干扰条件下的“北斗”信号解扩重构DOA估计

在干扰条件下，卫星导航抗干扰波束形成算法往往需要卫星信号波达方向（Direction-of-Arrival，DOA）的先验信息。但当存在低信噪比信号或主动干扰源时，常规的DOA估计算法性能急剧下降甚至失效。针对此问题，提出了一种被干扰信号压制的低信噪比“北斗”信号的DOA估计算法。该算法首先通过对接收信号进行子空间投影抑制干扰信号，然后对抑制干扰后的信号进行解扩重构处理，最后通过多重信号分类算法完成对“北斗”信号的DOA估计。仿真结果表明，在干扰信号干信比80 dB条件下，“北斗”信号DOA估计误差在5°以内，为下一步进行波束形成计算提供了高精度的入射角信息。     

一种改进的新三步搜索算法

在对三步法工作原理进行研究的基础上提出了新三步搜索算法（NITSS）。该方法充分利用视频序列运动矢量概率分布上的中心偏置特性．在三步搜索算法的基础上引入了十字型分布的4个点构成搜索点群。实验结果表明。新三步搜索算法解决了三步法的小运动估计效果较差问题．提高了搜索精度，保持了三步法的高效率。     

卫星电视上行站信号自动监测系统

每个卫星电视上行站都必须对卫星转发器上的电视信号进行监测,才能及时发现卫星电视上行信号的异常变化,准确处理异常突发干扰。为实现自动、连续、实时监测,就需要建立卫星电视上行站射频信号自动监测系统。文章详细介绍了一个自动监测系统的设计及实现。     

Sequential Spectrum Analysis of the Sideband Components of Digital Amplitude-Modulated Signals

It is shown that, for the spectrum analysis of digital quasi-periodic signals, one must use a procedure based on approximating the sequence of data readouts by a first-order trigonometric polynomial with a varying frequency of its harmonic functions.     

基于USB总线的虚拟频谱分析仪设计

文章详细介绍了基于USB总线的虚拟频谱分析仪的设计过程。该仪器使用嵌入式混合处理器MC56F8323来实现动态信号的实时采集、频谱分析和数字滤波等功能。处理结果由USB2．0接口芯片CY7C68013上传至PC机．以完成数据显示、存储、绘制图形等功能。其中，CY7C68013工作于Slave FIFO模式，以实现与MC56F8323间的数据传输。该系统可同时对两路动态信号进行实时谱分析，每路采样频率高选500kHz。     

Accurate estimation of capacities and cross-traffic of all links in a path using ICMP timestamps

The estimation of the link capacity and its available bandwidth in an end-to-end path is crucial for network management, admission control and flow control for adaptive applications. This paper introduces an estimation mechanism able to accurately estimate the available bandwidth of all links in an end-to-end path, through its capacity and cross-traffic estimation. The estimation procedures resort to the dispersions of packet pairs and trains using the concepts of ICMP Timestamp and Traceroute that, efficiently used together, enable the measurement of the dispersions in all links in the path. These mechanisms were evaluated through simulation experiments, where we analyzed the influence of the several network parameters on each estimation mechanism. The results show that these estimation methods are able to accurately estimate both the capacity and the cross-traffic of all links in a path with moderate length and with low overhead.     

基于矢量平均的信道估计算法

提出一种适用于DS-CDMA无线通信系统的低计算量而性能良好的信道估计算法。在DS-CDMA系统中，当接收信号经过解扩或多用户检测等时域预处理后，可以认为干扰大大减弱、期望信号在处理后的信号中占主要地位。这样，用预处理后信号相关阵的最大特征值对应的特征矢量可以很好地近似期望信号的信道矢量。但是，直接特征分解需要很大的计算量，特征跟踪计算量较低，但瞬态性能较差。本文提出一种基于相关矩阵列矢量平均的信道估计算法，该算法不需要特征分解或跟踪。仿真结果表明：新算法在降低计算量的情况下可以获得同直接特征分解方法几乎相同的性能。     

Characteristic Features of the Optimal Processing of the Results of Measurements in the Case of a Random Observation Function

An analysis is made of the characteristic features and problems of the optimal processing of the results of measurements in the case of a random observation function utilizing a nonlinear Kalman filter. A method is proposed for increasing the convergence domain of the filter with additional processing of measurements in the frequency domain.     

提取地震信号高频信息方法的若干问题

岩性油气藏勘探已成为当代油气勘探的重要组成部分,因此提取地震资料高频信息已成为一个重要研究课题。文中对分辨率、分频处理地震信号、波阻抗反演中的一些问题进行了较深入的讨论,并得出以下认识:1要提高垂向和横向分辨率,必须设法提高野外采集地震资料的频率;2地震分频处理是偏移后提高分辨率的常用方法之一,这种方法应该限定在地震波的有效频带内,而超出有效频带,可能会带来很多假像;3低频合成地震记录中高频反射系数存在不确定性。在基于模型波阻抗反演的方法中,反演结果受初始模型的影响非常大,初始模型是依据测井资料建立的,初始模型与实际情况越接近,反演效果就越好;否则,会产生模型化的现象;4在相对波阻抗数据体(相当于地震数据体)作为约束条件下的SP测井参数协克里金插值是正演过程,消除了模型化的问题,使反演结果更接近真实情况,提高了砂层真实的分辨率。     

Reconfigurable hardware implementation of a phase-correlation stereoalgorithm

This paper describes the implementation of a stereo-vision system using Field Programmable Gate Arrays (FPGAs). Reconfigurable hardware, including FPGAs, is an attractive platform for implementing vision algorithms due to its ability to exploit parallelism often found in these algorithms, and due to the speed with which applications can be developed as compared to hardware. The system outputs 8-bit, subpixel disparity estimates for 256× 360 pixel images at 30,fps. A local-weighted phase correlation algorithm for stereo disparity [Fleet, D. J.: {Int. Conf. Syst. Man Cybernetics 1:48–54 (1994)] is implemented. Despite the complexity of performing correlations on multiscale, multiorientation phase data, the system runs as much as 300 times faster in hardware than its software implementation. This paper describes the hardware platform used, the algorithm, and the issues encountered during its hardware implementation. Of particular interest is the implementation of multiscale, steerable filters, which are widely used in computer vision algorithms. Several trade-offs (reducing the number of filter orientations from three to two, using fixed-point computation, changing the location of one localized low-pass filter, and using L1 instead of L2 norms) were required to both fit the design into the available hardware and to achieve video-rate processing. Finally, results from the system are given both for synthetic data sets as well as several standard stereo-pair test images.