Fine structure of the male accessory glands of Triatoma rubrofasciata (De Geer, 1773) (Hemiptera, Triatominae)

Male of Triatoma rubrofasciata has four elongated sac-like reproductive mesodermic accessory glands, lined by an inner single layer of secretory cells, with basal plasma membrane infolds and short apical microvilli, and externally enveloped by a thin visceral muscle layer. The secretory cells have a well-developed rough endoplasmic reticulum, Golgi complex, mitochondria, and secretory granules. In one day old adult the gland cells are poorly developed, presenting small, electron-transparent secretory granules scattered among the rough endoplasmatic reticulum, whereas in three days old adult these cells have the cisternae of the rough endoplasmatic reticulum varing size degree, filled with granular electrondense content. In five days old males the secretory granules increase in diameter, being released to the gland lumen. Therefore, there is an increase of the secretory activity according to male maturation.     

Intra- and interspecific mineral composition variability of commercial instant coffees and coffee substitutes: Contribution to mineral intake

The present paper reports the amount and estimated daily mineral intake of nine elements (Ca, Mg, K, Na, P, Fe, Mn, Cr and Ni) in commercial instant coffees and coffee substitutes (n = 49). Elements were quantified by high-resolution continuum source flame (HR-CS-FAAS) and graphite furnace (HR-CS-GFAAS) atomic absorption spectrometry, while phosphorous was evaluated by a standard vanadomolybdophosphoric acid colorimetric method.Instant coffees and coffee substitutes are rich in K, Mg and P (>100 mg/100 g dw), contain Na, Ca and Fe in moderate amounts (>1 mg/100 g), and trace levels of Cr and Ni. Among the samples analysed, plain instant coffees are richer in minerals (p < 0.001), except for Na and Cr. Blends of coffee substitutes (barley, malt, chicory and rye) with coffee (20–66%) present intermediate amounts, while lower quantities are found in substitutes without coffee, particularly in barley.From a nutritional point of view the results indicate that the mean ingestion of two instant beverages per day (total of 4 g instant powder), either with or without coffee, cannot be regarded as important sources of minerals to the human diet, although providing a supplementation of some minerals, particularly Mg and Mn in instant coffees. Additionally, and for authentication purposes, the correlations observed between some elements and the coffee percentage in the blends, with particular significance for Mg amounts, provides a potential tool for the estimation of coffee in substitute blends.     

Discovery of an Allosteric Ligand Binding Site in SMYD3 Lysine Methyltransferase

SMYD3 is a multifunctional epigenetic enzyme with lysine methyltransferase activity and various interaction partners. It is implicated in the pathophysiology of cancers but with an unclear mechanism. To discover tool compounds for clarifying its biochemistry and potential as a therapeutic target, a set of drug-like compounds was screened in a biosensor-based competition assay. Diperodon was identified as an allosteric ligand; its R and S enantiomers were isolated, and their affinities to SMYD3 were determined (K_D=42 and 84 μM, respectively). Co-crystallization revealed that both enantiomers bind to a previously unidentified allosteric site in the C-terminal protein binding domain, consistent with its weak inhibitory effect. No competition between diperodon and HSP90 (a known SMYD3 interaction partner) was observed although SMYD3–HSP90 binding was confirmed (K_D=13 μM). Diperodon clearly represents a novel starting point for the design of tool compounds interacting with a druggable allosteric site, suitable for the exploration of noncatalytic SMYD3 functions and therapeutics with new mechanisms of action.     

Photoconductivity and photoluminescence under bias in GaInNAs/GaAs MQW p-i-n structures

The low temperature photoluminescence under bias (PLb) and the photoconductivity (PC) of a p-i-n GaInNAs/GaAs multiple quantum well sample have been investigated. Under optical excitation with photons of energy greater than the GaAs bandgap, PC and PLb results show a number of step-like increases when the sample is reverse biased. The nature of these steps, which depends upon the temperature, exciting wavelength and intensity and the number of quantum wells (QWs) in the device, is explained in terms of thermionic emission and negative charge accumulation due to the low confinement of holes in GaInNAs QWs. At high temperature, thermal escape from the wells becomes much more dominant and the steps smear out.     

Electrode surface treatments in sludge electro-osmosis dewatering

The sewage sludge dewatering produced by wastewater treatment plants (WWTP) is a multifaceted process due to the presence of colloid fractions. Electro-osmosis could be a suitable technique to reduce the water content of the final sludge. Electric fields of 10, 15, and 20?V/cm have been studied for electro-osmosis tests under the pressure of a static or rotating piston, obtaining a dry solids content up to 40–45%, with respect to 25–30% obtained by mechanical methods. In order to optimize the process, the corrosion behavior and the wear of the anodic material appear to be the main critical aspects, due to the high circulating current density and the use of a rotating electrode. We compared the efficiency and the corrosion resistance of dimensionally stable anodes (DSA) with respect to bare stainless steel (AISI 304) and stainless steel coated by PVD technique with TiN, AlTiN, and DLC. Characterization of the anode surfaces by SEM and potentiodynamic tests show that DSA is the most suitable material for our application. However, efficiencies of the electro-osmosis processes have been found comparable, in terms of developed current densities and total energy consumptions, for short-test duration.     

Proteomics in the Diagnosis of Endometriosis: Opportunities and Challenges

The non‐surgical diagnosis of endometriosis is still challenging for the clinician. Ultrasonography and magnetic resonance imaging can be used to diagnose ovarian endometriotic cysts and deep infiltrating endometriosis; but their performance is poor in the diagnosis of initial stages of endometriosis. CA‐125 and other serum markers (such as CA 19‐9, serum protein PP14, interleukins, and angiogenetic factors) have been measured in women with endometriosis but they are not reliable for the diagnosis of the disease. Although several studies used proteomics technologies to identify plasmatic markers of endometriosis, the non‐invasive diagnosis of endometriosis is far from being achieved. In this issue, Manousopoulou et al. compare the integrated quantitative proteomic profile of eutopic endometrium and serum of women with endometriosis and controls. 1214 proteins are differentially expressed in the eutopic endometrium and 404 proteins in the serum of the two study groups. 21 proteins are aberrantly expressed in both eutopic endometrium and serum of women with endometriosis. More work is needed to assess if the differentially expressed proteins identified in this study can be used as clinical markers of endometriosis.     

Thermodiffusion‐Assisted Pyroelectrics—Enabling Rapid and Stable Heat and Radiation Sensing

Sensors for monitoring temperature, heat flux, and thermal radiation are essential for applications such as electronic skin. While pyroelectric and thermoelectric effects are suitable candidates as functional elements in such devices, both concepts show individual drawbacks in terms of zero equilibrium signals for pyroelectric materials and small or slow response of thermoelectric materials. Here, these drawbacks are overcome by introducing the concept of thermodiffusion‐assisted pyroelectrics, which combines and enhances the performance of pyroelectric and ionic thermoelectric materials. The presented integrated concept provides both rapid initial response upon heating and stable synergistically enhanced signals upon prolonged exposure to heat stimuli. Likewise, incorporation of plasmonic metasurfaces enables the concept to provide both rapid and stable signals for radiation‐induced heating. The performance of the concept and its working mechanism can be explained by ion–electron interactions at the interface between the pyroelectric and ionic thermoelectric materials.     

A methodology for screening of microalgae as a decision making tool for energy and green chemical process applications

The increasing interest for biotechnological use of microalgae demands a methodology for selection of species suitable to support the development of technologies based on the use of such non-conventional renewable raw material, i.e., green industrial applications. The vast and expanding collection of experimental data on both cell growth and biomass composition available in the literature can be used to reduce the cost of the experimental investigations required to support process engineering and optimization. Selecting the appropriate organism requires extracting useful information from such data, a cumbersome task since various multidisciplinary factors must be considered. This paper presents a computer-aided methodology for selecting appropriate algal species given an energy or green chemical process application employing microalgae as a renewable raw material. The approach is “system oriented”, based on biomass composition and chemical processing of the biomass downstream of the CO₂ biofixation and harvesting operations. Quantitative performance results are supported by professional process simulation. Besides comparison of a set of species performances, the proposed methodology also allows the discrimination among distinct algal compositions resulting from different growth conditions for a given species. Furthermore, three categories of screening metrics are proposed to be maximized by the decision making procedure in order to elicit the relevant information. To demonstrate the potential of the proposed methodology, a databank of both biochemical and elemental compositions of microalgal biomass was used in three green applications: Assessment of biomass heating value; production of syngas by gasification of the biomass; and production of Bio-H₂. Within the accuracy of the databank employed to illustrate the procedure, the methodology selected Botryococcus braunii and Isochrysis galbana as potential promising candidates, for the three examined applications.     

Influence of mesostasis in volcanic rocks on the alkali-aggregate reaction

Mesostasis material present in the interstices of volcanic rocks is the main cause of the alkali-aggregate reaction (AAR) in concretes made with these rock aggregates. Mesostasis often is referred to as volcanic glass, because it has amorphous features when analyzed by optical microscopy. However, this study demonstrates that mesostasis in the interstitials of volcanic rocks most often consists of micro to cryptocrystalline mineral phases of quartz, feldspars, and clays. Mesostasis has been identified as having different characteristics, and, thus, this new characterization calls for a re-evaluation of their influence on the reactivity of the volcanic rocks. The main purpose of this study is to correlate the characteristics of mesostasis with the AAR in mortar bars containing basalts and rhyolites.     

Auto-Regressive Moving Average Models on Complex-Valued Matrix Lie Groups

The present contribution aims at extending the classical scalar autoregressive moving average (ARMA) model to generate random (as well as deterministic) paths on complex-valued matrix Lie groups. The numerical properties of the developed ARMA model are studied by recurring to a tailored version of the Z-transform on Lie groups and to statistical indicators tailored to Lie groups, such as correlation functions on tangent bundles. The numerical behavior of the devised ARMA model is also illustrated by numerical simulations.