射频磁控溅射法在室温柔性衬底PET上制备了掺锆氧化锌(ZZO)透明导电薄膜.利用不同方法提高了ZZO薄膜的电阻率而未使其可见光透过率降低.X射线衍射(XRD)和扫描电子显微镜(SEM)表明,ZZO薄膜为六角纤锌矿结构的多晶薄膜.在有机衬底和玻璃衬底上制备ZZO薄膜的择优取向不同,前者为(100)晶面,而后者为(002)晶面.在有ZnO缓冲层的PET衬底上制备的ZZO薄膜电阻率比直接生长在玻璃衬底样品上的小.通过优化参数,在PET衬底上制备出了最小电阻率为1.7×10-3Ω·cm、可见光透过率超过93%的ZZO薄膜.实验表明,镀膜之前在柔性衬底上沉积ZnO缓冲层能有效地提高ZZO薄膜的质量.     

用PLD方法制备Li掺杂的p型ZnMgO

在玻璃衬底上用PLD方法成功制备出具有高度(0002)取向性的、晶体质量较好的Li掺杂为0.4%的p型 Zn0.8Mg0.2O薄膜.衬底温度对薄膜的电学性能及结晶质量有重要影响,实验表明:在500℃时薄膜的电学性能最好,其载流子浓度为5.1×1018cm-3,电阻率为6.58Ω·cm,霍尔迁移率为0.189cm2/(V·s),且制备出的薄膜在可见光区具有90%的高透射率及在室温下光学禁带宽度3.625eV.     

用PLD方法制备Li掺杂的p型ZnMgO

在玻璃衬底上用PLD方法成功制备出具有高度(0002)取向性的、晶体质量较好的Li掺杂为0.4%的p型 Zn0.8Mg0.2O薄膜.衬底温度对薄膜的电学性能及结晶质量有重要影响,实验表明:在500℃时薄膜的电学性能最好,其载流子浓度为5.1×1018cm-3,电阻率为6.58Ω·cm,霍尔迁移率为0.189cm2/(V·s),且制备出的薄膜在可见光区具有90%的高透射率及在室温下光学禁带宽度3.625eV.     

Cost-effective test solutions for smart card and other integrated flash applications

From its emergence in the late 1980s as a lower cost alternative to early EEPROM technologies, flash memory has evolved to higher densities and speedsand rapidly growing acceptance in mobile applications.In the process, flash memory devices have placed increased test requirements on manufacturers. Today, as flash device test grows in importance in China, manufacturers face growing pressure for reduced cost-oftest, increased throughput and greater return on investment for test equipment. At the same time, the move to integrated flash packages for contactless smart card applications adds a significant further challenge to manufacturers seeking rapid, low-cost test.     

Theoretical analysis of the relationship between the Brillouin gain coefficient and the strain in the optical-fiber sensors

The relation between the power of the Brillouin signal and the strain is one of the bases of the distributed fiber sensors of temperature and strain. The coefficient of the Bfillouin gain can be changed by the temperature and the strain that will affect the power of the Brillouin scattering. The relation between the change of the Brillouin gain coefficient and the strain is thought to be linear by many researchers. However, it is not always linear based on the theoretical analysis and numerical simulation. Therefore, errors will be caused if the relation between the change of the Brillouin gain coefficient and the strain is regarded as to be linear approximately for measuring the temperature and the strain. For this reason, the influence of the parameters on the Brillouin gain coefficient is proposed through theoretical analysis and numerical simulation.     

Novel fiber-optical interferometer with miniaturized probe for in-hole measurements

Today, micro-system technology and the development of new MEMS （Micro-Electro-Mechanical Systems） are emerging rapidly. In order for this development to become a success in the long run, measurement systems have to ensure product quality. Most often, MEMS have to be tested by means of functionality or destructive tests. One reason for this is that there are no suitable systems or sensing probes available which can be used for the measurement of quasi inaccessible features like small holes or cavities. We present a measurement system that could be used for these kinds of measurements. The system combines a fiber optical, miniaturized sensing probe with low-coherence interferometry, so that absolute distance measurements with nanometer accuracy are possible.     

An Improved parallel thinning algorithm with two subiterations

The parallel thinning algorithm with two subiterations is improved in this paper. By analyzing the notions of connected components and passes, a conclusion is drawn that the number of passes and the number of eight-connected components are equal. Then the expression of the number of eight-connected components is obtained which replaces the old one in the algorithm. And a reserving condition is proposed by experiments, which alleviates the excess deletion where a diagonal line and a beeline intersect. The experimental results demonstrate that the thinned curve is almost located in the middle of the original curve connectivelv with single pixel width and the processing speed is high.     

Teleportation of an arbitrary unknown N-qubit entangled state under the controlling of M controllers

A new quantum protocol to teleport an arbitrary unknown N-qubit entangled state from a sender to a fixed receiver under M controllers(M < N) is proposed. The quantum resources required are M non-maximally entangled Greenberger-Home-Zeilinger (GHZ) state and N-M non-maximally entangled Einstein-Podolsky-Rosen (EPR) pairs. The sender performs N generalized Bell-state measurements on the 2N particles. Controllers take M single-particle measurement along x-axis, and the receiver needs to introduce one auxiliary two-level particle to extract quantum information probabilistically with the fidelity unit if controllers cooperate with it.     

Diode-end-pumped Nd:YVO4/LBO lasers with 4.2W continuous-wave output at 457 nm

A continuous-wave (CW) 457 nm blue laser operating at the power of 4.2 W is demonstrated by using a fiber coupled laser diode module pumped Nd: YVO4 and using LBO as the intra-cavity SHG crystal With the optimization of laser cavity and crystal parameters, the laser operates at a very high efficiency. When the pumping power is about 31 W, the output at 457nm reaches 4.2 W, and the optical to optical conversion efficiency is about 13.5% accordingly. The stability of the out putpower is better than 1.2% for 8 h continuously working.     

JOURNAL OF ELECTRONICS(CHINA)

正~~     

Call for Papers

正Introduction Jointly sponsored by the China Institute of Communications(CIC)and the IEEE Communications Society(IEEE ComSoc)since the year 2013,China Communications,currently,is aiming to gradually realise the transition from journal to magazine content and style.We are now looking for innovative technical papers pertinent to Information and Communications Technologies(ICTs)worldwide.Theoretical research papers     

Call for Papers

正Wireless Body-area Networks The last decade has witnessed the convergence of three giant worlds:electronics,computer science and telecommunications.The next decade should follow this convergence in most of our activities with the generalization of sensor networks.In particular with the progress in medicine,people live longer and the aging of population will push the development of wireless personal networks     

Call for Papers—Feature Topic,Vol.12,No.7,2015

正Information Centric Networking Information-Centric Networking(ICN) is an emerging direction in Future Internet architecture research,gaining significant tractions among academia and industry.Aiming to replace the conventional host-to-host communication model by a data-centric model,ICN treats data content as the first