合成己二腈反应技术研究——(Ⅴ)己二腈工业反应过程模拟与反应器改造

对己二腈工业反应器提出了两釜串联带回流的模型,通过模拟计算得出模型的级间返混系数 f=6的结论。该模型能较好地预测工业反应器中物料组分浓度变化和气、液两相的流动特性;指出了现工业反应器的鼓泡中和段体积偏小是造成己二酸浓度偏高的关键;提出了可以通过增加串连一个鼓泡预反应段的改造方案,能有效地降低己二酸的浓度,从7%降至4%左右,从而能较好地减缓腐蚀和结焦。     

Kinetics of two-step anionic polymerization

This article deals with the kinetics of two-step anionic polymerization by way of a non-steady state method. Several molecular parameters can be evaluated using the formulae developed. A bimodal molecular weight distribution function for the resulting polymer is derived from the set of kinetic differential equations, which is in agreement with the experimental data reported.     

Structure and properties of CE/CTBN/EP blends: II. Effect of EP on the mechanical properties and thermostability of the CE/CTBN system

Carboxyl‐terminated butadiene‐acrylonitrile rubber (CTBN) has often been used to improve the toughness of cyanate ester (CE) resin while sacrificing modulus and thermostability. In this paper, the addition of the appropriate amount of epoxy resin (EP) to the CE/CTBN system is shown to not only increase the modulus and thermostability of the blend, but also improve the toughness. The values of impact strength showed a maximum for the CE/CTBN/EP 100/5/5 blend. The temperature of 10 % weight loss (T₁₀) improves from 376 °C for CE/CTBN 100/5 to 407 °C for the CE/CTBN/EP 100/5/2.5 blend. It is proposed that addition of the appropriate amount of EP can decrease the mobility and increase the stability of CTBN via the reaction between the terminal carboxyl group of CTBN and the hydroxyl group of EP. But a very high EP concentration will decrease the crosslinking density of CE, consequently reducing the mechanical properties and thermostability of the blends. Copyright © 2004 Society of Chemical Industry     

β－C_2S固溶体稳定的热力学研究

从热力学理论出发，利用Ｘ射线衍射定性和定量的方法，对β－Ｃ＿２Ｓ固溶体的稳定性进行了分析和研究。经热力学理论推导得出β－Ｃ＿２Ｓ稳定的热力学条件，即掺入的微量元素的化学位μ＿ｉ须小于β－Ｃ＿２Ｓ的反应自由焓△Ｇ＿β，μ＿ｉ＜△Ｇ＿β．并定量地计算出一种微量元素稳定β－Ｃ＿２Ｓ的临界掺加量为；多种微量元素对β－Ｃ＿２Ｓ的稳定性判断条件为：     

Photoreactivation of Escherichia coli following medium-pressure ultraviolet disinfection and its control using chloramination.

Ultraviolet (UV) disinfection is becoming increasingly popular as an alternative disinfection technology to chlorination in recent years. In this study, we investigated the photoreactivation of Escherichia coli following medium-pressure (MP) UV disinfection of synthetic water by a bench-scale collimated beam apparatus. The UV doses ranged from 1.6 -19.7 mWs/cm2 and photoreactivation was investigated for 6 hours under fluorescent light. In addition, chloramination was applied after UV disinfection to investigate its ability to control photoreactivation. It was found that photoreactivation occurred for all UV doses tested and the increase in bacteria numbers ranged from 0.04 to 1.35 log10. However, the degree of photoreactivation decreased with increased UV doses. Chloramination experiments revealed that the addition of 0.5 mg/l of monochloramine resulted in suppression of photoreactivation for 1 hour only. An increased monochloramine dose of 1 mg/l was found to prevent photoreactivation for the entire duration of the experiment. The results of this study have shown that photoreactivation occurs even after MP UV disinfection, although it is of a lesser extent at higher UV doses. This study has also established that secondary chloramination can effectively suppress and eliminate photoreactivation with a chloramine dose of 1 mg/l.     

Temperature dependence study of two-dimensional electron gas effecton the noise performance of high frequency field effect transistors

We present experimental evidence that the noise figure (NF) and associated gain equal to those achieved with GaAs pseudomorphic high electron mobility transistors (GaAs p-HEMT's) can also be accomplished by ion implanted GaAs metal-semiconductor field-effect transistors (GaAs MESFET's). These measured noise figure results as a function of low temperature for GaAs MESFET's and p-HEMT's clearly suggest that the transport properties of the two-dimensional electron gas in HEMT's and p-HEMT's do not make a significant contribution to the noise reduction at high frequency operation of these devices     

化工企业环境因素的评价

化工企业环境因素评价是建立环境管理体系的核心任务，化工企业生产过程的特点决定了其环境因素数量多、环境影响大、识别评价难、控制难度大。本文介绍了化工企业环境因素评价的技术方法和过程，可以为提高环境因素评价的科学性、客观性和充分性提供参考。     

我国建筑涂料技术进步简评

从以下诸方面简述我国建筑涂料的技术进步:⑴新品种涂料的研制开发;⑵加强对配套材料及施工技术的研究;⑶超细填料在涂料中的应用;⑷计算机自动配色技术;⑸产品标准的修订;⑹建筑涂料的实用范围扩大。     

浅谈高层建筑火灾扑救

前言伴随着我国经济建设的迅速发展 ,高层建筑已在各大城市大量涌现。大量的高层建筑 ,既为城市的经济发展增添了繁荣的氛围 ,同时又给消防安全提出了新的课题。近年来 ,高层建筑所引发的火灾已成为全世界关注的一个难题。据统计 ,1999年全国共发生高层建筑火灾 112 2起 ,而 2 0 0 0年则猛增到 184 32起。因此 ,加强对高层建筑火灾扑救的研究 ,对缔造良好的消防环境 ,确保经济和社会稳定至关重要。本文仅是作者的一些浅见 ,希望能有可取之处与大家分享。18世纪末至 19世纪 ,欧洲和美国的的工业革命带来了生产力的发展与经济的繁荣。这个时期…