多区双重介质复合气藏渗流数学模型及其压力动态

四川盆地大多数气藏属于裂缝孔隙型气藏,气藏非均质性强.经典的径向均质复合试井解释模型与气藏实际情况不相符,解释结果与实际地质情况出现抵触现象.针对这种情况,建立了多区双重孔隙介质复合地层模型,求得了该模型的拉氏空间解,分析了其典型的压力动态特征,并对影响因素可能对曲线产生的影响进行了分析.     

Evaluation of a system of wind tunnels for field studies of ammonia loss from grassland through volatilisation

Rates of ammonia (NH₃) loss from a ryegrass sward measured using a system of small wind tunnels were compared with concurrent measurements made using a micrometeorological mass balance method. Measurements were made during two experiments within a circular plot (radius 10m) treated with urea at a rate of 200kgNha^?1. In the first experiment, air speed through the tunnels was adjusted as necessary to maintain a value of approximately 1ms^?1. This value differed on most occasions from the mean ambient wind speed which was measured at a height of 250mm and which ranged from 0.61 to 2.95ms^?1. Rates of loss measured using the wind tunnels differed by a factor of between two and five from those measured using the mass balance method; there was no consistent pattern in the differences between the rates of loss. The total losses of NH₃ measured during 15 days were equivalent to 49.1 and 30.2kg Nha^?1 for the mass balance and wind tunnel methods, respectively. In the second experiment, air speed through the tunnels was adjusted as necessary to maintain a value as close as possible to the mean ambient wind speed measured at a height of 250mm. Rates of NH₃ loss measured using the two methods did not differ significantly; total losses of NH₃ during 17 days were equivalent to 96.9 and 101kg Nha^?1 for the mass balance and wind tunnel methods, respectively. The difference between the findings of the two experiments could be attributed to the direct effect of air speed through the tunnels rather than to differences between ambient temperatures and those inside the tunnels. During and following periods of rain the rates of loss measured using the tunnels were up to six times greater than those observed with the mass balance method. Rates of loss measured by the two methods became similar again when the tunnels were moved following rain. The study demonstrates that enclosures can be designed and operated to provide reliable measurements of the rate of NH₃ loss from grassland. Potential applications of the two methods are discussed.     

大凌河流域典型水生植物微生物群落吸附特征试验分析

本文采用高通测序方法对大凌河流域五刺金鱼藻、格菱、狐尾藻、水蓼及芦苇5种水生植物不同季节的微生物群落进行试验分析,分析表明:藻类密度在沉水植物表层要高于浮叶植物表层,微生物群落在浮叶植物根部的结构与其表面存在明显差异。各水生植物的优势生物群落依次为变形菌、梭菌、柔膜菌、鞭脂杆菌、杆菌、疣微菌门,且各微生物群落在季节丰度上存在明显差异性。由此可见,水环境对生物群落的影响要高于植物类型。研究成果可为大凌河流域生态修复工程提供重要理论依据。     

一类非自衡对象的典型反馈型PID控制

针对一类非自衡对象,提出了一种基于典型反馈模型的PID控制器(TF-PID);采用全极点型逼近方法对被控对象的时滞环节做近似处理,并在内模控制原理的基础之上导出一种基于典型反馈模型的PID控制器参数整定策略,从而得到PID控制器的整定参数;仿真结果表明,所设计的控制方法具有更优的设定值跟踪性能和干扰抑制性能,并且实现二者分离控制。     

基于三维特征向量的非侵入式电热负荷细分算法

非侵入式负荷监测分解（NILMD）技术是当前居民用能服务深化提升和电力供需互动的重要数据获取手段,然而当前工程上应用广泛的事件驱动型NILMD技术一直无法准确细化分解电热负荷。针对这一问题,文中提出了一种基于三维特征向量的典型电热负荷细化分解算法。首先,基于有功、无功功率和电流谐波等电气负荷特征采用事件检测方法提取电热事件,在有功功率的基础上,引入运行时长、频繁启停次数等非电气负荷特征共同构建三维特征向量电器模型。然后,采用序贯覆盖法设计典型电热负荷细化分解命题学习规则和细化分解算法。最后,基于实证实验数据进行分解验证,发现4种典型电热负荷的细化分解准确率超过85%。实验结果表明,文中所提典型电热负荷细化分解算法有效地提高了4种典型电热负荷分解的准确率。     

Phosphorus fractions and adsorption characteristics in grassland soils of varied soil phosphorus status

Characterization of phosphorus (P) in soils is important both agronomically and environmentally, although the outcome may depend on the technique applied. Consequently, we evaluated fractionation and adsorption, individually and jointly, and relevant ancillary soil attributes, to determine the dominant functional characteristics of soil P in 32 fertilized temperate grassland Inceptisols classified by eight soil series, and by two soil-P index and parent material groups. Residual P was low (30.7%) and organic P (Po) prominent, 42.0% vs. 17.5% for equivalent soils in unfertilized natural ecosystems. Labile fractions comprised 6.8% inorganic P (Pi) and 9.1% Po. The proportional increase in high vs. low index soils (Morgan P > 6.0 mg l⁻¹ vs. ≤ 6.0 mg l⁻¹) was higher for Pi, and highest for labile and moderately labile fractions. Only moderately labile Pi and Po differed significantly between soils of limestone and non-limestone origin. Oxalate extractable Fe (Fe_ox) and buffering (EBC) were higher in the latter. The equilibrium P concentration (EPC) was substantially higher in the high index group, and EBC and binding energy (k) substantially lower, with no significant difference in sorption maximum (Pmax). EBC equated with weak to strong buffering in different soil series, and conformed better than k to ancillary attributes. Pmax correlated in order Al_ox > clay > OC > Fe_ox, and more broadly reflected sorption attributes than oxalate-based sorption capacity (PSC). Principal component (PC) analysis showed consistent differentiation of P fractions, mostly labile and moderately labile, in PC 1 vs. adsorption and ancillary attributes in PC 2. However, scatterplots of PC scores showed that adsorption characteristics provided better functional differentiation than P fractions for distinguishing individual soil series, which may have implications in selection and interpretation of extractants not only for environmental but also for agronomic soil-tests.     

“典型性训练法”与服装设计专业教学中课程整体设计的关系

文章以整体教学目标为核心,原创＂典型性训练法＂,以教学目标中某个具体问题或项目作为切入点,将各个不同的项目模块由浅入深、逐步分解,再回到服装设计整体教学中。解决的教学问题为：探索从教学过程中的教师、课程与学生三要素入手,推进服装设计教学改革与教学建设,精心设计整个专业、整门课程、精心设计每节课,以＂一体化＂课程（整体设计）与原创＂典型性训练（单元设计）＂互融共进的教学方法为手段,带动＂任务驱动型合作式（师生共同完成）、实践型项目化、研究型自主学习＂等教学方式改革,将创新型教学方式转变作为服装设计专业建设的重点,使学生具有＂系统的应用知识和持续的发展能力＂,以提高职业人才培养质量。     

职业教育学习领域课程及课程开发

职业教育工学结合的学习领域课程开发,应在明确综合职业能力培养目标的基础上,通过基于工作过程职业资格研究,特别是实践专家研讨会,提炼出某一职业（专业）的典型工作任务,从而确定学习领域课程,设计学习情境,并采用行动导向的教学方案.     

典型平差方法的比较研究

通过对几种典型平差方法的计算过程、算法效率、算法精度进行对比研究,表明：条件平差方法是既简单又高效的平差方法;4种平差方法的区别主要在于所选未知数的多少,参数直接决定所采用的函数模型;4种平差方法所选择的参数不同,平差精度接近,均在±2.0 mm左右.     

基于中位数众数理论的Tennant法改进与应用

在河流生态径流计算中Tennant法应用比较广泛,但其多年平均流量的确定一直是该方法应用的一个难点,以往使用的平均数有时并不能准确反映总体分布的集中趋势,针对这一问题,通过研究实测数据的统计特性,引入中位数及众数理论,对原Tennant法进行改进,有效的去除了极端数据对统计规律的影响,找出了典型流量过程。将其应用在滦河下游生态径流计算中,通过新老方法的比较,认为采用改进后的计算方法得到的结果更加科学合理。该方法具有原理简单、计算过程“透明”等特点,对河流生态环境研究和水资源合理利用具有指导意义。