柠条的纤维特性及其双螺杆CMP制浆性能研究

以柠条为原料，分析了其化学组分和纤维形态，并探讨了柠条双螺杆CMP法的制浆工艺以及浆料的纤维形态和成纸的物理性能。研究结果表明：与针、阔叶木相比，柠条原料中纤维素和综纤维素质量分数较低，苯醇抽出物和热水抽出物质量分数较高，柠条纤维长度总体偏短，木质部和皮部的纤维质量平均长度分别为0.621和0.819 mm，还存在部分杂细胞。采用3.5% Na₂SO₃和1.5% NaOH常温预浸12 h、90℃汽蒸1 h后再用双螺杆挤浆机在质量分数35%下进行搓丝，并结合高浓盘磨机磨浆，所得CMP浆得率可达73%。柠条CMP浆基本保持了纤维原有的长度，质量平均长度达0.650 mm，长宽比为32.7，纤维解离较好，但分丝帚化情况不理想，含有部分纤维束和杂细胞。当加拿大游离度为300 mL时，柠条CMP浆成纸的环压强度指数和松厚度较高，分别为8.67（N·m）/g和2.56 cm³/g，抗张指数为19.6（N·m）/g，本色浆白度较高，达50%（ISO）。柠条CMP浆适合配抄瓦楞原纸等包装用纸，漂白后可配抄新闻纸和白板纸。     

V2O5/RGO/Pt nanocomposite on oxytetracycline degradation and pharmaceutical effluent detoxification

The cover image is based on the Research Article V₂O₅/RGO/Pt nanocomposite on oxytetracycline degradation and pharmaceutical effluent detoxification by Mohan, H et al., DOI: 10.1002/jctb.6238 .

     

酸性废水中As(Ⅲ)、Cu(Ⅱ)与铁粉的反应行为

在Fe-As(Ⅲ)-Cu(Ⅱ)-H₂O体系中, 研究了酸性废水中As(Ⅲ)、Cu(Ⅱ)与金属铁粉的反应行为, 考察了反应过程中As在气、液、固三相中的分配比。结果表明, As(Ⅲ)和Cu(Ⅱ)离子被Fe还原为单质As和Cu后, As、Cu进一步结合成Cu₅As₂等金属间化合物, 从而促进As(Ⅲ)沉淀反应的发生, 且无AsH3生成。在反应时间40min、铁粉过量系数1.2、溶液初始pH=0.0、温度40 ℃、Cu/As摩尔比1.0条件下, As在气、液、固三相中的分配比分别为0、20.7%和79.3%, 沉砷率为79.3%。     

催化重整装置进料/产物换热器泄漏的检测及判断

介绍了三种检测及判断催化重整装置进料/产物换热器泄漏的方法及原理,并在某工业装置上加以运用的情况.其中芳烃含量法是根据产物分离罐底物料和重整汽油芳烃含量变化来判断;转化率比较法是根据特定环烷烃的转化率来判断;示踪剂法是在原料中注入苯酚,再根据产物分离罐底物料中是否存在苯酚来判断.     

内循环好氧三相流化床处理造纸中段废水

本实验采用内循环好氧三相流化床处造纸中段废水，经过一段时间的驯化，获得了稳定的出水。CDO去除经保持在65％以上，系统对进水污染负荷的变化具有较大的承受能力。出水Cl^-的浓度有所增加，说明驯化后的微生物可能对有抽氯化物具有一定的降解作用。水气比在1／120至1／140之间可获得最好的COD去除效果。后进行絮凝处理后，出水COD降为60－80mg/L,BODo 50-60/L，色度为100－150CU，挥发性酚的质量浓度小于0．0265mg／L。     

探讨电石法PVC烟气治理方法

分析了电石法PVC生产链中电石炉烟气及电厂烟气二氧化硫的排放情况,指出利用电石炉烟气中的CO合成氨、再将合成氨用于燃煤电厂烟气的"氨法"脱硫是具有较大应用潜力的循环经济产业链。     

Sequential batch reactor for eucalypt kraft pulp effluent treatment with Trametes versicolor

BACKGROUND: A sequential batch reactor (SBR) was used for eucalypt kraft pulp effluent treatment with Trametes versicolor. A 2³ full factorial design and response surface methodology were applied to optimise the batch fermentation conditions. Effluent concentration, culture medium and inoculum age were the factors selected for this study in order to optimise the reduction of chemical oxygen demand (COD). RESULTS: The presence of Trametes Defined Medium (TDM) in the fermentation was required to obtain a significant COD reduction. Experiments in the batch reactor confirmed, in general, the predicted results of optimisation developed from Erlenmeyer batch assays. The T. versicolor culture remained active during 42 days of study in the SBR, providing approximately 80% of COD reduction. CONCLUSION: Trametes versicolor may be considered as very promising for the biological treatment of effluents from kraft pulp mills in an SBR system instead of the activated sludge mixed cultures traditionally used. Copyright © 2008 Society of Chemical Industry     

国电双鸭山发电有限公司工业废水的回收

阐述了国电双鸭山发电有限公司工业废水回收的必要性和废水排放现状.确定实现污水零排放工程的方案.计算了回收改造工程实施后的经济效益,这对保护电厂周边环境、减少环境污染有重要意义.     

An investigation into the occurrence of sewage fungus in rivers containing papermill effluents—IV. Growth in experimental channels dosed with effluents and pure compounds

Wastewaters from the manufacture of pulp and paper have given rise to problems of excessive microbial growth in rivers over a number of years. This paper is the first in a series of four articles describing research undertaken by PIRA at four U.K. paper/board mills (one integrated with pulp production) over the period 1978–1980. This first paper briefly reviews the published literature on sewage fungus growth from pulp and paper mill discharges up to 1978, but mainly describes previously unpublished work undertaken by PIRA over the period 1965–1975. This introductory paper thus provides a state-of-the-art review of methods to control sewage fungus growth from pulp and paper mill effluents prior to commencement of the research described in the following three articles.     

稻草亚铵制浆废液氧化铵解改性产物的红外分析

利用红外光谱法定性分析了经过离子交换法萃取分离后的稻草亚铵制浆废液氧化铵解改性产物的有机组分和无机组分,同时将反应原液固形物和改性产物固形物的结构谱图进行了对比,从而推测出稻草亚铵制浆废液氧化铵解反应的历程.