Novel approaches to purifying bacteriocin: A review

ABSTRACT

Bacteriocin is a proteinaceous biomolecule produced by bacteria (both Gram-positive and Gram-negative) that exhibits antimicrobial activity against closely related species, and food-borne pathogens. It has recently gained importance and attracted the attention of several researchers looking to produce it from various substrates and bacterial strains. This ushers in a new era of food preservation where the use of bacteriocin in food products will be an alternative to chemical preservatives, and heat treatment which are understood to cause unwanted side effects, and reduce sensory and nutritional quality. However, this new market depends on the success of novel downstream separation schemes from various types of crude feedstocks which are both effective and economic. This review focuses on the downstream separation of bacteriocin from various sources using both conventional and novel techniques. Finally, recommendations for future interesting areas of research that need to be pursued are highlighted.     

灵芝菌丝体多糖的分离纯化及其单糖组成分析与分子量测定

前期杂交优化后赤芝菌种经液体深层发酵后,提取灵芝菌丝体多糖,并过DEAE-Sepharose Fast Flow柱分离纯化,利用高效体积排阻色谱(HPSEC)检测多糖级分的纯度,采用完全酸水解PMP柱前衍生化RP—HPLC测定多糖级分的单糖组成,多角度光散射仪联用装置(SEC—MALLS)测定其绝对重均分子量(Mw),并且根据分子旋转半径与分子摩尔数的关系曲线斜率初步推断其空间构象。结果显示:分离纯化得到3个多糖级分GLMP1、GLMP2和GLMP3,HPSEC检测其峰面积百分比分别为93.58%,97.64%,99.19%,单糖组成分析结果表明GLMP1、GLMP2和GLMP3均含有甘露糖、鼠李糖、半乳糖醛酸、葡萄糖、半乳糖、木糖、阿拉伯糖和岩藻糖,但单糖摩尔比各异。SEC—MALLS测试GLMP1、GLMP2和GLMP3的Mw分别为4.526×105,4.603×104,3.760×103 g/mol,3个多糖级分构象可能均为高度紧缩且具有分支结构的聚合物。     

Nitric oxide reduction and carbon monoxide oxidation over carbon-supported copper-chromium catalysts

Carbon supported copper-chromium catalysts are shown to be very active for both the reduction of nitric oxide with carbon monoxide and the oxidation of carbon monoxide with oxygen. Mixed copper-chromium oxide active phases have good activity in the simultaneous removal of nitric oxide and carbon monoxide from exhaust gases. The influence of several catalyst variables has been investigated. The activity per volume of catalyst increases with increasing loading, while the intrinsic activity shows a maximum around C/M=100−50. An optimum catalyst for nitric oxide reduction and carbon monoxide oxidation has a copper/chromium ratio of 2/1. The apparent activation energy for the carbon monoxide oxidation over carbon supported copper-chromium catalysts is 77 kJ/mol, suggesting that the Cu---O bond rupture is the rate-limiting process. The reduction of nitric oxide takes place at higher temperatures. Since all catalysts have a low selectivity for molecular nitrogen formation at lower temperatures, the dissociation of nitric oxide is probably rate determining, resulting in a slightly reduced catalyst system. In an excess of carbon monoxide the reaction is first-order in nitric oxide and zero-order in carbon monoxide. Moisture inhibits the reaction by reversible competitive adsorption, whereas carbon dioxide does not. Oxygen completely inhibits the reduction of nitric oxide due to the more rapid reoxidation of the catalytic sites compared to nitric oxide. Therefore, the reduction of nitric oxide takes place only when all oxygen has been converted and, hence, is shifted to higher temperatures. As a possible consequence, the production of nitrous oxide is reduced. Nitric oxide and molecular oxygen react preferentially with carbon monoxide, so, in an excess of oxidizing component, gasification of the carbon support occurs at higher temperatures after carbon monoxide has been completely consumed.     

高炉煤气净化系统新技术研究与应用

济钢第二炼铁厂针对原高炉煤气净化系统处理能力不足等问题，研制了新的煤气净化系统。该系统采用单根文氏管、串联花环、丝网脱水器湿法除尘，取代原串联文氏管电除尘净化工艺。应用表明，新系统运行安全，净煤气含尘量小于10^mg／m^3，含水量小于5g／m^3，高炉风温提高90℃。     

Catalytic oxidation of sulphide ions to elementary sulphur in aqueous solutions over transition metal oxides

The catalytic activity of a wide range of transition metal oxides in oxidation of sulphide ions by air in aqueous medium was studied. Some specific features of the reaction mechanism on some of the studied oxides were considered. The transition metal oxides are promising catalysts for practical application. Some of these oxides will allow the preparation of catalysts possessing activity comparable to that of the cobalt phthalocyanine based catalysts, popular in industrial practice.     

Comparative studies on Ar and He closed-cycle MHD power plants combined with fossil fuel

Comparative studies on Ar and He closed-cycle MHD power plants combined with fossil fuel are performed. The sizes of a regenerative heat exchanger and a boiler are expected to be smaller for He than for Ar. The pressure loss of a working gas in a regenerative heat exchanger is reduced for He. The purification subsystem for He is expected to be more compact and economical than that for Ar; but a larger compressor is required for He than for Ar.     

Design consideration of photocatalytic oxidation reactors using TiO2-coated foam nickels for degrading indoor gaseous formaldehyde

In the design process of the photocatalytic oxidation (PCO) reactor using TiO₂-coated foam nickels, the optimum of catalyst film thickness, light intensity and flow velocity were considered. A model was developed to study the effect of catalyst film thickness on photocatalytic degradation of formaldehyde by a TiO₂-coated foam nickel at continuous flow mode. In this model, external mass transfer and internal molecule diffusion-reaction were considered. A first-order kinetics equation was used to account for the photocatalytic reaction. Two exponential equations were employed to describe the distribution of light intensities in foam nickels and catalyst films, respectively. Validated with experimental data, the model can be used to predict the optimal thickness of catalyst films. A method for determining appropriate light intensities was proposed and discussed. The appropriate light intensity can be obtained by giving a margin, regarded as an excess coefficient, to the light intensity calculated based on the assumption of complete use of excited electron–hole pairs. The excess coefficient needs to be determined experimentally. In addition, the optimal flow velocity of PCO reactors could be consistent with the required one by changing the windward area of foam nickels. Based on the theoretical analyses, a novel PCO reactor containing 15 parallel-connected cells was designed. Each reaction cell was composed of an UV lamp and a TiO₂-coated tubular foam nickel. The performance of the reactor was tested by degrading gaseous formaldehyde at an indoor concentration level. The results showed that the reactor had low pressure loss and good degradation capability.     

Influences of land use/cover on water quality in the upper and middle reaches of River Njoro, Kenya

Data from 10 sampling sites along the River Njoro are used to examine the contribution of nutrients from upstream land uses draining each of the sampling sites. The data also are used to assess whether both the proportion of land uses and the size of the subwatersheds account for the variability in water quality in the River Njoro watershed. Geographical Information System analysis was used to determine the spatial distribution of land‐cover types and subwatersheds contributing run‐off to the sampling sites in the River Njoro. Standard Digital Elevation Model‐based routines were used to establish the watershed area contributing run‐off to each sampling site. Water and sediment samples were collected for chemical analysis, and the nutrient levels were related to the upstream land‐use types and the size of the subwatersheds. The mid‐stream portion of the River Njoro (near Egerton University) accounts for the highest nutrient contributions. The percentage contribution is magnified by additions from industrial, human settlements and agricultural land uses around the University. There is a significant decrease in nutrient levels downstream, however, indicating natural purification as the river flows through an area of large‐scale farming with intense, well‐preserved riparian and in‐stream vegetation. Steep slopes of the land upstream of Egerton University enhance erosion and nutrient losses from those subwatersheds. Mixed small‐scale agricultural and bare lands contribute over 55% of the phosphorus load to the upper and mid‐reaches of the River Njoro. The size of the subwatershed accounts for about 53% of the variability in the soluble phosphorus in the river. The land‐use subwatershed proportions are important for characterizing and modelling water quality in the River Njoro watershed. Upland land uses are as important as near‐stream land uses. We suggest that conservation of intact riparian corridor along the river and its tributaries contributes significantly to natural purification processes and recovery of the ecological integrity of the River Njoro ecosystem.     

2,6-二甲基萘生产技术进展

概述了国外2，6-二甲基萘生产技术现状，详细介绍了ExxonMobil公司2，6-二甲基萘的工艺路线和日本神户制钢所的提纯方法，指出了实现我国2，6-二甲基萘工业化生产应注意的问题。     

横管初冷器液体喷洒系统的改进

介绍了横管初冷器液体喷洒系统存在的问题，改进方法及效果。