Metal nanocrystal memory with sol-gel derived HfO2 high-κ tunnel oxide

An all-solution processed metal-oxide-semiconductor (MOS) capacitor structure containing gold (Au) nanoparticles (NPs) within HfO₂ high-κ oxide was fabricated. The ultra-thin (~ 10 nm) HfO₂ high-κ tunnel oxide layer was prepared by sol-gel process and showed good electrical properties, which were critical to superior memory property of the MOS structure. Au NPs with particle size of about 3.3 nm were synthesized by chemical reduction method and then self-assembled onto HfO₂ tunnel oxide. Finally, a Si/HfO₂/Au NPs/HfO₂ memory structure was constructed after the substrate had been covered with a sol-gel-derived HfO₂ control oxide layer (~ 13 nm). By utilizing high-quality HfO₂ as tunnel oxide, the MOS structure containing Au NPs showed memory effect even at a low voltage of ± 3 V. Although its memory window was only 0.8 V by a swapping voltage between ± 5 V, the MOS showed desirable retention characteristics. Therefore, we have fabricated nanocrystal memory device with sol-gel derived HfO₂ high-k tunnel oxide which are attractive for low operation voltage non-volatile memory applications.     

Evaluation of friction coefficient using indentation model of Brinell hardness test for sheet metal forming

This work presents an indentation model of the Brinell hardness test, which is a rigid ball-deformable plane contact model (RB-DP model), to elucidate the sliding friction mechanism of sheet metal forming. In the proposed model, the friction force can be defined as a combination of shear (shearing effect) and plough (ploughing effect) forces. The real contact area ratio α is determined from the RBDP model under sliding condition. Moreover, the lateral contact area ratio A _c /A _r can be specified as a function of the real contact area ratio α. Based on Meyer’s law and Hertz contact problem, the maximum contact area ratio α _u , a limiting condition of the real contact area ratio α, can be described as a function of the strain hardening exponent n. Additionally, a limiting condition applies: the strain hardening exponent n must be less than 0.64 in the present model. The present friction model reveals that the friction coefficient μ _d is a function of strain hardening exponent n, the real contact area ratio α and the maximum contact area ratio α _u . The calculated friction coefficient μ _d agrees with the published experimental results.     

Identification of the protein 4.1 binding interface on glycophorin C and p55, a homologue of the Drosophila discs-large tumor suppressor protein

Protein 4.1 is the prototype of a family of proteins that include ezrin, talin, brain tumor suppressor merlin, and tyrosine phosphatases. All members of the protein 4.1 superfamily share a highly conserved N-terminal 30-kDa domain whose biological function is poorly understood. It is believed that the attachment of the cytoskeleton to the membrane may be mediated via this 30-kDa domain, a function that requires formation of multiprotein complexes at the plasma membrane. In this investigation, synthetically tagged peptides and bacterially expressed proteins were used to map the protein 4.1 binding site on human erythroid glycophorin C, a transmembrane glycoprotein, and on human erythroid p55, a palmitoylated peripheral membrane phosphoprotein. The results show that the 30-kDa domain of protein 4.1 binds to a 12-amino acid segment within the cytoplasmic domain of glycophorin C and to a positively charged, 39-amino acid motif in p55. Sequences similar to this charged motif are conserved in other members of the p55 superfamily, including the Drosophila discs-large tumor suppressor protein. Our data provide new insights into how protein 4.1, glycophorin C, p55, and their non-erythroid homologues, interact with the cytoskeleton to exert their physiological effects.     

放电等离子超快速烧结氧化铝力学性能和显微结构研究

本文介绍用和电等离子超快速烧结方法制备的氧化铝陶瓷的力学性能和显微结构特征，超快速烧结的升温速率为６００℃／ｍｉｎ，在烧结温度不保温，迅即在３ｍｉｎ内冷却至６００℃以下，与保温时间为２ｈ的无压烧结相比，可降低烧结温度和提高样品密度。力学性能研究结果表明，用放电等离子超快速烧结方法制备的纯氧化铝陶瓷的抗弯强度高达８００ＭＰａ以上，比通常氧化铝陶瓷的抗弯强度高出一倍，用ＳＥＭ研究了在不同温度下超快速烧     

Sequencing mixed-model assembly lines with genetic algorithms

This research introduces the use of an artificial-intelligence based technique, genetic algorithms (GA), to solve mixed-model assembly-line sequencing problems. This paper shows how practitioners can comfortably implement this approach to solve practical problems. A substantial example is given for which GA produces a solution in just a matter of seconds that improves upon Toyota's Goal Chasing Algorithm. The new method is then investigated on a test bed of 80 problems. Results indicate GA generates an improved sequence over Goal Chasing on 50 of the problems and also shows a performance advantage of 2% across all 80 problems using Toyota's variability of parts consumption criterion. The paper concludes that further investigation to fine tune the GA methodology is warranted. It also points out that the GA approach can readily be used by practitioners to address a variety of managerial goals concurrently, such as inventory and work load equalization.     

An economic discrete replacement policy for a shock damage model with minimal repairs

A discrete replacement model for a repairable system which is subject to shocks and minimal repairs is discussed. Such shocks can be classified, depending on its effect to the system, into two types: Type I and Type II shocks. Whenever a type II shock occurs causes the system to go into failure, such a failure is called type II failure and can be corrected by a minimal repair. A type I shock does damage to the system in the sense that it increases the failure rate by a certain amount and the failure rate also increases with age due to aging process without external shocks; furthermore, the failure occurred in this condition is called type I failure. The system is replaced at the time of the first type I failure or the n-th type Il failure, whichever occurs first. Introducing costs due to replacement and mininal repairs, the long-run expected cost per unit time is derived as a criterion of optimality and the optimal number n∗ found by minimizing that cost. It is shown that, under certain conditions, there exists a finite and unique optimal number n∗.     

Interbacterial binding among strains of pathogenic and commensal oral bacterial species

OBJECTIVE: Family resources and coping skills are important to adaptation to pediatric chronic illness. Psychological and educational interventions have been found to enhance the coping skills of children with juvenile rheumatic disease (JRD) and their families. We examined the efficacy of a 3-day family retreat as a multidisciplinary, comprehensive treatment. METHODS: Children with JRD and their caregivers completed questionnaires assessing the children's behavioral and emotional functioning, pain, strain on caregivers' work and leisure activities, and caregivers' psychological distress before and 6 months after the family retreat. Principal caregivers were both parents for 16 children, mothers only for 10 children, and an aunt for 1 child. RESULTS: Improvements were found in children's emotional functioning, strain on caregivers' work, and strain on caregivers' leisure activities. Reductions in reported pain were not consistently revealed. CONCLUSIONS: Family retreats are an efficacious, multidisciplinary approach to helping families of children with JRD cope with the disease and its manifestations. Importantly, retreats offer a comprehensive intervention package that might not be available to families on an individual basis.     

X window based group collaborative editing system

Group collaborative editing is an activity by which people geographically dispersed can edit the same document simultaneously. It makes use of computers and network communication to provide an interactive and convenient environment, so people can save much of their time and cost. We have developed a group collaborative editing system which not only allows participants to jointly view and process multimedia documents but also provides real-time interactive conversation facilities to let users feel realistic and friendly. This paper describes the concepts of group collaboration and the mechanisms of our system. It also presents the interface design strategy and the synchronization control method.     

Acute benign intracranial hypertension with spontaneous recovery (reference to 5 cases)

Infections were a major cause of death in 84% of 38 autopsied renal allograft recipients in a south Indian hospital. Pyogenic bacteria and fungi were the most common etiological agents encountered, being present in 50 and 47% of cases, respectively. Tuberculosis and hepatitis B virus infection were more prevalent and Pneumocystis carinii and cytomegalovirus disease rarer than in comparable series from non-tropical countries. 1 case each of amoebiasis, strongyloidiasis and filariasis were the parasitic infections encountered.