不同段数爆破地震波的反应谱分析

为了研究段数对反应谱特性的影响,基于某石方控制爆破工程爆破振动实测数据,对不同段数爆破振动信号进行了反应谱分析。首先,利用实测的爆破振动速度信号采用直接微分法获得了加速度信号,并利用EEMD分解对加速度信号进行低通滤波去噪处理,获得了准确清晰的加速度曲线。然后,利用精确法求得了不同段数下爆破振动信号的速度反应谱和标准速度反应谱。分析结果表明:不同段数的爆破振动质点峰值速度与速度反应谱的峰值速度并不存在对应关系,因此分段数的选择应综合考虑结构对爆破振动的动态响应。     

A design of experiments investigation into dry separation using a Knelson Concentrator

Enhanced gravity, or centrifugal, separators have revolutionised gold processing over the past decades, significantly increasing the recovery of fine (−100 μm) free gold. One of the main drawbacks of centrifugal gravity concentrators is the large volume of water required (even if it is all recycled). With water becoming an ever increasingly important “commodity”, reducing this is of importance both from an environmental and a monetary point of view. This work investigated operating a laboratory scale Knelson Concentrator with a dry feed and using air as the fluidising medium. The feed used was a synthetic mixture of tungsten and quartz, used to mimic a gold ore. The response surface method and central composite design techniques were used to design the experiments and to model the results, with the experimental variables being the bowl speed (G-Level), air fluidising pressure and the feed rate. The models corresponded well to the experimental results, indicating that for this experimental setup, the optimal conditions were a bowl G-Level of 40 G, a feed rate of 220 g/min and an air fluidising pressure of 8 psi.     

Effect of select parameters on the properties of edible film from water-soluble fish proteins in surimi wash-water

Edible film from water-soluble fish proteins were developed by casting film solution on leveled trays and effects of pH (9.5, 10.0 and 10.5), heating temperature (60, 70 and 80 °C), and heating time (10, 20 and 30 min) of the film solution on various film properties were determined using Response Surface Methodology (RSM). The impact of pH and heating temperature of film solution was more significant, overall, on the film's properties than heating time. Contour plots of tensile strength and elongation at break was highest at pH of 10.0 at 70 °C (2.75-3.02 MPa) but low in elongation at break (6.35-9.16%), while water vapor permeability and oxygen permeability were at their lowest (58.55-65.96 g mm/m² d kPa and 351.33-624.18 cm³ μm/m² d kPa). There was a direct correlation between the films’ and proteins’ solubility on one hand, and heating temperature of film solution on the other, which reversed with change in pH of film solution. Film color was darker and more yellowish with increase in the pH of film solution.     

基于VXI总线的超宽带线性调频信号源的设计

主要介绍了VXI总线C尺寸超宽带线性调频信号源的设计方法，重点描述了利用现场可编程逻辑器件FPAG和DSP设计VXI总线接口电路，以及数字波形存储直读技术在线性调频信号源中的应用。     

中低速率语音波形编码

提出了一种波形编码的新方法，阐述了其编码原理。该编码算法简单，恢复的语音质量较好。由于利用了矢量量化技术，所以该编码速率较低。     

一种具有带孔补偿过滤器的γ剂量计的能响补偿计算

对在低能区有过高响应的γ辐射剂量计可采用带孔补偿过滤器进行能响补偿。本文介绍了对这类补偿过滤器选择最佳补偿参数(材料厚度和孔隙率)的近似求解方法;并对 CaSO:Tm 热释光剂量计用此方法作了实例计算。文中还计算了自制带有鼠笼结构的这类补偿过滤器的 CaSO:,Tm热释光剂量计对照射量的能量响应,与实测结果比较,各能量点响应的最大相差为10%。     

Neural network systems to reproduce crash behavior of structural components

The use of neural networks as global approximation tool in crashworthiness problems is here investigated. Neural networks are not only asked to return some meaningful indices of the structural behavior but also to reproduce load-time curves during crash phenomena. To contain the number of examples required for the training process, parallel subsystems of small neural networks are designed. Design points for the training process are obtained by explicit finite element analyses performed by PAMCRASH. The settlement of the points in the design domain is defined using a maximum distance concept. The procedure is applied to different typical absorption structures made of aluminum alloy: riveted tubes, honeycomb structures, longitudinal keel beam and intersection elements of helicopter subfloors.     

Effect of strain waveform on creep-fatigue life for Sn–8Zn–3Bi solder

This paper describes the creep‐fatigue life of Sn–8Zn–3Bi under push–pull loading. Creep‐fatigue tests were carried out using Sn–8Zn–3Bi specimens in fast–fast, fast–slow, slow–fast, slow–slow and hold–time strain waveforms. Creep‐fatigue lives in the slow–slow and hold‐time waveforms showed a small reduction from the fast–fast lives but those in the slow–fast and fast–slow waveforms showed a significant reduction from the fast–fast lives. Conventional creep‐fatigue life prediction methods were applied to the experimental data and the applicability of the methods was discussed. Creep‐fatigue characteristics of Sn–8Zn–3Bi were compared with those of Sn–3.5Ag and Sn–37Pb.     

发射机脉冲调制器的探讨

针对雷达发射机调试实践中存在的调制器脉冲波形问题，对磁控管发射机常采用的刚性调制器脉冲波形影响雷达性能及发射机可靠性的情况进行了分析与探讨，并结合实际，提出了调制器脉冲波形的改善途径及解决办法。     

TBM地区低孔渗高产气储层预测

 本文从TBM地区目的层的地质和地球物理特征分析出发，以三维地震资料为基础，综合利用人工和神经网络波形分类等定性储层预测方法和利用反演及敏感地震属性分析，对TBM地区低孔渗砂岩分布区开展了砂体展布特征分析和天然气高产区预测研究。根据研究结果部署了10口钻井，已完钻的4口井中有3口获得高产气流（其中DK27井日产天然气36.8×10⁴m³）。值得指出的是，目前所用的预测方法还不能预测厚度小于6m的单砂层或砂层组构成的储层。