共查询到20条相似文献,搜索用时 140 毫秒
1.
高强度高导电性铜合金在现代电子技术和电工等领域具有广阔的应用前景,因而成为铜合金材料的研究热点之一。综述了获得高强高导电铜合金的研究进展,介绍了发展该类合金的最新技术及其研究现状。 相似文献
2.
高强高导铜合金的研究概述EI 总被引:55,自引:1,他引:54
高强高导铜合金是一类很有应用潜力的功能材料,近年来研究和开发应用高强高导铜基合金取得了显著成效。本文叙述了开发和研究高强高导铜合金的基本原理及制备方法,并对国内外高强高导铜合金的研究和开发应用现状进行了综述,同时,阐述了高强高导铜合金的发展方向及应用前景。 相似文献
3.
4.
高强高铜合金是一类具有发展潜力的功能材料。评述了几种新发展起来的高强高导铜合金的制备技术,并对其存在问题及发展趋势进行了评论。分析指出快速凝固已成为进一步改善合金化法制备高强高导铜合金综合性能的有效手段;机械合金化、定向凝固和塑性变形等复合强化方法代表着今后高强高导铜合金的发展方向,但其工艺较为复杂,生产成本较高,有待进一步研究开发。 相似文献
5.
采用真空熔炼的方法制备了一种新型的高强高导兼顾的铜合金材料Cu-Ag-Zr合金。利用显微硬度测试、金相和透射电镜分析等方法,研究了微量zr对Cu.Ag合金力学性能的影响.结果表明,微量Zr的加入,能显著提高Cu-Ag合金的显微硬度和再结晶温度,使Cu-Ag合金的再结晶软化温度提高200℃以上,Cu-Ag-Zr合金经550℃退火2h后,其显微硬度仍保持为128Hv,能够满足高强高导铜合金高温性能的要求;微量Zr对Cu-Ag合金的强化主要通过使该合金中形成细小、弥散分布的析出相来实现的。 相似文献
6.
7.
8.
9.
10.
11.
12.
为了提高H62黄铜合金的表面性能,通过正交试验获得了最佳锅、钵双稀土处理液配方。利用硝酸点滴、中性盐雾试验评价了H62黄铜合金钝化膜的耐蚀性能,通过电子探针(EPMA)观测了其表面形态结构及元素分布,利用电化学方法表征了 H62黄铜表面钝化膜在3.5%NaCl溶液中的缓蚀行为,采用XRD对H62黄铜表面钝化膜的成分进行了检测。结果表明:H62黄铜合金由镉、钵双稀土处理液钝化成膜的主要成分为Cu2O,CeO2,La(OH)3,Ce(OH)4;致密的钝化膜耐硝酸点滴时间达到21.98s,在3.5%NaCl溶液自腐蚀电位增加,腐蚀电流降低,腐蚀速度明显降低,耐蚀性能增加,耐中性盐雾性能明显优于鋪单一稀土处理液。 相似文献
13.
目前广泛采用的镍-金属氢化物电池负极材料多为LaNi5基合金。本实验研究了稀土中镨含量分别为0、10%、20%、30%、40%和5种(La,Pr,Nd)Ni3.5Co0.8Mn0.4Al0.3合金的电极性能。发现稀土中镨含是来20%和30%的合金比其它成分手合金具有更高的放电容量,更好的电极稳定性。选用镨含量为17%的富镧混合稀土制备了成分为MlNi3.5Co0.8Mn0.4Al0.3的电极合金, 相似文献
14.
Liang Zhang Song-bai Xue Li-li Gao Yan Chen Sheng-lin Yu Zhong Sheng Guang Zeng 《Journal of Materials Science: Materials in Electronics》2009,20(12):1193-1199
Ternary lead free solder alloys Sn–Ag–Cu were considered as the promising alternatives to conventional SnPb alloys comparing with other solders. In the present work, effects of trace amounts of rare earth Ce on the wettability, mechanical properties and microstructure of Sn–Ag–Cu solder have been investigated by means of scanning electron microscopy and energy dispersive X-ray analysis systematically. The results indicate that adding trace amount of rare earth Ce can remarkably improve the wettability, mechanical strength of Sn–Ag–Cu solder joint at different temperature, especially when the content of rare earth Ce is at about 0.03%, the tensile strength will be 110% times or more than that of the lead free solder joint without rare earth Ce addition. Moreover, it was observed that the trace amount of rare earth Ce in Sn–Ag–Cu solder may refine the joint matrix microstructure, modify the Cu6Sn5 intermetallic phase at the copper substrate/solder interface, and the intermetallic compound layer thickness was reduced significantly. In addition, since rare earth Ce possesses a higher affinity to Sn in the alloy, adding of rare earth Ce can also lead to the delayed formation and growth of the intermetallic compounds of Ag3Sn and Cu6Sn5 in the alloy. 相似文献
15.
环保型铜及其合金化学抛光与钝化新工艺 总被引:4,自引:1,他引:4
为了提高铜及其合金的表面抗变色能力,研制了一种环保的化学抛光工艺和含稀土盐的新型钝化工艺.对抛光与钝化后的试件进行检验,并利用硝酸点滴法及扫描电镜对钝化膜进行了检测,介绍了各组分在抛光液与钝化液中的作用机理,最后简述了常见问题与解决办法. 相似文献
16.
稀土在过共晶高硅铝合金中的合金化作用 总被引:4,自引:0,他引:4
运用力学性能测试、金相显微镜、扫描电镜研究了稀土在含硅量约为22%的过共晶Al-Si合金中的合金化作用。结果表明,稀土可作为合金元素替代昂贵金属Ni,;稀土与Cu,Mg,Fe,Si等形成的稀土化合物产生的第二相强化是改善合金高温拉伸性能的主要原因,稀土对合金的强化作用存在一个稀土的最佳含量范围。 相似文献
17.
The Mg-MM and Mg-Nd master alloys were prepared through the ingot metallurgy method under the protection of a special flux.The thermodynamic behaviors of different rare earth elements in the molten Mg alloys were investigated.Two experimental alloys,Mg-3.0 wt pct MM-0.7wt pct Zn-0.7wt pct Zr and Mg-2.8wt pct Nd-0.7wt pct Zn-0.7wt pct Zr,were prepared.The hardness and tensile properties of experimental alloys were measured and the microstructures were observed.The results showed that the rare earth elements could react greatly with the Mg chloride in the flux.The Mg-Nd-Zn-Zr alloy displayed a good aging hardening effect.The dispersed metastable phase βˊ(Mg3Nd) is an important strengthening phase to improve the tensile properties of this alloy.So the M-g-Nd-Zn-Zr alloy has better tensile properties and elongation than those of the Mg-MM-Zn-Zr alloy,and the ductile fracture character could be observed.The microvoid coalescence is the dominant fracture mechanism in this alloy. 相似文献
18.
19.