共查询到20条相似文献,搜索用时 62 毫秒
1.
对四角切向燃烧煤粉锅炉内冷态气相流动进行了数值模拟。为减小数值伪扩散对强旋流动的影响,采用了减小网格 尺寸和提高差分格式精度等措施。通过与实验结果的对比分析,评价了不同模型与方法对流动模拟效果的影响。 相似文献
2.
3.
4.
本文数值模拟了煤粉旋流火焰燃烧过程,燃烧数值计算包括理论物理模型建立,数值方法两个大部分,计算模型处理了气相湍流与燃烧、气固两相流动、煤颗粒燃烧过程和辐射传热等物理化学过程,以k-ε模型模拟湍流流动;PDF法模拟气相扩散火焰燃烧;颗粒运动计算颗粒运动少颗粒湍流浓度方程模拟颗粒湍流扩散;通量法计算火焰辐射传热,煤粉颗粒复杂燃烧模型计算了颗粒尺寸、形状变化和颗粒孔隙内部燃烧、表面平度对整个颗粒的燃烧过程影响。计算获得了气相速度分布场、气相k和ε分布场、气相温度场、气相组份场和颗粒浓度场及运动过程,揭示了煤粉复合旋流燃烧特性。 相似文献
5.
6.
用RNGκ—ε模型计算内燃机缸内湍流流动 总被引:3,自引:0,他引:3
应用快速畸变假设对RNGκ-ε湍流模型进行压缩性修正后,将其应用于内燃机缸内湍流流动的数值模拟,计算采用任意拉格朗日-欧拉法。给出了用RNGκ-ε模型算得的结果,并与标准的RNGκ-ε模型算得的结果和实验结果进行了对比。结果表明,用RNGκ-ε湍流模型算得的结果比RNGκ-ε模型算得的结果有所改进,此模型适合于计算内燃机缸内湍流流动。 相似文献
7.
强旋湍流气固两相流动和煤粉燃烧数值模拟 总被引:1,自引:0,他引:1
该文给出一种用于强旋流的气固两相湍流模型,采用双流体模型及相应的数值解法,求解旋风炉燃烧室内气固两相流动及煤粉燃烧。模拟结果表明,前置室内湍流空气动力场分布具有强旋,中心回收流和各向异性湍流的特点。 相似文献
8.
9.
10.
本文介绍四角切向燃烧锅炉炉内流动过程的数值模拟方法,三维湍流气相流场通用计算方法、计算对象的进、出口边界条件、固体壁面条件及近壁面处理技巧.利用所开发的炉内三维湍流气相流场数值计算程序,对焦作电厂3号炉进行实例计算.计算结果较准确地预测了炉内实际流动情况. 相似文献
11.
13.
14.
Alexandre Suryadi Florian Nils Schmidt Christina Appel Nils Reiche Roland Ewert Michaela Herr Jochen Wild 《风能》2023,26(1):23-43
The rotor of a large diameter wind turbine experiences more substantial and more dynamic loads due to the fluctuating and heterogeneous wind field. The project SmartBlades 2.0 investigated rotor blade design concepts that alleviate aerodynamic loading using active and passive mechanisms. The present work evaluates the acoustics of the two load alleviating concepts separately, an inboard slat and an outboard flap, using the Fast Random Particle Mesh/Fast Multipole Code for Acoustic Shielding (FRPM/FMCAS) numerical prediction toolchain developed at DLR with input from the averaged flow field from RANS. The numerical tools produce a comparable flap side-edge noise spectrum with that of the measurement conducted in the Acoustic Wind Tunnel Braunschweig (AWB). The validated FRPM/FMCAS was then used to analyze the self-noise from a slat at the inboard section of a rotor blade with a 44.45 m radius and compared with that from the outboard trailing edge. Furthermore, the rotational effect of the rotor was included in the post-processing to emulate the noise observed at ground level. The findings show an increase in the slat's overall sound pressure level and a maximum radiation upwind of the wind turbine for the case with the largest wind speed that represents the off-design condition. In operational conditions, the slat adds at most 2 dB to the overall sound pressure level. The toolchain evaluates wind turbine noise with conventional or unconventional blade design, and the problem can be scaled up for a full-scale analysis. As such, the tools presented can be used to design low-noise wind turbines efficiently. 相似文献
15.
Luis Valiño Radu MustataMaría Isabel Gil Jesús Martín 《International Journal of Hydrogen Energy》2010
A numerical study of a PEMFC (proton exchange membrane fuel cell) bipolar plate has been made to study the influence of the relative entry positions of hydrogen and oxygen on the distribution of gases. Various 3D configurations, under simplified working conditions, have been considered. As the main result, it is shown that the flow of the gas in stoichiometric defect (usually hydrogen) forces the pattern of the other reactant gas (oxygen). 相似文献
16.
等离子点火系统数值模拟计算 总被引:1,自引:0,他引:1
本文用等效的内部加热区代替产生欧姆热的电弧,采用k—ε双方程湍流模型进行数值模拟,对等离子点火装置内的气体流场进行计算。通过改变不同的工况,分析了进气速度,电功率对电极斑点附近的电极表面温度及流场温度的影响。计算表明增加气流量可以有效提高电极的冷却效果,也是提高电极冷却效果的最佳途径;但增加气流量不但使喷嘴出口气流平均温度降低,而且还会增加电源功率,同时也容易使等离子弧进入湍流区。通过对数值模拟结果的分析,提出了等离子发生器的结构设计的合理建议。 相似文献
17.
通过600MW汽轮机中压外缸斜法兰的加工工艺的分析,叙述了一种采用三轴联运数控程序加工斜法兰的新工艺以及编程技巧。 相似文献
18.
19.
20.
介绍锅炉结渣的机理以及控制炉内结渣过程的主要因素,用数值模拟方法对某电厂360t/h锅炉结渣问题进行分析,并提出了改造该锅炉切实可行的措施.通过对该锅炉第二次改造后运行实践的检验,得出了与防结渣技术相关的一些结论. 相似文献