Involvement of sensory neurons in bone defect repair in rats

We investigated bone repair in sensory-denervated rats, compared with controls, to elucidate the involvement of sensory neurons. Nine-week-old male Wistar rats received subcutaneous injections of capsaicin to denervate sensory neurons. Rats treated with the same amount of vehicle served as controls. A standardized bone defect was created on the parietal bone. We measured the amount of repaired bone with quantitative radiographic analysis and the mRNA expressions of osteocalcin and cathepsin K with real-time polymerase chain reaction (PCR). Quantitative radiographic analysis showed that the standard deviations and coefficients of variation for the amount of repaired bone were much higher in the capsaicin-treated group than in the control group at any time point, which means that larger individual differences in the amount of repaired bone were found in capsaicin-treated rats than controls. Furthermore, radiographs showed radiolucency in pre-existing bone surrounding the standardized defect only in the capsaicin-treated group, and histological observation demonstrated some multinuclear cells corresponding to the radiolucent area. Real-time PCR indicated that there was no significant difference in the mRNA expression levels of osteocalcin and cathepsin K between the control group and the capsaicin-treated group. These results suggest that capsaicin-induced sensory denervation affects the bone defect repair.     

Specific determination of bromate in bread by ion chromatography with ICP-MS

A sensitive method for detecting bromate in bread by ion chromatography with inductively-coupled plasma mass spectrometry (IC/ICP-MS) was developed. Bromate was extracted from bread with water. The clean-up procedure included a 0.2 micron filter, a C18 cartridge for defatting, a silver cartridge to remove halogen anions, a centrifugal ultrafiltration unit to remove proteins, and a cation-exchange cartridge to remove silver ions. A 500 microL sample solution was applied to IC/ICP-MS. The detection limit and the quantitation limit of bromate in the solution were 0.3 ng/mL and 1.0 ng/mL, expressed as HBrO3, respectively, which corresponded to 2 ng/g and 5 ng/g, respectively, in bread. Recovery of bromate was about 90%, and the CV was about 2%. Based on the detection limit in solution and recovery from bread, the detection limit of bromate in bread was estimated to be 2 ng/g.     

Distribution of fatty acids in triacylglycerols and phospholipids from peas (Pisum sativum L.)

BACKGROUND: The fatty acid distribution of triacylglycerols (TAG) and major phospholipids (PL) obtained from four varieties of peas (Pisum sativum) was investigated. The total lipids extracted from the peas were separated by thin layer chromatography into seven fractions. RESULTS: The major lipid components were PL (52.2–61.3%) and TAG (31.2–40.3%), while hydrocarbons, steryl esters, free fatty acids and diacylglycerols (sn‐1,3 and sn‐1,2) were also present in minor proportions (5.6–9.2%). The main PL components isolated from the four varieties were phosphatidylcholine (42.3–49.2%), phosphatidylinositol (23.3–25.2%) and phosphatidylethanolamine (17.7–20.5%). Significant differences (P < 0.05) in fatty acid distribution were found for different pea varieties. Phosphatidylinositol was unique in that it had the highest saturated fatty acid content among the three PL. However, the principal characteristics of the fatty acid distribution in the TAG and three PL were evident among the four varieties: unsaturated fatty acids were predominantly located in the sn‐2 position while saturated fatty acids primarily occupied the sn‐1 or sn‐3 position in the oils of the peas. CONCLUSION: These results should be useful to both producers and consumers for the manufacture of pea foods in Japan. Copyright © 2007 Society of Chemical Industry     

Fuel ethanol production from sweet sorghum using repeated-batch fermentation

Ethanol was efficiently produced from three varieties of sweet sorghum using repeated-batch fermentation without pasteurization or acidification. Saccharomyces cerevisiae cells could be recycled in 16 cycles of the fermentation process with good ethanol yields. This technique would make it possible to use a broader range of sweet sorghum varieties for ethanol production.     

Spectroscopic study of lactonic rhodamine B immobilised on polytetrafluoroethylene porous film

Rhodamine B (RB) is frequently used in chemical sensors, where the sensing principle depends on its structural changes to lactone (L), zwitterion (Z), and cation (C) forms in response to the local environment. Compared to the Z- and C-forms, stabilising the L-form in matrices is difficult because of the required low environmental polarity. In this study, we report a simple and easy method to stabilise the L-form of RB on the surface of a polytetrafluoroethylene porous film (p-PTFE), in which the film is dipped in an ethanol solution containing RB and dried. This phenomenon was not observed on polyethylene film and cellulose filter paper in RB solutions. Furthermore, a chemical stability test for colourless RB/p-PTFE samples was conducted by exposing these samples to a humid environment. The test result indicated that, with an increase in the environmental humidity, the equilibrium shifted from the L-form to the Z-form of RB immobilised on the p-PTFE film.     

Operating regimes for second generation luminescent solar concentrators

In this paper, we introduce the concept of first and second generation luminescent solar concentrators. Traditional, first generation devices are characterised by their randomly oriented molecules that absorb sunlight and emit luminescence isotropically. By applying detailed balance to the absorbed and emitted photon fluxes we derive the Shockley–Queisser limit for these devices. It is found that they have inherently low efficiency due to optical losses (the well known reabsorption problem) and also that device performance is strongly affected by the areal ratio between the top and edge surfaces. This latter property makes it very difficult to achieve significant cost reductions because as the edge area is reduced (to lessen the amount of expensive photovoltaic material required for conversion), the efficiency of the system diminishes. First generation concentrators have now approached the fundamental limits which we predict here, thus to achieve a stand‐alone luminescent concentrator that enables significant cost reductions, second generation approaches are now needed. New, second generation devices are characterised by either directional emitters or photonic filters which enhance the waveguiding mechanism, allowing high efficiency and large sizes to be achieved simultaneously. Here we define the fundamental operating regime in which second generation technology must reach to surpass the limit of first generation devices. Copyright © 2011 John Wiley & Sons, Ltd.     

Fabrication and Training of 3D Conductive Polymer Networks for Neuromorphic Wetware

The human brain possesses an exceptional information processing capability owing to the 3D and dense network architecture of numerous neurons and synapses. Brain-inspired neuromorphic hardware can also benefit from 3D architectures, such as high integration of circuits and acquisition of highly complex dynamical systems. In this study, for future 3D neuromorphic engineering, 3D conductive polymer networks consisting of poly(3,4-ethylenedioxy-thiophene) doped with poly(styrene sulfonate) anions (PEDOT:PSS) are successfully and stably fabricated between multiple electrodes from scratch in precursor solution by electropolymerization. The networks efficiently emulate the 3D local connections between neighboring neurons observed in the cortex. This novel technology, which allows 3D conductive wiring only between desired electrodes, is unprecedented and has potential as an underlying technology for 3D integration. Furthermore, the experimental results also conclusively prove that conductance modification can be performed by manipulating the physical and chemical properties of 3D branch-wired conductive polymer wires, thus demonstrating for the first time the feasibility of neuromorphic wetware with enhanced biological plausibility in the subsequent post-Moore era.