Cross-Layer Optimization of Dynamic Packet Assignment for Video Transmission Over IEEE 802.11e Networks

Video transmission over IEEE 802.11e wireless networks still shows poor performance for large bandwidth demand and frequently changed environments. Thus, several enhancements of IEEE 802.11e were proposed. On the other hand, big frames and simultaneous sending of adjacent frames always cause packet dropping for buffer overflow. In the past, we proposed an IEEE 802.11e enhancement named DFAA and a content aware mechanism to solve the above problems. The motivation of this paper is to find a proper way to integrate these two mechanisms. A DFAA enhancement (DFAA-E) is proposed to make up the insufficiency of content aware mechanism. Experiments results show that the combination of DFAA-E and content aware mechanism improves the video decoded quality greatly. And its performance can be further enhanced by selecting the suitable settings of certain parameters.     

Coexistence of three ferroelectric phases and enhanced piezoelectric properties in BaTiO3–CaHfO3 lead-free ceramics

Perovskite ferroelectrics possess the fascinating piezoelectric properties near a morphotropic phase boundary, attributing to a low energy barrier that the results in structural instability and easy polarization rotation. In this work, a new lead-free system of (1-x)BaTiO₃-xCaHfO₃ was designed, and characterized by a coexistence of ferroelectric rhombohedral-orthorhombic-tetragonal (R-O-T) phases. With the increase amount of CaHfO₃ (x), a stable coexistence region of three ferroelectric phases (R-O-T) exists at 0.06 ≤ x ≤ 0.08. Both large piezoelectric coefficient (d₃₃～400 pC/N), inverse piezoelectric coefficient (d₃₃^*～547 pm/V) and planar electromechanical coupling factor (k_p～58.2%) can be achieved for the composition with x = 0.08 near the coexistence of three ferroelectric phases. Our results show that the materials with the composition located at a region where the three ferroelectric R-O-T phases coexist would have the lowest energy barrier and thus greatly promote the polarization rotation, resulting in a strong piezoelectric response.     

链轨节用钢15B36Cr的开发与试制

淮钢采用90 t顶底复吹转炉-LF-RH-200 mm×200 mm连铸-连轧工艺流程试生产了2炉Φ60 mm链轨节用钢15B36Cr(/%:0.30～0.37C、0.15～0.30Si、1.20～1.50Mn、≤0.040P、≤0.0505、0.20～0.40Cr、≤0.25Ni、≤0.35Cu、≤0.06Mo、0.0005～0. 0030B)。通过加严影响淬透性化学成分,控制出钢碳≥0.08%,转炉有效挡渣和下渣检测系统控制下渣,LF炉铝粒和电石渣面脱氧,RH最低真空度处理20～30 min,结晶器电磁搅拌、末端电磁搅拌和连铸低过热度保护浇铸等工艺措施,15B36Cr钢的化学成分稳定控制在内控范围内,除了B粗以外,其他类型非金属夹杂物级别全部控制在1.0以内,淬透性控制在较窄的范围内,试制钢种关键技术指标达到客户和预期设计要求。     

苏6井区下石盒子组高分辨率层序地层学特征

以高分辨率层序地层学理论和技术方法为指导，在苏里格气田苏6井区地表露头、钻井岩心、测井、地震资料综合研究的基础上，通过基准面旋回结构、叠加样式的沉积动力学分析，将该井区下石盒子组划分为2个长期、5个中期和14个短期旋回层序；并较为详细地讨论了各期旋回层序特征；建立了以长期旋回层序界面和最大洪泛面为等时年代地层框架，以中期旋回层序为等时地层单元的高分辨率层序地层格架；通过分析，认为下石盒子组盒₈下段天然气储、盖条件最为有利；有利于储层发育的河道砂体主要出现在长、中期上升半旋回的中、下部，层序界面上相当短期旋回级别的单河道砂体是下石盒子组天然气勘探开发的主要目标。     

水泥浆失水制约下套管与井眼间隙的研究

通过对水泥浆失水规律的室内试验分析以厦对注水泥顶替过程中水泥浆失水桥堵套管与井眼间隙问题的研究，建立了顶替过程中滤失层不发生水泥浆失水而桥堵环形空间的临界失水量计算模型，提出了调配水泥浆失水性能和确定合理套管井眼间隙的具体方法，对注水泥现场施工和井身结构设计具有一定的指导意义。     

Optimal Block Design for Asynchronous Wake-Up Schedules and Its Applications in Multihop Wireless Networks

In this paper, we consider the problem of designing optimal asynchronous wake-up schedules to facilitate distributed power management and neighbor discovery in multihop wireless networks. We first formulate it as a block design problem and derive the fundamental trade-offs between wake-up latency and the average duty cycle of a node. After the theoretical foundation is laid, we then devise a neighbor discovery and schedule bookkeeping protocol that can operate on the optimal wake-up schedule derived. To demonstrate the usefulness of asynchronous wake-up, we investigate the efficiency of neighbor discovery and the application of on-demand power management, which overlays a desirable communication schedule over the wake-up schedule mandated by the asynchronous wake-up mechanism. Simulation studies demonstrate that the proposed asynchronous wake-up protocol has short discovery time which scales with the density of the network; it can accommodate various traffic characteristics and loads to achieve an energy savings that can be as high as 70 percent, while the packet delivery ratio is comparable to that without power management.     

Synthesis of amphiphilic magnetic microspheres by dispersion copolymerization of styrene and poly(ethylene oxide) macromonomer

Amphiphilic magnetic microspheres ranging in diameter from 5 to 100 µm were prepared by dispersion copolymerization of styrene and poly(ethylene oxide) vinylbenzyl (PEO‐VB) macromonomer (MPEO) in the presence of Fe₃O₄ magnetic fluid. The effects of various polymerization parameters on the average particle size were systematically investigated. The average particle size was found to increase with increasing styrene concentration and initiator concentration. It also increased with decreasing stabilizer concentration and molecular weight of MPEO. The content of the hydroxyl groups localized in the microspheres ranged from 0.01 to 0.2 mmol g^?1. © 2003 Society of Chemical Industry     

微波辅助合成3,4-二氨基苯甲酸

以对氨基苯甲酸为原料,在微波辐射下经乙酰化、硝化、水解及还原反应制得3,4-二氨基苯甲酸(Ⅰ),总收率为67．6%(未用微波辐射时为40．7%),反应时间由6 h缩短为1 h,并探讨了合成条件。在n(p- H2NC6H4COOH):n(Ac2O)=1:2,微波功率800 w的条件下,回流5 min,对乙酰胺基苯甲酸(Ⅱ)的收率为93．8%;n(Ⅱ):n(Ac2O)=1:2,使用过量乙酸酐,在冰水浴中滴完浓硝酸后,在微波功率800 W,回流3 min后,4-乙酰氨基-3-硝基苯甲酸(Ⅲ)的收率为85．3%;在微波功率800 W条件下,Ⅲ与过量的w(KOH)= 50%乙醇溶液,回流5 min,3-硝基-4-氨基苯甲酸(Ⅳ)的收率为93．1%;在Ⅳ的乙醇溶液中,在回流温度下滴加w[(NH4)2S]=9%硫化铵溶液,然后,在微波功率800 W条件下,回流5 min,可得90．8%的目标产物Ⅰ。用IR、1H NMR对化合物Ⅰ～Ⅳ进行了表征。     

结构优化分子筛的制备及其催化裂化性能Ⅱ.结构优化分子筛的催化裂化性能

利用结构优化改性前后的分子筛作为活性组元制备出一系列催化剂,并通过重油微反及ACE-Model R+固定流化床评价其催化裂化性能,并进行了比较.结果表明,采用气相超稳制备的分子筛再经稀土离子优化改性后,用其制成的催化剂的催化裂化反应的转化率显著提高,重油裂化能力明显增强,汽油中烯烃的含量大幅度降低.