Li influx and binding, and li/mg competition in bovine chromaffin cell suspensions as studied by li NMR and fluorescence spectroscopy

Li(+) influx by bovine chromaffin cells, obtained from bovine adrenal medulla, was studied in intact cell suspensions using (7)Li NMR spectroscopy with the shift reagent [Tm(HDOTP)](4-). The influx rate constants, k(i), were determined in the absence and in the presence of two Na(+) membrane transport inhibitors. The values obtained indicate that both voltage sensitive Na(+) channels and (Na(+)/K(+))-ATPase play an important role in Li(+) uptake by these cells. (7)Li NMR T(1) and T(2) relaxation times for intracellular Li(+) in bovine chromaffin cells provided a T(1)/T(2) ratio of 305, showing that Li(+) is highly, immobilized due to strong binding to intracellular structures. Using fluorescence spectroscopy and the Mg(2+) fluorescent probe, furaptra, the free intracellular Mg(2+) concentration in the bovine chromaffin cells incubated with 15 mM LiCl was found to increase by about mM after the intracellular Li(+) concentration reached a steady state. Therefore, once inside the cell, Li(+) is able to displace Mg(2+) from its binding sites.     

Synthesis of hyperbranched P poly(glycerol-diacid) oligomers

Novel oligomeric prepolymers were synthesized by acid-catalyzed condensation of glycerol with iminodiacetic, azelaic, or succinic acid. The prepolymers were obtained, on average, in 62% yield and were characterized by ¹³C NMR, ¹H NMR, matrix-assisted laser desorption ionization-time of flight-mass spectrometry, and gel permeation chromatography. The synthesized oligomers had an average M.W. of 1543 Daltons (average polydispersity (PD)=1.34, average degree of polymerization (DOP)=5.5). Hyperbranching was evident in the oligomers produced when using azelaic acid and succinic acid as co-monomers with glycerol, whereas the reaction between iminodiacetic acid and glycerol resulted in linear products bearing cyclic urethane structures.     

Induction of DNA-double-strand breaks by auger electrons from 99mTc complexes with DNA-binding ligands

The potential of certain Auger electron emitting nuclides for systemic radiotherapeutic applications has recently gained much attention. In particular, the ability of several nuclides, including 111In, 125I, and 123I, to induce DNA double-strand breaks (dsb), a good indicator of cytotoxicity, has been extensively studied. However, this ability has never previously been shown experimentally for 99mTc, which, besides the well-known gamma radiation that is used for diagnostic applications, also emits an average of 1.1 conversion electrons and 4 Auger or Coster-Kronig electrons per decay. Owing to the short range of Auger electrons, the radionuclide needs to be located very close to the DNA for dsb to occur. We synthesized two cationic 99mTcI-tricarbonyl complexes with pendant DNA binders, pyrene and anthraquinone. The X-ray crystal structures of the two complexes could be elucidated. Linear dichroism and UV/Vis spectroscopy revealed that the complex with pyrene intercalates DNA with a stability constant, K, of 1.1 x 10(6) M(-1), while the analogous complex with anthraquinone interacts with DNA in a groove-binding mode and has an affinity value of K=8.9 x 10(4) M(-1). We showed with phiX174 double-stranded DNA that the corresponding 99mTc complexes induce a significant amount of dsb, whereas non-DNA-binding [TcO4]- and nonradioactive Re compounds did not. These results indicate that the Auger electron emitter 99mTc can induce dsb in DNA when decaying in its direct vicinity and this implies potential for systemic radiotherapy with 99mTc complexes.     

Al ionic radius influence on molecular dynamics simulations ofγ-Al2O3

Molecular dynamics (MD) simulations of-Al₂O₃, using a pairwise additive interaction potential of Pauling's type with four different radii for aluminum atoms, were analysed in order to determine the influence of the radius on the modification of coordination numbers of A1 relative to the ideal structure, at two different temperatures of 300 and 1500 K. It is found that the best choice is the radius of penta-coordinated aluminum, reproducing structural and vibrational properties of the compound in excellent agreement with experimentally observed properties.     

Production of FAME from acid oil,a by-product of vegetable oil refining

Simple alkyl FA esters have numerous uses, including serving as biodiesel, a fuel for compression ignition (diesel) engines. The use of acid-catalyzed esterification for the synthesis of FAME from acid oil, a by-product of edible vegetable oil refining that is produced from soapstock, was investigated. Soybean acid oil contained 59.3 wt% FFA, 28.0 wt% TAG, 4.4 wt% DAG, and less than 1% MAG. Maximum esterification occurred at 65°C and 26 h reaction at a molar ratio of total FA/methanol/sulfuric acid of 1∶15∶1.5. Residual unreacted species under these conditions, as a fraction of their content in unesterified acid oil, were FFA, 6.6%; TAG, 5.8%; and DAG, 2.6%. This corresponds to estimated concentrations of FFA, 3.2%; TAG, 1.3%; and DAG, 0.2%, on a mass basis, in the ester product. In an alternative approach, the acylglycerol species in soapstock were saponified prior to acidulation. High-acid (HA) acid oil made from this saponified soapstock had an FFA content of 96.2 wt% and no detectable TAG, DAG, or MAG. Optimal esterification conditions for HA acid oil at 65°C were a mole ratio of FFA/methanol/acid of 1∶1.8∶0.17, and 14 h incubation. FAME recovery under these conditions was 89% of theoretical, and the residual unesterified FFA content was approximately 20 mg/g. This was reduced to 3.5 mg/g, below the maximum FFA level allowed for biodiesel, by washing with NaCl, NaHCO₃, and Ca(OH)₂ solutions. Alternatively, by subjecting the unwashed ester layer to a second esterification, the FFA level was reduced to less than 2 mg/g. The acid value of this material exceeded the maximum allowed for biodiesel, but was reduced to an acceptable value by a brief wash with 0.5 N NaOH.     

PORE-MOUTH POISONING OF NON-UNIFORM CATALYSTS

Impurity poisoning of a catalyst particle having a non-uniform activity distribution is analyzed. Equations that relate the position of the poison-front with time for different activity profiles are derived. It is shown that the effect of the activity distribution on the poisoning rate is apparent in the case of intraparticle-diffusion control. The performance of a non-uniform bifunctional catalyst in such conditions is also studied.     

Online FPS games: effect of router buffer and multiplexing techniques on subjective quality estimators

First Person Shooters are a genre of online games in which users demand a high interactivity, because the actions and the movements are very fast. They usually generate high rates of small packets which have to be delivered to the server within a deadline. When the traffic of a number of players shares the same link, these flows can be aggregated in order to save bandwidth. Certain multiplexing techniques are able to merge a number of packets, in a similar way to voice trunking, creating a bundle which is transmitted using a tunnel. In addition, the headers of the original packets can be compressed by means of standard algorithms. The characteristics of the buffers of the routers which deliver these bundled packets may have a strong influence on the network impairments (mainly delay, jitter and packet loss) which determine the quality of the game. A subjective quality estimator has been used in order to study the mutual influence of the buffer and multiplexing techniques. Taking into account that there exist buffers which size is measured in terms of bytes, and others measured in packets, both kinds of buffers have been tested, using different sizes. Traces from real game parties have been merged in order to obtain the traffic of 20 simultaneous players sharing the same Internet access. The delay and jitter produced by the buffer of the access router have been obtained using simulations. In general, the quality is expected to be reduced as the background traffic grows, but the results show an anomalous region in which the quality rises with the background traffic amount. Small buffers present better subjective quality results than bigger ones. When the total traffic amount gets above the available bandwidth, the buffers measured in bytes add to the packets a fixed delay, which grows with buffer size. They present a jitter peak when the offered traffic is roughly the link capacity. On the other hand, buffers which size is measured in packets add a smaller delay, but they increase packet loss for gaming traffic. The obtained results illustrate the need of knowing the characteristics of the buffer in order to make the correct decision about traffic multiplexing. As a conclusion, it would be interesting for game developers to identify the behaviour of the router buffer so as to adapt the traffic to it.     

Domain nucleation dictates overall nanostructure in composites of block copolymers and model nanorods

The detailed nanostructure of composites formed from block copolymers and nanoparticles is known to depend sensitively on the preferred morphology of the block copolymer, on the shapes of the particles, and on interactions between the two components. But it can also depend on the kinetics of self-assembly in the polymer, and there are circumstances under which the kinetics of morphologically selective domain nucleation and growth determine the overall nanostructure of the composite. To study the mechanism of morphological seeding in block-copolymer nanocomposites, we have combined cylinder phases of polystyrene-block-polyisoprene diblock (as a solution in dibutylphthalate) and poly(styrene-block-isoprene-block-styrene) triblock (as a blend with homopolystyrene) copolymers with gold nanorods of different diameters and surface treatments. Polarized optical microscopy and transmission electron microscopy on these composites demonstrate that the nanorods selectively nucleate coaxial domains of copolymer cylinders (i.e., domains of cylinders aligned along the same axis as the nanorod). These single nucleation events occur regardless of nanorod diameter and surface character, and determine the order of most of the surrounding polymer. Mesoscale modeling of the nucleation process, performed with nanorods of different diameters and with different polymer-surface interactions, illustrates the mechanism by which copolymer-dispersed nanorods with different sizes and surface chemistry can template the organization of cylindrical copolymer domains.