Electrochemical growth and characterization of iron doped cadmium sulfide thin films

Cadmium Sulfide and Ferrous doped Cadmium Sulfide thin films have been prepared on different substrates using an electrodeposition technique. Linear sweep voltammetric analysis has been carried out to determine deposition potential of the prepared films. X-ray diffraction analysis showed that the prepared films possess polycrystalline nature with hexagonal structure. Surface morphology and film composition have been analyzed using Scanning electron microscopy and Energy dispersive analysis by X-rays. Optical absorption analysis showed that the prepared films are found to exhibit Band gap value in the range between 2.3, 2.8 eV for Cadmium Sulfide and Ferrous doped Cadmium Sulfide.     

原子吸收次灵敏线法直接测定土壤中Fe、Mn

用原子吸收次灵敏线法塞曼效应扣除背景测定土壤中Fe、Mn,实验结果表明:此方法有较好的准确度,精密度,操作简单,适合一般土壤中Fe、Mn的测定。     

二价金属离子对UASB颗粒污泥的影响

分析了Mg^2 、Ca^2 、Fe^2 等二价金属离子对UASB反应器中厌氧颗粒污泥的影响。     

纳米Fe粉的制备研究

总结了纳米Fe粉的制备方法,重点介绍了一种新的制备方法——封闭循环氢还原法。该方法以FeSO·47H2O和NaOH为原料,采用沉淀方法制备粒径为30～70nm的Fe2O3粉末,其反应条件为:反应温度50℃,反应终点pH值大于12,陈化时间1h。用封闭循环氢还原法,在400℃下还原Fe2O3得到了Fe粉。其粒径在20～50nm之间,含量为99.16%。     

Hydrogen Absorption and Release Behavior in Hydrogen Decrepitation Process of Nd-Fe-B Alloys

The behavior of hydrogen absorption and release in hydrogen decrepitation (HD) process of Nd-Fe-B alloys were investigated. The results reveal that the reactivity and the amount of hydrogen absorption in HD process are related to the surface activity of the alloy so that the fresh and active surface has a higher efficiency. The presence of Nd-rich phase at the grain boundary is an essential factor of the HD activity of the alloy at room temperature. On degassing, hydrogen is released from the HD powder continuously with increasing temperature. And the residual hydrogen is as low as 0.0015% at 1073K, which shows that the hydrogen is almost exhaused. It is feasible to remove the hydrogen from the HD powder by heating treatment at the temperature of 523-723K for 1h prior to the magnetic field forming in order to decrease the harmful effect of hydrogen on the easy axis alignment of HD magnet.     

Electrochemical Investigation on the Formation of Dy-Fe Alloy in Molten Chlorides

ＥｌｅｃｔｒｏｃｈｅｍｉｃａｌＩｎｖｅｓｔｉｇａｔｉｏｎｏｎｔｈｅＦｏｒｍａｔｉｏｎｏｆＤｙＦｅＡｌｏｙｉｎＭｏｌｔｅｎＣｈｌｏｒｉｄｅｓＬｉｕＧｕａｎｋｕｎ（刘冠昆），ＴｏｎｇＹｅｘｉａｎｇ（童叶翔），ＨｏｎｇＨｕｉｃｈａｎ（洪惠婵），Ｙａｎｇ...     

臭氧在食品加工用水处理工程上的应用

本文叙述了臭氧的一些特性 ,并以烟台某食品加工公司食品加工用水处理工程为例 ,介绍了臭氧的产生及应用情况 ,提供了处理前后水中各项指标的对照     

压力对Fe－29wt％Ni合金超细微粒特性的影响

利用蒸发冷凝法，制备了不同平均粒径的Ｆｅ－２９ｗｔ％Ｎｉ合金超细微粒。在不同压强下，将超细微粒压制成片。随压强增大，马氏体体积分数和比饱和磁化强度σｓ明显增大，而矫顽力Ｈｃ呈线性下降。压力效应与平均粒径ｄ大小密切相关     

纳米Fe2O3对镁铬耐火材料烧结及力学性能的影响

在镁铬耐火材料中添加纳米Fe2O3,研究了它对镁铬耐火材料烧结性能与常温力学性能的影响.结果发现,在相同的工艺条件下,加入1%(外加)的纳米Fe2O3即可使镁铬砖的烧成温度降低150℃左右,并在相同烧成温度下能使试样的常温抗折强度和耐压强度大幅度提高.分析认为,在镁铬耐火材料中添加少量纳米级Fe2O3,可促进MgO-FeO固溶体中Cr3+和Al3+含量的提高,增强镁铬砖的直接结合程度,从而提高其力学性能.