Piston-driven laminar flow and heat transfer in a plane channel with a sudden expansion

 This paper presents a numerical study of piston-driven heat transfer and fluid flow in a plane channel containing a sudden expansion. The numerical method employed is based on a control-volume-based finite element method for incompressible flow with a staggered and moving grid and SIMPLER algorithm for pressure-velocity coupling. The numerical results show a good agreement with the experimental data reported in the literature. Results concerning time and space evolution of the thermal and flow fields are presented for different values of the expansion ratio, the initial clearance volume, and the piston velocity. Received: 20 April 2002 / Accepted: 23 January 2003     

A Method for Measuring Pulsed Amplifier Noise Using a Spectrum Analyzer

Measuring the noise generated by a pulsed RF amplifier is not a simple task [1]. One method of making this measurement converts the RF pulse to video with a phase detector and uses a spectrum analyzer to measure the noise between the lines of the pulse spectrum. The measurement includes the combined effects of timing jitter, power-supply modulation, and amplifier noise. An alternate method, described in this note, requires less test equipment by using an RF spectrum analyzer to measure the noise at a point outside the pulse spectrum. This measurement responds only to amplifier noise and is valid if the noise density is the same both inside and outside the pulse spectrum. Since this situation tends to be true of broad-band amplifiers such as TWT's and CFA's, the second method is preferable because of its relative simplicity. This note describes the procedure for measuring pulsed amplifier noise using an RF spectrum analyzer. The test setup and measurement procedure are described, as well as the conversion of the measured spectral-density ratio to an equivalent CW signal-to-noise ratio.     

Type A behavior, achievement striving, and a dysfunctional self-evaluation system.

We conducted two experiments to examine the relations among characteristics of how Type A individuals strive for achievement, including goal achievement, self-evaluation, and psychological distress. We evaluated these relations as subjects performed two sequential general information tests. Experiment 1 indicated that achievement striving associated with the Type A behavior pattern is characterized by a tendency to set personal goals in excess of performance and is associated with a low probability of achieving goals. The results of Experiment 2 indicated that the achievement strategy Type A individuals adopted was associated with low self-evaluation of their actual performance. Furthermore, a pre- and postexperiment self-report questionnaire of psychological state suggested that failure to achieve personal goals was related to increased psychological distress. The results of our study suggest that unrealistically high performance standards and failure to achieve personal goals may be a mechanism that triggers the negative psychological states and performance dissatisfaction associated with the Type A behavior pattern. Our study also supports theoretical conceptualizations that excessive achievement striving can act as a potential motivational mechanism. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

市内通信电缆绝缘电阻特殊要求的实现和措施

本文对市内通信电缆的各生产过程进行分析、研究和控制 ,从而提出了解决绝缘电阻特殊要求的方法 ,以及改进的措施。     

TiO2纳米薄膜的微结构控制

通过有机酸修饰的水基so1-gel法，分别制备了由层状、针形和球形纳米粒子构成的纳米二氧化钛薄膜，采用SEM、XRD、红外光谱进行了表征.研究发现，调节水解过程中钛酸四丁酯：醋酸的摩尔比，可以控制薄膜的微结构，并对其机理进行了分析.该方法可以应用于sol-gel法制备其他纳米薄膜过程中的材料微结构控制.     

Effects of the cryogenic cooling on the fatigue strength of the AISI 304 stainless steel ground components

For environmental considerations, the substitution of the conventionally used oil-based grinding fluids has nowadays become strongly recommended. Although several alternatives have been proposed, cryogenic cooling by liquid nitrogen is the non-polluting coolant that has been given relatively more attention because of its very low temperature. In this investigation, in order to contribute to developing this promising cooling mode, its beneficial effects on the ground surface integrity of the AISI 304 stainless steel and their consequences on the fatigue lifetime are explored. Results of this investigation show that grinding under cryogenic cooling mode generates surfaces with lower roughness, less defects, higher work hardening and less tensile residual stresses than those obtained on surfaces ground under oil-based grinding fluid. These surface enhancements result into substantial improvements in the fatigue behaviour of components ground under this cooling mode. An increasing rate of almost 15% of the endurance limit at 2 × 10⁶ cycles could be realized. SEM analyses of the fatigue fracture surfaces have shown that the fatigue cracks observed on the specimens ground under cryogenic cooling are shorter (i.e., 30-50 μm) than those generated under oil-based cooling mode (i.e., 150-200 μm). The realized improvements in the surface integrity and in the fatigue behaviour are thought to be related to the reduction of the grinding zone temperature observed under cryogenic cooling, as no significant differences between the grinding force components for both cooling modes have been observed.     

Mannitol and oligosaccharides as new criteria for determining cold tolerance in sugarcane varieties

Sugarcane can be very susceptible to damage by freezes. Freeze-deteriorated cane can cause problems in processing and sometimes leads to a factory shut-down. This study was undertaken during the 2000/2001 harvest season to assess the cold tolerance performance of six commercial sugarcane varieties and to establish new and more sensitive criteria to measure cold tolerance. Two varieties CP 70-321 and CP 79-318, with known cold tolerance, were planted in the study as controls. The other varieties included LHo 83-153, LCP 85-384, HoCP 85-845 and HoCP 91-555. Freezing temperatures occurred on 20 December 2000 when the min. field temperature was −4.4 °C, and again on 21 December, 30 December through 5 January 2001, 9–10 January and 20–21 January. The lowest field temperature recorded was −5.6 °C on 4 January. Freezing conditions prevailed for 8–15 h during each freeze incident. Stalks of all varieties were frozen to the ground following the initial freeze, with freeze cracks evident only after the 4 January freeze. For this study, samples were taken on the date of the first freeze, 20 December, and subsequently again at 7, 14, 22 and 30 days after the first freeze. Criteria used to measure overall stalk cold-tolerance included changes in pH, Brix, dextran (ASI-II method), sucrose, glucose, and fructose concentrations. Mannitol, ethanol and the oligosaccharides, palatinose, leucrose, iso-maltotriose and 1-kestose, were simultaneuously measured using IC-IPAD. Marked differences were observed in most criteria for all varieties, particularly 22 and 30 days after the first freeze. Mannitol was strongly correlated (r²=0.84) with dextran, confirming its use as an indicator for cane dextran deterioration. In comparison, ethanol was only weakly correlated (r²=0.55) with dextran and did not always predict cane dextran deterioration. Iso maltotriose was the most sensitive oligosaccharide indicator of freeze deterioration, although both leucrose and palatinose could be used to confirm whether severe dextran formation (>1500 ppm/Brix) has occurred in cane. Isomaltotriose was strongly correlated (r²=0.89) with dextran and pH (r²=−0.83); pH was also a strong indicator of both dextran (r²=−0.85) and mannitol (r²=−0.92) formation. Four of the varieties, CP 79-318, LCP 85-384, HoCP 85-845 and HoCP 91-555, were shown to be susceptible to other sources of microbial and enzymic deterioration as well as dextran deterioration from Leuconostoc bacteria, especially 30 days after the first freeze. This was indicated by increased glucose/fructose ratios, ethanol formation, changes in 1-kestose concentration, and further sucrose losses.     

The Berlekamp-Massey Algorithm revisited

We propose a slight modification of the Berlekamp-Massey Algorithm for obtaining the minimal polynomial of a given linearly recurrent sequence. Such a modification enables to explain it in a simpler way and to adapt it to lazy evaluation. partially supported by the Galois Theory and Explicit Methods in Arithmetic Project HPRN-CT-2000-00114 partially supported by the European Union funded project RAAG CT-2001-00271     

Name‐Based Autoconfiguration for Mobile Ad hoc Networks

In a mobile ad hoc network, difficulties exist in supporting address autoconfiguration and naming resolution due to the lack of centralized servers. This letter presents a novel approach, called name‐based autoconfiguration (NBA), which uses host names to determine IP addresses and provides address autoconfiguration and name resolution as a single protocol.