Large domain-wall currents in epitaxial Au/BiFeO3/SrRuO3 thin-film capacitors with modulated oxygen vacancy and wall densities

Large domain wall (DW) conductivity in an insulating ferroelectric plays an important role in the future nanosensors and nonvolatile memories. However, the wall current was usually too small to drive high-speed memory circuits and other agile nanodevices requiring high output-powers. Here, a large domain-wall current of 67.8 μA in a high on/off ratio of ~4460 was observed in an epitaxial Au/BiFeO₃/SrRuO₃ thin-film capacitor with the minimized oxygen vacancy concentration. The studies from read current-write voltage hysteresis loops and piezo-response force microscope images consistently showed remaining of partially unswitched domains after application of an opposite poling voltage that increased domain wall density and wall current greatly. A theoretical model was proposed to explain the large wall current. According to this model, the domain reversal occurs with the appearance of head-to-head and tail-to-tail 180° domain walls (DWs), resulting in the formation of highly conductive wall paths. As the applied voltage increased, the domain-wall number increased to enhance the on-state current, in agreement with the measurements of current-voltage curves. This work paves a way to modulate DW currents within epitaxial Au/BiFeO₃/SrRuO₃ thin-film capacitors through the optimization of both oxygen vacancy and domain wall densities to achieve large output powers of modern domain-wall nanodevices.     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.     

储层泥浆侵入深度预测方法研究

泥浆侵入半径的确定尚缺乏严格的验证标准.以油水两相渗流理论和离子扩散方程为基础,结合储集层特点,研究了不同储层参数下泥浆滤液对地层的侵入特性.数值模拟侵入时间选取10 d和20 d.数值模拟结果表明,侵入半径在渗透率不变的情况下随孔隙度的增大而减小,在孔隙度不变的情况下随渗透率的增大而增大;当渗透率和孔隙度都发生变化时,泥浆侵入半径一般随孔隙度的增加呈幂函数增加.依据这种关系对测井资料约束处理,得到的泥浆侵入半径较客观地反映了地层的真实情况.     

墙体裂缝的成因及防治

介绍了墙体裂缝的种类，从地基不均匀下沉、温度变化等方面分析了引起墙体裂缝的原因，介绍了墙体裂缝的预防措施和治理措施，以有效控制墙体裂缝的危害程度。     

砾岩储层精细描述中标准测井资料的应用

克拉玛依油田七区的标准测井资料是指使用标准电极系视电阻率测井、自然电位测井和井径测井,以相同的1:500深度比例尺及相同的横向比例进行测井作业所取得的资料.这种资料本来并不具备定量解释储层孔隙度和含油饱和度的能力,但这种资料占该区测井资料总量的比率高达34%.利用标准电极系视电阻率资料和岩心分析资料建立了视电阻率-岩性图版,利用自然电位减小系数α和岩心孔隙度分析资料φ建立了α-φ图版,根据综合测井资料求出标准测井视电阻率校正系数,进而确定了饱和度计算方程的参数.与相应的综合测井资料计算结果相对比,用该方法得到的孔隙度平均绝对误差及相对误差分别为1.85%和11.88%;含油饱和度平均绝对误差及相对误差分别为9.08%和24.75%.将该方法有选择地应用到该区砾岩储层精细描述研究中,弥补了缺乏综合测井资料无法进行测井储层评价及参数研究的缺陷.     

川西新场气田JS_2~1气藏测井多参数评价方法

针对川西新场气田JS12气藏开展了多参数的综合评价研究,多参数包括储层参数、裂缝参数、储层分类厚度参数。首先,开展了储层参数及裂缝参数的计算,以岩心分析结果为依据,建立了孔隙度、渗透率、含水饱和度计算模型。利用铸体薄片进行了微裂缝识别,对样品的裂缝参数和测井曲线进行相关分析,建立了测井计算裂缝参数的数学模型;其次,对储层进行聚类分析,通过聚类将储层分为三类;最后,将计算的裂缝参数、储层分类中的Ⅰ类储层厚度、孔渗饱等参数进行正态化处理,拟和测试的无阻流量与这些参数建立多元回归计算模型,即综合含气指标的数学计算模型。以综合含气指标为主要依据,进行储层综合分类和评价,指出了有利的含气区域和可供挖潜井的建议。该方法在指导气藏开发中获得了良好效果。     

地震平衡技术及其在地震反演中的应用

地震平衡技术是一种在地震反演中改善井震关系的新技术。它通过单井对比、空间分形建模以及平衡处理的手段 ,克服地震反演中子波空变的影响 ,使得经过地震平衡技术处理的地震剖面井震关系得到较好改善 ,从而可以用统一的子波对研究区的地震资料进行反演     

多臂井径成像测井技术

多臂井径成像测井技术同以往的40臂、X—Y井径等非成像工程测井相比具有较为明显的优势，不但可以做定量解释提供最大、最小、平均井径值，而且可以提供更为直观的18条或36务独立的测井曲线、磁井径，磁重量、井温、井壁立体图、井壁成像图、井壁截面图，为检测井下套管的完好性及修复提供了更为可靠直观的资料，满足了地质学家及时监测套管状况的要求，也为油井作业、大修提供全面、准确的套管全貌。文章介绍了18臂、36臂两种井径成像测井技术。并通过对测试资料实例的解释、分析、研究，总结了多臂井径成像测井技术的特点及应用效果。