乙烯酮(双乙烯酮)下游产品废水的治理技术

乙烯酮(双乙烯酮)是十分重要的化工中间体,其下游产品较多。江苏某化工厂开发生产乙烯酮(双乙烯酮)下游产品三十多个,年生产规模三万多吨,是国内以乙烯酮(双乙烯酮)为中间体生产精细化学品的综合骨干企业。针对乙烯酮(双乙烯酮)下游产品废水特点,该厂结合企业实际,开展了产品优化,结构调整,清洁生产,资源循环利用,节水降耗等工作,从源头削减了污染物的生产。同时投资二千多万元新建预处理装置三套,6000m3/d废水生化处理装置一套,使全厂乙烯酮(双乙烯酮)下游产品的废水得到了有效的治理。     

我国聚碳酸酯工业发展概况

介绍我国聚碳酸酯生产能力和消费需求,对聚碳酸酯在信息工业中的应用作了简短介绍     

Effect of degree of deacetylation of chitosan on the kinetics of ultrasonic degradation of chitosan

The objective of the study was to explore the effect of the degree of deacetylation (DD) of the chitosan used on the degradation rate and rate constant during ultrasonic degradation. Chitin was extracted from red shrimp process waste. Four different DD chitosans were prepared from chitin by alkali deacetylation. Those chitosans were degraded by ultrasonic radiation to different molecular weights. Changes of the molecular weight were determined by light scattering, and data of molecular weight changes were used to calculate the degradation rate and rate constant. The results were as follows: The molecular weight of chitosans decreased with an increasing ultrasonication time. The curves of the molecular weight versus the ultrasonication time were broken at 1‐h treatment. The degradation rate and rate constant of sonolysis decreased with an increasing ultrasonication time. This may be because the chances of being attacked by the cavitation energy increased with an increasing molecular weight species and may be because smaller molecular weight species have shorter relaxation times and, thus, can alleviate the sonication stress easier. However, the degradation rate and rate constant of sonolysis increased with an increasing DD of the chitosan used. This may be because the flexibilitier molecules of higher DD chitosans are more susceptible to the shear force of elongation flow generated by the cavitation field or due to the bond energy difference of acetamido and β‐1,4‐glucoside linkage or hydrogen bonds. Breakage of the β‐1,4‐glucoside linkage will result in lower molecular weight and an increasing reaction rate and rate constant. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 3526–3531, 2003     

Semi-empirical equation of state of metals. Equation of state of aluminum

A semi-empirical equation of state for metals is described. Its capabilities are demonstrated by the example of the equation of state for aluminum. New experimental data are presented on the location of the isentrope of aluminum for unloading from the state at p = 229.71 GPa on the shock adiabat to an aerogel (SiO₂) of density 0.08 g/cm³. __________ Translated from Fizika Goreniya i Vzryva, Vol. 44, No. 2, pp. 61–75, March–April, 2008.     

几种乙炔加压设备性能的比较

阐述并比较了几种加压设备在乙炔加压清净过程中的性能和特点。     

水泥水化热测定方法综述

水泥水化热是中、低热水泥和核电工程用水泥的一项关键的技术指标。全球范围内测定水泥水化热的方法有溶解法、直接法/半绝热法、等温传导量热法三种。本文总结了中、美、欧相关方法标准,对其测试原理、仪器设备、试验过程等方面进行了比对,并对其在领域的应用做了简单的概括。     

Calorimetric and Computational Study of Enthalpy of Formation of Diperoxide of Cyclohexanone

A thermochemical rather simple experimental technique is applied to determine the enthalpy of formation of Diperoxide of ciclohexanone. The study is complemented with suitable theoretical calculations at the semiempirical and ab initio levels. A particular satisfactory agreement between both ways is found for the ab initio calculation at the 6–311G basis This set level. Some possible extensions of the present procedure are pointed out.     

船舶柴油机涡轮增压器的清洗

采用喷射清洗剂的方法，清洗涡轮叶片积炭。     

杀虫磺缓释剂杀钉螺试验报告

杀虫磺缓释剂浸杀成螺、幼螺、螺卵效果好，现场应用缓释片６３克／米＾２，半年后活螺平均密度下降９３．２％，春季施药１次，可达到控制当年钉螺的扩散。     

气化给煤系统故障分析

气化给煤装置自投运以来,出现了气化煤仓堵煤、称重给煤机输送皮带因跑偏而损伤以及清扫装置故障频繁等问题,多次造成气化系统减负荷运行。通过对出现的各种问题进行分析,找到了产生这些问题的原因,并有针对性地采用配煤和改进清扫链等措施,使出现的问题得到了极大的改善。     

生物酶法合成氰氟草酯过程监测的RP-HPLC分析方法的研究

为实时监控化学-酶法制备氰氟草酯反应过程,建立了一种该体系中氰氟草酯的RP-HPLC的检测方法。采用SymmetryC18柱（5μm,4.6 mm i.d.×150 mm）,以V（甲醇）∶V（水）=80∶20为流动相,流速为1.0 mL/min,紫外检测波长为282 nm,柱温为30℃,进样量为20μL。氰氟草酯在5.0~1000.0 mg/L范围内线性良好,相关系数达到0.9999,检出限为1.0 mg/L,相对标准偏差为0.58%（n=5）,加标回收率在92.3%~101.5%之间。     

塔设备改造选型的分析

就当前扩产增容中塔设备设计和改造时板式塔和填料塔的选型问题加以分析。在评述目前国内常用的几种塔板和新型填料之后，着重介绍一种新型塔板（导向梯形浮阀塔板）和一种新型填料（波环填料——乾隆帕克）。     

醋酸纤维素取代基分布与性质的关系

分析了以吡啶为溶剂的醋酸纤维素的13C-NMR核磁共振谱,得出了三种不同位置羟基的取代度。结合X—射线和DSC分析,初步说明具有相同取代度但未经水解和经过水解的醋酸纤维素(CA) 性质上的差异是由于三个羟基上的取代度分布不同及消晶程度差异所致。     

孤岛原油乳状液稳定性影响因素研究

通过乳状液稳定性实验考察了孤岛原油乳状液稳定性影响因素。结果表明,低剪切作用下,部分水解聚丙烯酰胺(HPAM)与原油作用1d和54d,所测得其浓相体积分数很快接近零,即HPAM与原油所形成的乳状液稳定性较低。而当溶液中存在50μg/g固体颗粒蒙脱土时,测得其与原油作用1d和54d后的浓相体积分数都约0.08。当溶液中同时含有固体颗粒与HPAM时,测得其与原油作用后所形成的乳状液浓相体积分数很快达到零,固体颗粒与HPAM的协同作用对原油乳状液稳定性有较大影响。另外,随着盐浓度、温度的增加,孤岛原油所形成的乳状液稳定性降低。在30000r/min高速剪切作用下,测得聚合物、固体颗粒模拟水体系与原油间所形成的乳状液浓相体积分数约为0.3,可形成较稳定的乳状液。     

Generalization of vdW type of equations of state

1 INTRODUCTIONBecause of importance of equations of state (EOS)in science and industry,hundreds forms of EOS havebeen presented since latter 19th century.It seems impossible to develop a general equation covering vari-ous kinds of EOS.But for cubic EOS,several generalequations have been reported already. Martin presented the first general equation whichis following p=RT/V-α(T)/(υ β)(υ γ) δ(T)/υ(υ β)(υ γ) (1) Kumar et a1.presented an equation called the most general form of a density-cubic or, alterna tively,volume-cubic mathematical equation,the form of which is as follows     

光度法测定甲醛的研究进展

本文综述了近年来光度法测定甲醛的研究进展,分别从非动力学光度法、动力学光度法进行归纳,并从反应介质、检出限、线性范围和应用等方面进行叙述。     

化学化工数据局外点检测方法研究进展

局外点检测对于注重试验和数据采集的化学化工领域,其重要性不可忽视。结合化学化工的数据特点,对局外点检测方法的理论基础、应用需求、研究思路、技术关键和发展进程进行了综合分析。分别针对线性和非线性参变对象,概要介绍了当前适用的检测方法,包括各类判别标准、直接和间接方式、单个和多个局外点检测、经典和现代方法以及它们的优缺点和最新进展。最后展望了局外点检测方法的前景和发展方向。     

我国聚丙烯工业国际竞争力分析

应用管理学和市场营销学的基本原理和方法,深入分析我国聚丙烯工业的内部和外部环境、市场状况以及加入WTO后所面临的机遇与挑战.在此基础上,应用SWTO(态势分析法),确认出主要的优势和劣势、机会和威胁,对我国聚丙烯工业的国际竞争力进行结构化的综合分析.     

注塑成型收缩率影响因素的分析

在分析注塑成型收缩的基础上,结合注塑制品的生产实际和模具设计要求;讨论了注塑成型中的材料特性、模具结构设计及成型工艺条件等因素对制品的影响及各因素间的相互关系。     

乙烯质量分数对共聚透明PP性能的影响

讨论了乙烯质量分数[ω（C2H4）]对无规共聚透明聚丙烯(PP)性能的影响，并在保证透明度的同时，提出了其加入范围。试验证明，随着ω（C2H4）的增加，无规共聚PP的屈服拉伸强度、热变形温度降低，冲击强度有了明显的提高，雾度有降低趋势。含有较高ω（C2H4）(如大于4％)的PP，具有相对较低的雾度(38％左右)，是透明PP专用树脂的良好基料。添加透明剂A的无规共聚透明PP，ω（C2H4）至少在3％以上，专用树脂的透明度和其他性能良好。