Low surface energy films based on partially fluorinated isocyanates: the effects of curing temperature

Self-stratification strategy can be used to prepare films in which both bulk and surface properties can be optimized. By using this approach, only a very small quantity of fluorinated species is needed to generate a surface with low surface energy. When cross-linking is involved during film formation, we are dealing with a competition behavior between the diffusion of fluorinated species and the formation of cross-linked network. In this study low surface energy polymeric films were prepared on the basis of partially fluorinated polyisocyanates, in combination with hydroxyl-end-capped three-armed solventless liquid oligoesters and modified hyperbranched polyesters. At a fluorine concentration of only 0.5 wt.%, contact angles of water and hexadecane can reach 120° and 80°, respectively. A surface energy as low as 10–15 mN/m can be obtained upon the addition of less than 1 wt.% of fluorine in the films. It was shown, from real time ATR-FTIR and contact angle measurements, that the curing temperatures demonstrated significant effects on the cross-linking rate as well as on the wettability of the films.     

供电器可供放大器最大级数的计算

有线电视电缆网采用供电器进行集中供电，要计算一个额定容量的供电器可供放大器的最大级数，算式是很复杂的，而用VisaulFOXPRO6．0编写一个小程序，利用电脑对上述问题进行处理，就变得简单易用。     

马克法输铝管用胶结剂的研制及应用

用粘土熟料、软质粘土及复合结合剂研制的胶结剂,用于马克法铸钢输铝管系统的胶结,其使用性能和使用寿命达到或超过了进口胶结剂的水平。     

黄金矿山综合经济效益的灰色评估

本文偿试性地应用灰色系统理论中的灰色聚类评估模型,对山东省七个黄金矿山的综合经济效益进行了评价,得出了山东省黄金矿山的综合经济效益较好的合理结论。     

Traffic grooming on WDM rings using optical burst transport

A sublambda traffic-grooming scheme on wavelength-division-multiplexed (WDM) rings, which is called optical burst transport (OBT), is proposed. The network protocol and architecture allow increased flexibility to tailor the transport network behavior for efficient delivery of bursty data traffic. Using different network parameters, its performance is analyzed via simulation, and the implementation issues including the media-access-control (MAC) protocol, tunable-filter controller, and burst-mode receiver are addressed. Finally, the feasibility of the OBT with an experimental testbed built by the authors is demonstrated and a streaming-video application is used to present its overall functionality.     

短纤维增强透气性莫来石/铁(A3S2/Fe)复合材料烧结特性的研究

本文研究了A₃S₂/Fe复合材料的烧结特性、透气性和纤维增强效果,分析了烧结过程中材料宏观结构和微观组织的形成机理.实验结果表明:纤维增强A₃S₂/Fe复合材料在900～1000℃具有良好的烧结性能,烧成后表层存在一定厚度的硬化层;纤维增强效果显着.材料抗压强度达17～23MPa,相对透气系数为4.30～9.69cm3/(cm2·s·atm).已能满足实际应用的需要.     

悬浮床加氢裂化油溶性催化剂与沥青质的作用

在高压釜反应器中对添加了油溶性 Ni 催化剂(UPC-O)和水溶性 Ni 催化剂(UPC-W)的辽河稠油常压渣油(LHAR)进行了悬浮床加氢裂化实验。通过元素分析和傅里叶变换红外光谱(FTIR)分析对抑制反应生焦效果好的 UPC-O 与 LHAR 沥青质的作用进行了研究。元素分析结果显示,在 LHAR 中加入 UPC-O1000μg/g,沥青质和脱沥青质油中 Ni 含量分别出476μg/g和110μg/g 增加到7 559μg/g 和1 024μg/g,表明 UPC-O 在沥青质中有富集的趋势。FTIR 表征结果显示,UPC-O 和沥青质发生了相互作用。UPC-O 可在沥青质原位硫化为活性组分,对沥青质在悬浮床加氢裂化反应中的缩合起到好的抑制作用。     

一种简易的手工网印序号工艺法

通过一种简易的手工丝印序号工艺法,可以连续完成逐张PCB的序号印制且质量稳定。