轻质滤料滤池的试验与研究

轻质滤料滤池是以比水密度略小的滤料为滤床的滤池，通过以净水厂的原水和污水处理厂的二级处理出水为过滤试验对象，所取得的结果表明：下向流轻质滤料滤池对浊度和悬浮固体（SS）的去除率分别可以达到80％和45％，而滤床的水头损失不超过15cm。因此轻质滤料滤池可以以预过滤的形式配置在过滤处理的净水和污水的处理工艺中。     

采用纯化学物质校准仪器测定钛合金中碳量

采用纯化学物质对高频加热－红外检测碳硫仪校准，对钛合金中的碳量进行测定。     

有水气藏开发早期可采储量的评价方法

有水气藏是天然气藏中的一个基本气藏类型，其采收率受多种因素的影响，如地面集输压力、井筒混合气水流动的液柱压力和储层物性等，目前普遍采用经验取值、物质平衡和气藏数值模拟等方法进行研究，但由于受开发评价阶段试采资料偏少和气藏数值模拟无法模拟井筒流动等因素的影响，早期采收率计算往往偏差较大，针对这些问题，从气田开发一体化的特点出发，提出了一种全面考虑地层→井筒→地面流动条件下，有水气藏（含凝析有水气藏）发废弃压力的计算方法，发展了利用物质平衡早期预测有水气藏采收率的理论，方法可靠、适用性强，能够推广应用。     

An adaptive tracking problem for a family of retarded time-delay plants

Most of the existing switching control techniques are developed specifically for finite-dimensional linear time-invariant (LTI) systems. In many practical applications, however, it is essential to take time delay into consideration in the modelling as the control system can be highly sensitive to delay. In this paper, a multi-model switching control algorithm is proposed for retarded time-delay systems. It is assumed that the plant is represented by a family of known multi-input multi-output, observable, LTI models with multiple delays in the states, and that corresponding to each model in the known family, there exists a high-performance finite-dimensional LTI controller. In addition, it is supposed that a bound on the magnitude of the external inputs and disturbances is available. It is then shown that the proposed switching controller can stabilize the uncertain system, and that under some mild conditions, output tracking can be achieved in the given problem setting. Copyright © 2007 John Wiley & Sons, Ltd.     

铁液洁净度对凝固热力学参数的影响

为了给高洁净钢连铸细晶技术提供相关理论依据，在高温钼丝炉中通过对电解纯铁加金属铝和硅脱氧，获得不同铁液洁净度的试样。利用差热分析法测定了试样在相同冷却速度下的过冷度。利用凝固过程热力学理论研究了铁液洁净度与过冷度、凝固热力学驱动力、形核功和临界晶核半径等的关系。结果表明：随着铁液洁净度的提高，铁液凝固时的过冷度增大，形核所需的凝固热力学驱动力变大，非均质形核功和临界晶核半径减小。     

超高纯铜的制备方法和应用

简要介绍了超高纯铜(UHPC)的几种精炼方法，以及它在工业方面的应用。并对超高纯铜的研究开发趋势及应用前景进行了展望。     

Pure perceptual-based sequence learning.

Learning a sequence of target locations when the sequence is uncorrelated with a sequence of responses and target location is not the response dimension (pure perceptual-based sequence learning) was examined. Using probabilistic sequences of target locations, the author shows that such learning can be implicit, is unaffected by distance between target locations, and is mostly limited to first-order transition probabilities. Moreover, the mechanism underlying learning affords processing of information at anticipated target locations and appears to be attention based. Implications for hypotheses of implicit sequence learning are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

气相色谱在线分析变压吸附法制纯氢中的总碳

利用带镍加氢转化炉的气相色谱仪 ,在线分析变压吸附法制纯氢中的总碳。该法用变压吸附法制的纯氢作燃气 ,在检测器前端将氢气中的CO和CO2 转化为CH4,然后用氢火焰离子化检测器检测 ,直接以检测器的信号 (mV)进行定量。当氢气中总碳体积分数在 1 9～ 5 0 0 μl/L时 ,FID信号值与总碳体积分数有良好的线性关系。方法回收率为 99 90 %～ 10 1 9%,相对标准偏差 <1%。     

纯铜双层辉光离子渗钛组织形成机理及性能分析

采用双层辉光离子渗金属技术对纯铜进行了渗钛处理。用配有能谱仪(EDS)的扫描电子显微镜(SEM)、X射线衍射仪和透射电子显微镜对合金层的显微组织形貌、钛含量分布、相组成及相结构类型进行了观察与测定，对合金层的形成机理进行了探讨，并对其性能进行了对比测定。结果表明：渗钛层由合金层和扩散层组成，合金层主要由TiCu (Cu)固溶体 TiCu4构成，TiCu4为Dla型有序相，TiCu为B2型有序相，扩散层为(Cu)固溶体。渗钛处理后纯铜的表面得到显著强化。     

超纯汞生产新工艺的技术研究

本文着重介绍了超纯汞生产新工艺的基本原理的理论探讨及生产工艺过程的控制。