首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到20条相似文献,搜索用时 281 毫秒
1.
本文介绍了两种用于超声物位测量的系列换能器──纵向振动夹心换能器和纵振动与圆盘弯曲复合振动的压电换能器。纵向振动夹心换能器的尺寸为40和80,外壳采用了防腐蚀的PVC材料。从压电方程出发,计算了换能器的各部分振动元件的尺寸,然后通过实测,结果表明与计算值相吻合,当换能器距天棚2.5m时。不经过放大器可接收到第一次回波为300mVp-p,配以发射、接收电路盲区为0.5m。另一类是采用纵向振动与圆盘弯曲振动的复合换能器,它具有尖锐的指向性、高的发射效率和接收灵敏度。但是受激圆盘作弯曲振动时,在其表面…  相似文献   

2.
气介式功率超声复合换能器的声辐射特性研究   总被引:2,自引:0,他引:2       下载免费PDF全文
本文对气介式功率超声复合换能器的辐射声场进行了理论计算并与实验结果进行了对比。该复合换能器由夹心式纵向振动半波长换能器及弯曲振动的薄圆盘组成。从理论上推出了弯曲振动辐射圆盘在不同边界条件下的辐射声场分布及其共振频率方程。理论分析结果表明,固定边界弯曲振动圆盘辐射声场的指向性最佳,并且指向性的理论计算结果与实验结果符合很好。  相似文献   

3.
纵-扭复合模式夹心式压电超声换能器是超声马达、超声加工等应用技术中的重要组成部分.本文研究的复合模式换能器由圆柱型金属后盖板、指数型金属前盖板及轴向极化和切向极化的二组压电陶瓷晶堆组成.导出了换能器中纵向振动与扭转振动模式的共振频率方程.并得出了两种振动同频共振的条件.实验表明.换能器的测试频率与设计频率符合很好.且换能器的纵向共振频率与扭转共振频率基本一致.  相似文献   

4.
纵弯耦合宽带换能器设计及高静水压实验分析   总被引:1,自引:0,他引:1       下载免费PDF全文
严伟  郝浩琦 《声学技术》2008,27(3):469-472
利用纵振换能器的前盖板弯曲振动与其纵向振动相耦合的方式来拓宽换能器的频带.采用有限元仿真软件ANSYS对换能器进行整体分析,经过大量的仿真计算,最终优化设计出纵弯换能器,使其电导响应和发送电压响应-3dB带宽均达到了一个倍频程,同时鉴于纵弯换能器耐压性能差,对其进行高静水压下实验分析,实验证明此换能器至少可以承受8MPa的静水压力。  相似文献   

5.
提出了一种圆筒侧臂梁增压型水声换能器的结构形式,阐述并分析换能器的工作原理.利用有限元软件ANSYS对换能器进行了建模,分析了换能器的振动模态、工作频率和接收特性等方面.基于有限元计算的结果,制作了换能器样品并对其进行了测量,测量结果与有限元计算结果相吻合.  相似文献   

6.
在传统的齿轮纵向振动系统中,齿轮与变幅杆耦合处振幅较小,导致齿轮端面输出振幅偏小,满足不了齿轮超声加工的要求.基于非谐振设计理论和全谐设计理论,设计了一种新型齿轮纵向振动系统,该振动系统由齿轮与圆柱杆耦合振动单元、换能器、半波长圆锥形变幅杆组成,齿轮与变幅杆耦合处振幅较大,增大了齿轮端面的输出振幅.圆锥变幅杆形状参数固定时,齿轮分度圆直径和圆柱杆直径对齿轮端面的输出振幅没有影响,减小圆锥变幅杆小端直径可以增大齿轮端面的输出振幅.通过有限元分析和谐振特性实验验证这种新设计方法的可行性.研究结果为齿轮振动系统提供了一种新的设计方法,对齿轮超声加工工艺的工程应用具有重要意义.  相似文献   

7.
两种超声清洗槽中的声场研究   总被引:1,自引:0,他引:1  
本文对两种超声清洗槽中声场的均匀程度、超声频谱及换能器辐射阻抗进行了研究。一种是由夹心式换能器纵向振动通过清洗槽底向槽中辐射产生的声场,另一种是由夹心式换能器激发矩形薄板产生弯曲振动通过槽底向槽中辐射的声场。  相似文献   

8.
张永元  吴胜举  庞绍芳 《声学技术》2007,26(6):1300-1303
设计了一种夹心式纵弯复合振动模式超声换能器,该换能器由纵向夹心式压电超声换能器与弯曲正六边形薄板组成。采用有限元方法,对一定几何尺寸边界自由的正六边形薄板进行模态分析,得到中心位移最大的某一模态,设计以该模态的频率作为共振频率的纵弯复合模式换能器。当复合振动系统振动模式的共振频率与纵向换能器的共振频率以及正六边形薄板弯曲振动的共振频率一致时,复合振动系统具有较高的有效机电耦和系数,系统声辐射能力较强;频率的理论与测量值的误差可能是设计纵向换能器时未考虑预应力螺栓、前后盖板的形状以及横向振动的影响,材料参数的取值与实际值有误差。弯曲振动的正六边形薄板的几何尺寸大,将会增大复合振动系统声波的辐射面积,因此可以改善局部空化腐蚀问题,并且可以提高槽内声场的均匀性,从而可以提高声化学产率;实验结果表明,换能器的共振频率测试值与设计值基本吻合。  相似文献   

9.
一种大功率稀土纵向振动换能器的研究   总被引:4,自引:1,他引:3       下载免费PDF全文
本文采用通用有限元软件ANSYS对一种稀土纵向换能器进行了建模,利用软件中提供的机械振动,电磁场和耦合场等功能分析了换能器的电磁特性和机械振动特性,包括几种磁路结构的比较。磁致伸缩效应的建模,换能器的纵向振动模态以及在空气中的阻抗特性。  相似文献   

10.
超声加工的应用范围很广,而在超声波加工设备中,其关键部件就是超声换能器。这种超声换能器由两部分组成,一部分是声振动推动级,就是换能器振子部分,它可以是压电式的或磁致伸缩式的,目前使用最普遍的是压电振子。另一部分是声振动的放大级,就是超声聚能器部分。在聚能器的输出顶端可以获得比较高的振动能量,以满足各种加工需要。从结构上讲,各种各样的超声换能器可以归成以下三种类型;它们的工作频率大都在几十千赫范围,一般为二十千赫左右。 第一种最常见的换能器是由半波振子和半波聚能器组成,而且半波振子部分多数采用压电纵向复合式振…  相似文献   

11.
A method is proposed for estimating the parameters of a mixture of exponential and Weibull distributions for which the accuracy of preliminary estimates obtained by graphical analysis is refined in accordance with the criterion of maximum likelihood. The efficiency of the proposed method is supported by the results of statistical modeling.  相似文献   

12.
An approximate analytical expression is derived for the velocity of the front of the wave of change of boiling modes on a rod and on a plate. The impact of the Thomson effect and of the heater orientation in the gravity field is included. Adequate agreement is demonstrated between the derived relations and experimental data.  相似文献   

13.
An analysis of anisotropy of the properties of a Bi2Se0.3Te2.7 solid solution was carried out using construction of demonstrative surfaces for thermoelectric effectiveness and thermal expansion coefficients. It is shown that the texture is an important factor forming anisotropy of properties and technological fitness of ingots for manufacturing modules. Anisotropy of properties based on the studies of the ingot textures obtained using the float-zone method and Bridgman method (growing thermoelectric plates in a flat cavity) was studied.  相似文献   

14.
A novel method for the determination of the optical properties of tissue from time-domain measurements is presented. The data analysis is based on the evaluation of the first moment and the second centralized moment, i.e., the mean time of flight and the variance of the measured distribution of times of flight (DTOF) of photons injected by short (picosecond) laser pulses. Analytical expressions are derived for calculation of absorption and of reduced scattering coefficients from these moments by application of diffusion theory for infinite and semi-infinite homogeneous media. The proposed method was tested on experimental data obtained with phantoms, and results for absorption and reduced scattering coefficients obtained by the proposed method are compared with those obtained by fitting of the same data with analytical solutions of the diffusion equation. Furthermore, the accuracy of the moment analysis was investigated for a range of integration limits of the DTOF. The moment analysis may serve as a comparatively fast method for evaluating optical properties with sufficient accuracy and can be used, e.g., for on-line monitoring of optical properties of biological tissue.  相似文献   

15.
16.
Australia has several uranium mines and a large number of mineral sand mines, with associated processing facilities. Exposures resulting from these mining and processing operations usually involve intakes of mixtures of radionuclides. This work describes the development of a suite of first order, linear compartment models, based on the ICRP Publication 66 respiratory tract model, and an analytical solution to the decay equations, for assessing the consequences of such intakes. The computer programs based on these models directly compute excretion, organ retention and organ and whole-body doses for intakes of either single radionuclides or any mixture of radionuclides belonging to the same radioactive decay chain. The intake can be via inhalation, ingestion or injection, and can be acute, chronic or of limited duration. The starting concentration and degree of secular (dis)equilibrium can be specified for each radionuclide. No assumptions need to be made about the relative magnitudes of the radioactive half-lives of the different nuclides.  相似文献   

17.
18.
19.
水三相点是开尔文热力学温度的唯一基准点,也是ITS-90国际温标重要的定义固定点。因此,水三相点不确定度分析对整个温标的建立、温度量值传递起着至关重要的作用。近3年来,中国计量科学研究院研制出一系列高质量的水三相点容器,加强了水三相点的研究,为不确定度的分析提供了更为可靠的实验依据。同时,不确定度的分析也是客观评价新研制容器性能的一个重要指标。因此,根据实验结果对新研制容器所复现的水三相点进行了不确定度评定。评定结果表明,其扩展不确定度为0.16mK(k=2.69,P=0.99)。  相似文献   

20.
可燃气体检测报警器测量结果的不确定度评定   总被引:1,自引:0,他引:1  
本文详细介绍了可燃气体检测报警器示值误差测量结果的不确定度评定方法。  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号