Enhanced photo-electrochemical activity of ZnO/Cu2S nanotube arrays photocathodes

ZnO/Cu₂S nanotube arrays are fabricated firstly by a facile and capping-agent-free method, and the photo-electrochemical performance has been studied systematically. The results show that ZnO/Cu₂S nanotube arrays achieve enhanced photo-electrochemical water splitting performance and the photocurrent densities of ZnO/Cu₂S are 7.9 times than that of ZnO at 0 V versus Ag/AgCl. The performance of the ZnO/Cu₂S nanotube arrays can be adjusted by changing the amount of Cu₂S microcrystals. The results confirm that the enhanced photo-electrochemical performance of ZnO/Cu₂S is due to the significantly improved visible light absorption, effective separation of photo-induced carriers due to the well band energy match and the formed p-n junction between ZnO and Cu₂S.     

Use of heat-moisture treated maize starch to modify the properties of wheat flour and the quality of noodles

Waxy, normal and high-amylose maize starches were subjected to heat-moisture treatment (HMT) and then added to wheat flour (WF) in different ratios (1%, 5% and 10%). The properties of blends and their cooked noodles were studied to investigate the effects of HMT starches. The incorporation of HMT starch in WF led to an increase in swelling power, peak viscosity and breakdown and to a decrease in setback, thus inhibiting retrogradation, hence enhancing resultant noodle softness. Compared to the same addition ratio of native starch to WF, HMT starch led to higher tensile strength and extensibility in resultant noodles. WF with added HMT starch had higher resistant starch than with native starch. This study showed that addition of HMT maize starch has potential to bring nutritional benefits. However, it is necessary to select the proper blending ratio and amylose content of starch to add, in consideration of its effect on noodle quality.     

刚柔结合的充电机械臂设计

针对大型运输设备上的电池充电补给任务,设计了一款刚柔结合充电机械臂.针对机械臂的柔性部分和刚性部分分别分析了关节、任务、驱动空间之间的运动映射关系,给出了两级柔性臂的解耦运动学算法,使用蒙特卡洛方法求解了机械臂的工作空间,验证了机械臂设计的合理性,并用Adams软件进行动力学仿真分析,校核了设备选型的安全性.     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.     

DNAN及TNT基熔铸炸药综合性能比较

为了对比载体炸药2,4,6-三硝基甲苯(TNT)和2,4-二硝基苯甲醚(DNAN)、以及以它们为基的熔铸炸药的综合性能,系统研究了DNAN和TNT、以及DNAN/HMX(20/80)和TNT/HMX(25/75)熔铸炸药的流变、能量、安全、以及力学等性能。结果表明:载体炸药DNAN(6.87 m Pa·s)的粘度低于TNT(9.05 mPa·s),DNAN/HMX熔铸体系的极限固含量(约80%)高于TNT/HMX熔铸体系(约75%);DNAN/HMX(20/80)和TNT/HMX(25/75)熔铸炸药的爆速分别为8336 m·s~(-1)和8452 m·s~(-1),爆压分别为31.03 GPa和31.44 GPa;在1 K·min~(-1)的慢速烤燃条件下,DNAN/HMX(20/80)和TNT/HMX(25/75)熔铸炸药的响应等级分别为燃烧反应和爆炸反应;在4.51GPa的冲击波入射压力条件下,TNT/HMX(25/75)在8～12 mm内达到完全爆轰,而DNAN/HMX(20/80)在12 mm内未能达到完全爆轰;DNAN/HMX(20/80)的抗拉和抗压强度均大于TNT/HMX(25/75)。因此可以得出结论,在能量性能基本持平的情况下,DNAN/HMX(20/80)熔铸炸药的安全及力学性能优于TNT/HMX(25/75)熔铸炸药。     

切向结构永磁同步电机磁钢径向并联组合研究

针对低速大转矩切向结构永磁同步电机中磁钢尺寸对性能的影响进行研究.提出一种"工"字形排布的磁钢径向并联组合优化方案.在保证电机磁钢轴向长度和体积不变前提下,分析磁钢磁化方向长度变化对电机性能的影响.分析表明:磁钢的磁化方向长度在一定范围内增加可降低磁钢漏磁、增大反电动势和降低转矩波动;但磁钢的磁化方向长度过度增加会大大降低电机磁通面积,使得电机反电动势不增反降.在此基础上,提出一种降低磁钢漏磁、增大反电动势和降低转矩波动的三块磁钢径向并联组合的"工"字形排布方案:近气隙侧和近隔磁槽侧磁钢槽内分别插入磁化方向长度短、径向宽度窄的磁钢以降低近气隙侧和近隔磁套侧磁钢漏磁;近气隙侧磁钢和近隔磁槽侧磁钢之间采用磁化方向长度较短的磁钢以保证磁钢磁通面积降低得不多.通过仿真实验验证所提方案的可行性.     

采用信息增益率的混合入侵检测模型设计

针对现有混合入侵检测模型仅定性选取特征而导致检测精度较低的问题，同时为了充分结合误用检测模型和异常检测模型的优势，提出一种采用信息增益率的混合入侵检测模型.首先，利用信息增益率定量地选择特征子集，最大程度地保留样本信息；其次，采用余弦时变粒子群算法确定支持向量机参数构建误用检测模型，使其更好地平衡粒子在全局和局部的搜索能力，然后，选取灰狼算法确定单类支持向量机参数构建异常检测模型，以此来提高对最优参数的搜索效率和精细程度，综合提高混合入侵检测模型对攻击的检测效果；最后，通过两种数据集进行仿真实验，验证了所提混合入侵检测模型具有较好的检测性能.     

基于心理图式的知识挖掘与创新设计——以国庆彩车设计为例

为了提高设计创新效率,本研究基于心理图式提出了国庆彩车的设计程序与方法。研究按照浅层、中层和深层的次序递进,设计心理图式划分为“造型图式”“叙事与动作图式”以及“人物和情感图式”的基本类别,并提出了综合性、时态性、差异性和集体性四类基本属性。而后结合新中国成立70周年彩车设计,对不同心理图式的应用方法和属性进行了案例分析。本文所提出的方法在设计实践中得到了实证,具有一定的实用价值。     

高碘酸盐的活化及降解水体有机污染物研究进展

根据高碘酸盐活化方式、活化机理和相关自由基种类等方面,叙述了国内外高碘酸盐高级氧化体系降解水体有机污染物方面的工作。基于氧化剂为高碘酸盐的高级氧化技术氧化能力强,能在较宽的pH范围内高效降解包括抗氧化能力极强的全氟辛酸(PFOA)在内的多种有机污染物,在水处理领域具有较好的应用潜力。依据目前的研究现状,结合实际需求,认为进行废水处理的小试或者中试、优化活化理论研究,以及明确各活性物质对有机物选择性降解的机理,是将来需要关注的问题以及研究方向。