首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到10条相似文献,搜索用时 109 毫秒
1.
The shock wave dynamics, spontaneous ignition and flame variation during high-pressure hydrogen release through tubes with different cross-section shapes are experimentally studied. Tubes with square, pentagon and circular cross-section shapes are considered in the experiments. The experimental results show that the cross-section shape of the tube has no great difference on the minimum burst pressure for spontaneous ignition in our tests. In the three tubes with length of 300 mm, spontaneous ignition may occur when overpressure of shock wave is 0.9 MPa. When the spontaneous ignition is induced in a non-circular cross-section tube, the possible turbulent flow in the corner of the tube increases can promote the mixing of hydrogen and air, thus producing more amount of the hydrogen/air mixture. As a result, both the peak light signal and flame duration detected in the non-circular cross-section tubes are more intense than those in the circular tube. The smaller angle of the corner leads to a more intensity flame inside tube. When the hydrogen flame propagates to the tube exit from the circular tube, the ball-like flame developed near tube exit is relatively weak. In addition, second flame separation outside the tube is observed for the cases of non-circular cross-section tubes.  相似文献   

2.
In premixed H2/air explosion venting, an under-expansion jet may be caused by the pressure difference between the inside and outside of the explosion vent. Based upon the under-expansion jet, studying the structure of the under-expansion jet flame and the factors influencing its formation is essential to hydrogen safety in explosion venting. This study explored the basic characteristics of the under-expansion jet flame in premixed H2/air explosion venting, and discussed the formation of two under-expansion structures (Mach disk and diamond shock wave) of such jet flames by conducting a premixed H2/air explosion venting experiment. The influences of hydrogen fraction, explosion venting diameter, and duct length on the structure of under-expansion jet flames were evaluated. The results showed that after successful explosion venting, the under-expansion jet flame would be generated when the hydrogen fractions were 30–60 vol.%, and as the hydrogen fractions were 30–50 vol.%, the lengths of the venting duct were 30 and 50 cm. The duration of under-expansion jet flame was the longest when the hydrogen fraction was 40 vol.%. With the explosion venting diameter and hydrogen fraction increased, the spacing between under-expansion jet flame structures (S) increased. However, an increase in duct length led to the attenuation of the S. During the explosion venting, the under-expansion jet caused a pressure imbalance near the explosion vent and high-intensity convection forms on both sides of a jet, which can generate two or more explosions. Therefore, understanding the basic characteristics of under-expansion jet flame can aid the effective development of measures to prevent, mitigate, and protect against premixed H2/air explosions.  相似文献   

3.
An experimental study was conducted to research the mechanism of spontaneous ignition induced by high-pressure hydrogen release through tubes with a diameter of 10 mm and varying lengths from 0.3 to 3 m. The pressure and light signals inside the tube were collected. The propagation of shock wave inside and outside the tube was also systematically investigated. The development process of the jet flame in the atmosphere was completely recorded, and the multiple Mach disks at the tube exit were observed by using a high-speed camera. The results show that the minimum release pressure, at which the jet flame is formed, is found to be 3.87 MPa with the tube length of 1.7 m. When the tube length was longer than 1.7 m, the critical pressure for forming jet flame increased rapidly. The velocity attenuation of the shock wave is mainly affected by the burst pressure but not sensitive to the tube length, and the flame propagates in the tube at a slower velocity than the shock wave. The compression of the hydrogen-air mixture by the Mach disk causes it to burn more violently after passing through the Mach disk. It is confirmed that the flame at the tube exit is lifted in the atmosphere, then a jet flame initiates behind the second Mach disk.  相似文献   

4.
This paper investigates the effects of hydrogen additions on spontaneous ignition of high-pressure hydrogen released into hydrogen-air mixture. Hydrogen and air are premixed with different volume concentrations (0%, 5%, 10%, 15% and 20% H2) in the tube before high-pressure hydrogen is suddenly released. Pressure transducers are employed to detect the shock waves, estimate the mean shock wave speed and record the shock wave overpressure. Light sensors are used to determine the occurrence of high-pressure hydrogen spontaneous ignition in the tube. A high-speed camera is used to capture the flame propagation behavior outside the tube. It is found that only 5% hydrogen addition could decrease the minimum storage pressure required for spontaneous ignition from 4.37 MPa to 2.78 MPa significantly. When 10% or 15% hydrogen is added to the air, the minimum storage pressure decreases to 2.81 MPa and 1.85 MPa, respectively. When hydrogen addition increases to 20%, the spontaneous ignition even takes place at burst pressure as low as 1.79 MPa inside the straight tube.  相似文献   

5.
Spontaneous ignition induced by high-pressure hydrogen release is one of the huge potential risks in the promotion of hydrogen energy. However, the understanding of the microscopic dynamic characteristics of spontaneous ignition, such as ignition initiation and flame development, remains unresolved. In this paper, the spontaneous ignition caused by high-pressure hydrogen release through a tube is investigated by two-dimensional numerical simulation at burst pressure ranging from 2.67 to 15 MPa. Especially, the thermal and species characteristics in hydrogen shock-induced ignition under different strengths of shock wave are discussed carefully. The results show that the stronger shock wave caused by higher burst pressure leads to larger heating area and higher heating temperature inside the tube, increasing the possibility of spontaneous ignition. The shortening effect of initial ignition time and initial ignition distance will decrease with the increase of the burst pressure. Ignition will be initiated when the temperature is raised to about 1350–1400 K under the heating effect of shock waves. It is also found that the ignition occurs under the lean-fuel condition firstly on the upper and lower walls of the tube. The flame branch after spontaneous ignition is observed in the mixing layer. Two ignition kernels show different characteristics during the process of combustion and flow. The evolution of HRR and mass fraction of key species (OH, H, HO2) are also compared to identify the flame front. The mass fraction of H has the better trend with HRR. It is suggested that H radical is a more reasonable choice as the indicator of the flame front.  相似文献   

6.
A series of experiments were conducted to study the pressure and combustion characteristics of the high-pressure hydrogen during the occurrence of spontaneous ignition and the conversion from spontaneous ignition to a jet fire and explosion. Different initial conditions including release pressure (4–10 MPa), tube diameter (10/15 mm), and tube length (0.3/0.7/1.2/1.7/2.2/3 m) were tested. The variation of the pressure and flame signal inside and outside of the tube and the development of the jet flame were recorded. The experimental results revealed that the minimum ignition pressure required for self-ignition of hydrogen at different tube diameters decreased first and then increased with the extension of tubes. The minimum ignition pressure for tubes diameters of 10 mm and 15 mm is no more than 4 MPa and the length of the tubes is L = 1.7 m. The minimum release pressure required for spontaneous ignition of a tube D = 15 mm is always lower than that of a tube D = 10 mm at the same tube length. When the spontaneous ignition occurred, it did not absolutely trigger the jet fire. The transition from spontaneous ignition to a jet fire must go through the specific stages.  相似文献   

7.
The tendency of spontaneous ignition of high-pressure hydrogen during its sudden release into a tube is one of the main threats to the safe application of hydrogen energy. A series of investigations have shown that the tube structure is a key factor affecting the spontaneous ignition of high-pressure hydrogen. In this paper, a numerical study is conducted to reveal the mechanism of spontaneous ignition of high-pressure hydrogen inside the tube with local contraction. Large Eddy Simulation, Renormalization Group, Eddy Dissipation Concept, 37-step detailed hydrogen combustion mechanism and 10-step like opening process of burst disk are employed. Three cases with burst pressures of 3.10, 4.90, and 8.45 MPa are simulated to compare against the pervious experimental study. The spontaneous conditions and positions agree well with the experimental results. The numerical results indicate that shock wave reflection takes place at the upstream vertical wall of contraction part. The interacted-shock-affected region is generated at the tube center because of the subsequent shock wave interaction. The forward reflected shock wave couples with normal shock wave and increases the pressure of leading shock wave. The sudden contraction of tube blocks the propagation of hydrogen jet and decreases the speed from supersonic flow to subsonic flow. More flammable mixture is generated inside the contraction part, as a results, the length of the flame is increased. Two mechanisms are proposed finally.  相似文献   

8.
Spontaneous ignition processes due to high pressure hydrogen releases into air are known phenomena. The sudden expansion of pressurized hydrogen into a pipe, filled with ambient air, can lead to a spontaneous ignition with a jet fire. This paper presents results of an experimental investigation of the visible flame propagation and pressure measurements in 4 mm extension tubes of up to 1 m length attached to a bulk vessel by a rupture disc. Transparent glass tubes for visual observation and shock wave pressure sensors are used in this study. The effect of the extension tube length on the development of a stable jet fire after a spontaneous ignition is discussed.  相似文献   

9.
A high-pressure hydrogen jet released into the air has the possibility of igniting in a tube without any ignition source. The mechanism of this phenomenon, called spontaneous ignition, is considered to be that hydrogen diffuses into the hot air caused by the shock wave from diaphragm rupture and the hydrogen-oxidizer mixed region is formed enough to start chemical reaction. Recently, flow visualization studies on the spontaneous ignition process have been conducted to understand its detailed mechanism, but such ignition has not yet been well clarified. In this study, the spontaneous ignition phenomenon was observed in a rectangular tube. The results confirm the presence of a flame at the wall of the tube when the shock wave pressure reaches 1.2–1.5 MPa in more than 9 MPa burst pressure and that ignition occurs near the wall, followed by multiple ignitions as the shock wave propagates, with the ignitions eventually combining to form a flame.  相似文献   

10.
Experiments on shock waves propagation, spontaneous ignition, and flame development during high-pressure hydrogen release through tubes with symmetrical obstacles (O1-1) and asymmetrical obstacles (O1-2) are conducted. The obstacle's side is triangular with a length of 4 mm, a height of 3.6 mm, and its width is 15 mm. In the experiments, a reflected shock wave generates and propagates both upstream and downstream when the leading shock wave encounters the obstacle. At the same burst pressure, the reflected shock wave intensity in tube O1-1 is significantly greater than that in tube O1-2. Moreover, the presence of obstacles in the tube can induce spontaneous ignition. The minimum burst pressures for spontaneous ignition for tubes O1-1 and O1-2 are 2.84 MPa and 3.28 MPa respectively, lower than that for the smooth tube. Furthermore, both the initial ignition position and ignition time are greatly advanced in obstruction tubes, mainly affected by obstacle positions and burst pressures. Finally, the flame separation process near the obstacle is observed. After passing the obstacle, the flames grow rapidly in radial and axial directions on the tube sidewalls. And at the same burst pressure, the flame convergence time in tube O1-2 is usually longer than that in tube O1-1.  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号