首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到20条相似文献,搜索用时 46 毫秒
1.
基于InP HEMT在3 mm波段的优越的噪声性能,设计制作了一款3 mm波段InP HEMT低噪声放大器。通过合理设计外延材料结构和器件结构,提高器件性能。测试1~40 GHz器件的S参数和噪声参数以及75~110 GHz器件的S参数,并采用外推的方法建立了器件的噪声模型。电路设计采用ADS仿真软件,采用全版图电磁场仿真保证电路设计的准确性,最终实现了一款3 mm波段低噪声放大器。测试结果显示在92~96 GHz时,带内增益大于20 dB,噪声系数小于4.0 dB。芯片面积3.07 mm×1.75 mm,直流功耗60 mW。  相似文献   

2.
用MBE设备在半绝缘的InP衬底上依次生长高电子迁移率晶体管(HEMT)外延材料和共振遂穿二极管(RTD)外延材料,在此材料结构基础上研究和分析了RTD与HEMT器件单片集成工艺中的隔离工艺、欧姆接触工艺、HEMT栅挖槽工艺和空气桥工艺等几步关键工艺,给出了这些工艺的相关参数。利用上述工艺成功地制作了RTD和HEMT器件,并在室温下分别测试了RTD器件和HEMT器件的电学特性。测试表明:在室温下,RTD器件的峰电流密度与谷电流密度之比(PVCR)为3.66;HEMT器件的最大跨导约为370 mS/mm,在Vds=1.5 V时的饱和电流约为391 mA/mm。这将为RTD与HEMT的单片集成研究奠定工艺基础。  相似文献   

3.
设计了Ka波段GaN功率高电子迁移率晶体管(HEMT)外延材料及器件结构,采用AlN插入层提高了二维电子气(2DEG)浓度.采用场板结构提高了器件击穿电压.采用T型栅工艺实现了细栅制作,提高了器件高频输出功率增益.采用钝化工艺抑制了电流崩塌,提高了输出功率.采用通孔工艺减小源极寄生电阻,通过优化钝化层厚度减小了寄生电容,提高了器件增益.基于国产SiC外延材料及0.15 μm GaN HEMT工艺进行了器件流片,最终研制成功Ka波段GaN HEMT功率器件.对栅宽300 μm器件在29 GHz下进行了微波测试,工作栅源电压为-2.2V,源漏电压为20 V,输入功率为21 dBm时,器件输出功率为30 dBm,功率增益为9 dB,功率附加效率约为43%,功率密度达到3.3 W/mm.  相似文献   

4.
文章报道了90nm栅长的晶格匹配InP基HEMT器件。栅图形是通过80kV的电子束直写的,并采用了优化的三层胶工艺。器件做在匹配的InAlAs/InGaAs/InP HEMT材料上。当Vds=1.0V时,两指75μm栅宽器件的本征峰值跨导达到720ms/mm,最大电流密度为500mA/mm,器件的阂值电压为.0.8V,截止频率达到127GHz,最大振荡频率达到152GHz。  相似文献   

5.
通过合理的外延层材料结构设计和改进的器件制备工艺,制备出功率增益截止频率(fmax)为183GHz的晶格匹配InP基In0.53Ga0.47As-In0.52Al0.48As HEMT。该fmax为国内HEMT器件最高值,还报道了器件的结构、制备工艺以及器件的直流和高频特性。  相似文献   

6.
报道了基于50 nm栅工艺的AlN/GaN异质结的G波段器件结果。在AlN/GaN HEMT外延结构上,采用电子束直写工艺制备了栅长50 nm的"T"型栅结构。器件直流测试最大漏电流为2.1 A/mm,最大跨导为700 mS/mm;小信号测试外推其电流增益截止频率和最大振荡频率分别为180 GHz及350 GHz。采用该工艺制备的共面波导(CPW)结构的放大器工作电压6 V,在162 GHz小信号增益大于10 dB。166 GHz连续波峰值输出功率11.36 dBm,功率密度达到684 mW/mm,功率密度水平达到GaN器件在G频段的高水平。  相似文献   

7.
通过合理的外延层材料结构设计和改进的器件制备工艺,制备出功率增益截止频率(fmax)为183GHz的晶格匹配InP基In0.53Ga0.47As-In0.52Al0.48As HEMT.该fmax为国内HEMT器件最高值.还报道了器件的结构、制备工艺以及器件的直流和高频特性.  相似文献   

8.
提出了一种新的PMMA/PMGI/PMMA三层胶复合结构,通过一次对准和电子束曝光、多次显影在InP PHEMT材料上制作出高成品率的T型纳米栅.在曝光显影条件变化20%的情况下,InP HEMT成品率达到80%以上;跨导变化范围在590~610mS/mm,夹断电压为-1.0~-1.2V,器件的栅长分布均匀.这种新的结构工艺步骤少,工艺宽容度大,重复性好,大大提高了纳米栅器件的成品率.  相似文献   

9.
<正>日本《电子材料》1991年11月报道了低噪声HEMT和功率HEMT器件的性能和现状。低噪声HEMT的工作频率由V频段提高到w频段。工作于w频段的器件几乎都是p—HEMT和晶格匹配型HEMT。它们的NF和Ca最佳值分别为:在18GHz下,0.3dB和17.2dB;在60GHz  相似文献   

10.
采用减小栅长(Lg)的方法可以显著提高磷化铟基高电子迁移率晶体管(InP HEMT)器件的直流和微波性能,并使器件的工作频率上升到太赫兹频段。采用T形栅工艺制备了70 nm栅长的InP HEMT器件,器件的直流跨导达到了2.87 S/mm,截止频率ft和最大振荡频率fmax分别为230 GHz和310 GHz。对器件的寄生参数进行了提取和去嵌入,得到了器件的本征S参数。采用经典的9参数模型拓扑结构对器件进行了小信号建模,模型仿真与测试结果拟合良好。针对电流的短沟道效应,采用电流分段的方法来拟合I-V曲线,取得了较好的拟合结果。最后采用Angelov模型对器件的电容进行建模,并最终建立了器件的大信号模型。  相似文献   

11.
DUV lithography, using the 248 nm wavelength, is a viable manufacturing option for devices with features at 130 nm and less. Given the low kl value of the lithography, integrated process development is a necessary method for achieving acceptable process latitude. The application of assist features for rule based OPC requires the simultaneous optimization of the mask, illumination optics and the resist.Described in this paper are the details involved in optimizing each of these aspects for line and space imaging.A reference pitch is first chosen to determine how the optics will be set. The ideal sigma setting is determined by a simple geometrically derived expression. The inner and outer machine settings are determined, in turn,with the simulation of a figure of merit. The maximum value of the response surface of this FOM occurs at the optimal sigma settings. Experimental confirmation of this is shown in the paper.Assist features are used to modify the aerial image of the more isolated images on the mask. The effect that the diffraction of the scattering bars (SBs) has on the image intensity distribution is explained. Rules for determining the size and placement of SBs are also given.Resist is optimized for use with off-axis illumination and assist features. A general explanation of the material' s effect is discussed along with the affect on the through-pitch bias. The paper culminates with the showing of the lithographic results from the fully optimized system.  相似文献   

12.
This paper presents a new method to increase the waveguide coupling efficiency in hybrid silicon lasers. We find that the propagation constant of the InGaAsP emitting layer can be equal to that of the Si resonant layer through improving the design size of the InP waveguide. The coupling power achieves 42% of the total power in the hybrid lasers when the thickness of the bonding layer is 100 nm. Our result is very close to 50% of the total power reported by Intel when the thickness of the thin bonding layer is less than 5 nm. Therefore, our invariable coupling power technique is simpler than Intel's.  相似文献   

13.
The relation between the power of the Brillouin signal and the strain is one of the bases of the distributed fiber sensors of temperature and strain. The coefficient of the Bfillouin gain can be changed by the temperature and the strain that will affect the power of the Brillouin scattering. The relation between the change of the Brillouin gain coefficient and the strain is thought to be linear by many researchers. However, it is not always linear based on the theoretical analysis and numerical simulation. Therefore, errors will be caused if the relation between the change of the Brillouin gain coefficient and the strain is regarded as to be linear approximately for measuring the temperature and the strain. For this reason, the influence of the parameters on the Brillouin gain coefficient is proposed through theoretical analysis and numerical simulation.  相似文献   

14.
Today, micro-system technology and the development of new MEMS (Micro-Electro-Mechanical Systems) are emerging rapidly. In order for this development to become a success in the long run, measurement systems have to ensure product quality. Most often, MEMS have to be tested by means of functionality or destructive tests. One reason for this is that there are no suitable systems or sensing probes available which can be used for the measurement of quasi inaccessible features like small holes or cavities. We present a measurement system that could be used for these kinds of measurements. The system combines a fiber optical, miniaturized sensing probe with low-coherence interferometry, so that absolute distance measurements with nanometer accuracy are possible.  相似文献   

15.
The parallel thinning algorithm with two subiterations is improved in this paper. By analyzing the notions of connected components and passes, a conclusion is drawn that the number of passes and the number of eight-connected components are equal. Then the expression of the number of eight-connected components is obtained which replaces the old one in the algorithm. And a reserving condition is proposed by experiments, which alleviates the excess deletion where a diagonal line and a beeline intersect. The experimental results demonstrate that the thinned curve is almost located in the middle of the original curve connectivelv with single pixel width and the processing speed is high.  相似文献   

16.
From its emergence in the late 1980s as a lower cost alternative to early EEPROM technologies, flash memory has evolved to higher densities and speedsand rapidly growing acceptance in mobile applications.In the process, flash memory devices have placed increased test requirements on manufacturers. Today, as flash device test grows in importance in China, manufacturers face growing pressure for reduced cost-oftest, increased throughput and greater return on investment for test equipment. At the same time, the move to integrated flash packages for contactless smart card applications adds a significant further challenge to manufacturers seeking rapid, low-cost test.  相似文献   

17.
It is well known that adding more antennas at the transmitter or at the receiver may offer larger channel capacity in the multiple-input multiple-output(MIMO) communication systems. In this letter, a simple proof is presented for the fact that the channel capacity increases with an increase in the number of receiving antennas. The proof is based on the famous capacity formula of Foschini and Gans with matrix theory.  相似文献   

18.
The effect of laser microbeam trapping the bioparticles has been appfied widely in the biology .However the micromechanism of the acting that realizes the laser-microbeam trapping bioparticles is still lacking. In this paper ,the act microchenism of the gradiant force of laser microbeam for the bioparticles is analysed by means of quantum theory ,The result accords with our experiment.  相似文献   

19.
Using multiple importance sampling (MIS) technique, the optical communication system performance affected by polarization-mode dispersion (PMD) and polarization-dependent loss (PDL) is simulated numerically. The power penalties and system outage probabilities are obtained for optical communication systems with on-off keying (OOK) or differential phase shift keying (DPSK) modulation. The simulation results show that DPSK always performs better than OOK. When the system has moderate PDL (about 1.5 dB), it is necessary to compensate effectively the fiber PMD in order to enhance the system tolerance to the PMD and PDL. However, the efficiency of PMD compensation will degrade rapidly when the PMD of the whole optical link drops into the low value.  相似文献   

20.
A shape measurement based on ESPI by using carrier is presented. When the tested object is tilted with a small angle, the carrier pattern containing altitude information is formed on the object surface. By using the carrier pattern captured by a CCD camera, the phase of the object can be derived by Fourier transform and the shape measurement is realized. The principle of the method is introduced and proved by an experiment.  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号