关于项目管理中施工进度控制的研究

阐述了项目管理中施工进度控制的地位与作用，分析了影响工程进度的因素，提出项目进度控制需做好的工作，以提高进度控制水平，确保合同工期的实现。     

Observation of atomic steps on CaCO3 crystal surface

By using scanning polarization force microscopy,the deliquescence process and the atomic steps on the cleavage surface of CaCO3 in air were studied in situ.Under an exposure to medium umidity(-57%),the sloiw step movement has been observed.     

火电机组运行优化系统的现状与展望

简单回顾了国内外在火电机组运行优化领域的研究历程，列举了目前国内外市场上针对火电机组的各种主流运行优化产品的功能特点和应用情况，分析了国外引进产品和国内自主研发产品在中国当前市场环境下各自的优势和劣势。介绍了当前运行优化系统在国内电站机组的应用现状，阐述了国内外运行优化系统在实际应用中存在的问题，并提出了相应的改进意见。对机组运行优化系统的未来发展进行了展望，指出机组运行优化系统将利用先进技术设备和信息平台，与电站管理紧密结合，在日益规范的市场中不断发展完善，为提高电站经济性发挥更大的作用。     

储层石蜡沉积预测技术研究与应用

在油田开发过程中 ,由于油藏温度、压力等条件的变化 ,高含蜡原油在近井带容易产生石蜡沉积 ,堵塞地层孔隙或裂缝 ,严重影响油田开采 ,尤其对于低渗油田 ,伤害特别严重。文中应用理想溶液理论、质量守恒和能量守恒等基本原理 ,建立更符合油田实际情况的油藏中石蜡沉积预测数学模型 ,开发一套方便实用的油藏中石蜡沉积预测软件系统FPOS1 0。在此基础上 ,应用室内实验数据和现场数据对吉林新民油田油井石蜡沉积情况进行预测和现场拟合 ,确定新民油田临界石蜡沉积半径为 2 5m ,快速、准确地为现场清防蜡措施提供理论依据。     

石油系油浆与煤系闪蒸油的焦化性能——I．热解条件的影响

通过偏光显微镜观察了石油系油浆（LH）与煤系闪蒸油（SN）焦化后所得焦块的光学结构。结果表明，在较宽条件下两种原料单独焦化均得不到取向度高的流线型结构。将两种原料以一定比例混合后先热解丙焦化所得焦块的光学结构明显好于二者混合后直接焦化所得焦块的光学结构，其中LH和SN以3：2的重量比混合后在440℃、1MPa下热解3．5h然后再在530℃、1MPa下焦化8h所得焦块为具有较高取向度的流线型结构，适合于作为针状焦的起始原料。     

~（60）Co辐照对聚四氟乙烯表面润湿性的影响

研究了具有低表面能的氟聚合物聚四氟乙烯（ＰＴＦＥ），经６０Ｃｏγ射线辐照后表面状态的变化，以及其对液体介质蒸馏水的润湿性。较详细地论述了辐照后表面粗糙度、结晶度以及表面化学基因等不同因素对ＰＴＦＥ表面润湿性的影响。通过对ＰＴＦＥ及其表面的红外、Ｘ光衍射，表面粗糙度的分析，弄清了辐照后ＰＴＦＥ表面化学基团的改变对有机氟聚合物表加的润湿性影响很大，而粗糙度和结晶度的变化对润湿性影响较小。     

6M32(51)氮氢气压缩机系统的技术改造

1 机组简介 6M32(51)-190/320-BX型氮氢气压缩机的基础件采用德国博尔格公司的专有技术,具体参数如下: 压缩介质:氮氢气,压缩级数:6级;转速:375rpm;行程:320mm,轴功率:2920kW,容积流量:190m~3/min;气量调节:回路调节,冷却填料润滑油:1.95 kg/h;重量:主机69.45t,     

Performance of trellis coded-8PSK with cochannel interference

The performance of trellis coded-8PSK in the presence of cochannel interference is analyzed and compared with the performance of uncoded QPSK. The analytical expressions are derived and supported by simulating the bit error rate performance of different TC-8PSK systems. The analytical and simulation results show that TC-8PSK is slightly more robust to cochannel interference than uncoded QPSK     

An important factor affecting synergism on coprocessing of Taiheiyo coal with Athabasca oil sand bitumen

A series of mixtures of Japanese subbituminous Taiheiyo coal and Athabasca oil sand bitumen (AOB) with various coal concentrations (0–100 wt%) was coprocessed in a 70 ml autoclave at 420°C for 1 h in the presence of H₂ (50 kg/cm² at room temperature) and sulfided Ni---Mo/Al₂O₂ catalyst. The mixture containing 2 wt% coal produced the largest amount of hexane soluble fraction (HS) and the smallest amount of benzene insoluble fraction (BI). Thus, a synergistic liquid production occurred for this mixture with 2 wt% coal by suppressing the retrogressive reactions which proceeded for pure AOB. The HS obtained from mixtures with 2–30 wt% showed higher H/C ratios and lower heteroatom contents than those obtained from pure AOB and the mixtures with more than 30 wt% coal. The amounts of transferable hydrogen contained in the mixtures were estimated using anthracene as a hydrogen acceptor. The mixtures with 2–10 wt% coal contained higher amounts of donor hydrogen than pure AOB. The HS yield from the various mixtures was correlated with the amount of donor hydrogens contained in the mixtures, except for the mixture with 10 wt% coal. Thus, the important factor which results in synergism is suggested to be the amount of donor hydrogens contained in the feed mixtures.