Numerical study of the mixing process of binary-density particles in a bladed mixer

Discrete element method (DEM) simulations of binary mixing of particles with different densities were conducted to study the influence of density ratio, blade speed, and filling level on the particle dynamics and mixing performance in a bladed mixer. Four particles with different densities at different locations were tagged to discuss the influence of three factors on the particle trajectory and velocity field in the mixer. A method based on cubic polynomial fitting of relative standard deviation was used to determine the critical revolution during the mixing process. It was found that the non-dimensional tangential velocity decreases with the increase of the blade speed and filling level, the fluctuation of vertical velocity increases with the radial location, blade speed, and filling level, and it is more pronounced than the fluctuation of tangential and radial velocity during the mixing process. Results obtained indicate that the mixing performance of particles with different density increases with the decrease of density ratio and filling level, while it increases with the increase of blade speed.     

Numerical study of the motion behaviour of three-dimensional cubic particle in a thin drum

The motion of three-dimensional cubic particles in a thin rotating drum is simulated by the SIPHPM method. The drums with frictional or smooth front and rear walls, and the particles of cubic and spherical shapes, and different particle numbers are considered to study the effect of cubic particle shape, end-wall frictions and filling levels. Different flow patterns of cubic particles are observed, which are significantly dominated by the friction from the end-walls. The probability density function of velocity components, the flatness factors are used to analyze the motion behaviour of cubic particle. The Froude number, ensemble mean and time averaged particle velocities are also analyzed. A primary and secondary mode of driving from the end-wall frictions are indicated and the mechanisms on the influences of wall friction, particle shape and filling levels are fully explained.