共查询到20条相似文献,搜索用时 125 毫秒
1.
2.
伴随着便携式电子产品的快速更迭和新能源动力汽车行业的迅猛发展,大量的锂离子电池迎来报废退役,其回收迫在眉睫。焙烧—水浸联合工艺不仅改进了传统火法熔炼工艺存在的高能耗、锂难以有效分离等问题,又解决了湿法回收工艺过程试剂耗量大、废水处理等缺点,将是失效锂离子电池正极材料有效处理回收工艺发展的未来趋势及前进方向。综述了当前联合工艺处理失效锂离子电池正极材料的研究进展,主要分为还原焙烧、盐化焙烧两大类,盐化焙烧工艺极大降低了所需焙烧温度,根据添加剂的不同可细分为硫酸化焙烧、氯化焙烧、硝化焙烧。通过对比分析不同联合工艺的优势和不足,总结展望联合工艺未来的发展趋势及前景,为未来研发更加清洁高效的回收工艺提供参考。 相似文献
3.
采用湿法回收技术从废旧锌锰干电池中回收锰,并以此为锰源制备锂离子电池正极材料锰酸锂。用XRD、SEM对产物的结构和微观形貌进行表征,并对其电化学性能进行测试。结果表明,该工艺合成的产物为尖晶石型LiMn2O4,纯度高,粒径分布均匀,初始比容量可达119mAh/g,适合用作锂离子电池正极材料。 相似文献
4.
随着三元锂离子电池市场份额的快速增长,退役三元锂离子电池出现了爆发式增长,因此,回收三元锂离子电池电极材料成了电池行业新的关注热点。三元锂离子电池中的钴(Co)、锂(Li)、镍(Ni)和锰(Mn)都是较高价值的金属,因此,对退役后的三元锂电池进行回收再利用,不仅可以产生一定的经济效益,而且对于生态环境的保护都会有着巨大的效益。 相似文献
5.
6.
随着锂离子电池在电动汽车和储能领域的大量使用,废旧锂离子电池所面临的环境和资源问题日益突出。为了更好地资源利用和环境保护,世界各国对废旧锂离子电池中有价金属的回收和利用,及无危害处理相当重视。文中综述了国内外对废旧锂离子电池回收技术的研究现状,比较了不同回收途径的优缺点,讨论了回收技术的发展方向。本文中归纳的废旧锂离子电池回收方法,在目前回收领域中得到了广泛地研究,并且起到了显著效果,但是大多集中在对锂、钴、镍、锰、铜、铝等有价金属的回收利用上,对废旧锂离子电池中的导电碳、石墨以及电解质的回收和处理方面的研究较少,对工艺过程中产生的污染和安全性问题也缺乏系统的研究。另外,随着锂离子电池生产技术的发展,新的电极材料将会出现并取代过渡金属氧化物,比如单质硫、导电聚合物等;同时也需要相应的电解液与之匹配,如新型的有机电解液、聚合物电解质等,这将向废旧锂离子电池回收技术提出了新的要求。今后废旧锂离子电池资源化回收技术的研究方向是降低成本,减少污染和实现回收物质的多元化以及提高回收率。 相似文献
7.
8.
还原熔炼失效锂离子电池的研究 总被引:4,自引:0,他引:4
根据从失效锂离子电池中再生有价金属的现状,提出用还原熔炼的方法回收锂离子电池中的钴和铜,并从热力学原理分析其可行性,进行实验验证,证明了用碳作还原剂此工艺是可行的。电池中的铝也能作为还原剂来还原钴氧化物。用电弧炉还原熔炼后,钴回收率78.63%,铜回收率81.54%。 相似文献
9.
10.
据中国海关统计数据和中国电池工业协会提供数据显示,2004年我国电池出口数量与金额均比2003年有较大幅度的增长,传统的锌锰干电池其出口数量和金额增幅不大,分别为5.27%和9.31%,而诸如像铅酸蓄电池、镍镉、镍氢蓄电池,其增幅在25~30%左右,锂离子电池更是与2003年相比,增长近80%,即一次电池中传统出口的锌锰干电池维持在稳中有升,而二次电池中的传统电池如铅酸、镍镉、镍氢等电池增幅大升,而锂离子电池更是一枝独秀,名列各类出口电池榜首。我国电池出口正在发生可喜的变化,除传统的锌锰干电池外,其它技术含量高、附加值高的电池出口也正在大… 相似文献
11.
12.
Mahmoud A. Rabah Sabah M. Abelbasir 《Transactions of the Indian Institute of Metals》2018,71(12):3095-3101
Lead–calcium alloy containing up to 0.10% calcium was recovered from spent rechargeable sealed acid–lead batteries. Two techniques were investigated to explore the effect of flux salts on the extent and quality of the recovered alloy: pyrometallurgical and electrochemical methods. About 10 kg of the spent batteries were collected for testing. The sample was washed with hot water and dried. The plastic cases of the batteries were mechanically cut, the contents were dismantled manually, and the plastic containers were shredded for recycling. The electrode plates were freed from the loose powder and placed in SiC crucible and covered with alkali chloride salts. The loaded crucible was heated in an electronically controlled chamber furnace-type NaberthermC3 at temperatures up to 800 °C. The obtained metals were analyzed. The effect of temperature, rate of heating, atmospheric conditions, composition of the flux salts on the extent and quality of the recovered lead–calcium alloy were studied. Results revealed that the spent rechargeable batteries contain three groups of three plates of Pb–Ca grids, each packed with lead oxides. Direct heating of these plates in a silicon carbide crucible under ambient conditions produces lead metal poor in calcium content (0.07%) due to partial oxidation of the alloying calcium element. Rate of temperature increase has a considerable effect on the yield of the lead alloy composition. Thermodynamically, the activation energy of the alloying process amounts to 5366 kJ/mol. Flux sodium salts benefit the recovery process. Sodium salts are more powerful as compared to potassium salts. Lead calcium alloy meeting the standard specification has been successfully recovered from the spent rechargeable acid–lead batteries with a very competitive cost to that of the same alloy prepared from primary resources. 相似文献
13.
14.
《Baosteel Technical Research》2020,(2)
In this paper,a water-based binder was used in LiFePO_4 Li-ion batteries and the factors affecting the battery performance were analyzed. The type and amount of conductive agent and the amount of binder were found to have a significant impact on the rate performance of LiFePO_4 Li-ion batteries. The impact of the two types of binders used in the test was not obvious. 相似文献
15.
16.
17.
18.
随着新能源汽车产业的发展,汽车动力电池产量快速增长,动力电池报废量也逐年增加。为实现废旧动力电池中有价元素的循环利用,降低废弃物对环境的污染,缓解锂、钴资源供需不平衡矛盾,废旧动力电池资源化迫在眉睫。三元正极材料是废旧动力电池中最具有回收价值的成分,综述了废旧三元动力电池正极材料的湿法提取技术、火法—湿法联合提取技术以及其他提取技术的进展,分析比较了各种技术的优势与不足,并对废旧三元动力电池正极材料中有价元素提取技术未来的发展方向进行展望。 相似文献
19.
20.
近年来,我国新能源汽车及储能领域快速发展,磷酸铁锂电池使用量井喷式上升。在未来会产生大量退役磷酸铁锂电池,对其进行回收不仅可以缓解国内锂资源紧缺的问题也能减少含氟电解液带来的环境污染。回顾了近年来国内外退役磷酸铁锂电池回收技术,包括电池预处理、磷酸铁锂正极废料修复、全浸出回收、选择性提锂及提锂尾渣的回收等,总结归纳了各技术最新的研究成果,从工艺的经济性、回收率、环境影响等方面,对各个工艺的优缺点进行分析,并展望了未来退役磷酸铁锂电池回收技术的发展方向。 相似文献