多裂纹混凝土等效断裂模型研究

根据混凝土材料断裂过程区存在尺寸效应这一特点,结合混凝土断裂韧度的尺寸效应规律,对混凝土有效裂缝扩展量进行了研究,得到反映尺寸效应规律的有效裂缝扩展量表达式,进而得到与试件尺寸相关的混凝土多裂纹等效断裂模型,使得多裂纹等效断裂模型更符合断裂过程区的尺寸效应规律。同时,通过与在实际工程中已用的其他模型的计算结果相比较,得出此模型比较可靠的结论。     

Varactor-Tuned Dual-Band Quadrature Hybrid Coupler

A tunable dual-band quadrature hybrid coupler for mobile GSM bands (900 and 1800MHz) is proposed and characterized. The structure is composed of four quarter-wavelength sections at a frequency located between the two operating frequencies and two pairs of open-ended stubs. Frequency tuning is achieved by modifying the electrical length of the open-ended stubs with varactor-diode capacitors. A dual-band tunability of 33% and 10% is obtained for the first and the second bands, respectively     

塔河油田成藏期次的地球化学示踪研究

应用油藏地球化学的方法对塔河油田的成藏期次进行了探讨。塔河油田稠油正构烷烃分布完整,但色谱基线不同程度抬升;原油非烃和沥青质碳同位素偏轻,族组成碳同位素发生倒转;原油中普遍含有25-降藿烷。这些特征表明该区油藏经历了至少两期成藏过程,早期充注原油遭受生物降解作用后又受到高成熟原油充注。塔河油田天然气为典型的油型气,成熟度较高,为成熟—过成熟阶段产物,亦显示了两期充注的特征:早期充注的为典型的原油伴生气,充注时间与后期原油的充注时间相同;晚期充注的为高温裂解气,充注方向为自东向西。因此,塔河油田至少存在着3次油气充注过程。      

Improved homogenization of Ni in sintered steels through the use of Cr-containing prealloyed powders

The homogenization of Ni in powder metal (PM) steel compacts is usually difficult even after high-temperature sintering at 1250°C. An earlier study by the authors demonstrated that this problem can be alleviated through the addition of 0.5 wt pct Cr in the form of stainless steel powders. To further improve the microstructure and mechanical properties of Ni-containing PM steels and to understand the mechanisms, an attempt was made in this study using the Fe-3Cr-0.5Mo prealloyed powder as the base material. The results showed that the distribution of the Ni additives was significantly improved. As a result, the tensile strength of the Fe-3Cr-0.5Mo-4Ni-0.5C compact sintered at 1250°C reached 1323 MPa. The elongation was higher than 1 pct. These sinter-hardened properties, which were attained using a slow furnace cooling rate, were comparable to those of the sinter-hardened alloys reported in the literature using accelerated cooling and were equivalent to those of the best quenched-and-tempered alloys registered in the Metal Powder Industries Federation (MPIF) standards. These improvements were attributed to the positive effect of Cr addition on alloy homogenization due to the reduction of the repelling effect between Ni and C, as was demonstrated through the thermodynamic analysis using the Thermo-Calc program.     

DISPERSION COMPENSATION CFBG IN100km 10Gbit／s RECIRCULATING SYSTEMS

A 10Gbit/s recirculating system is configured with Chirped Fiber Bragg Grating (CFBG) for the dispersion compensation. For the first time, the transmission distance in the loop reaches 1000km with bit error rate of 10-9. The effect of the group delay ripple of the fiber grating is also investigated in the recirculating systems, and it is shown that the transmission distance is limited to 4 cycles (4×167.1km ) in the loop with the power penalty fluctuation below 1.0dB. Thus the group delay ripple should be reduced to allow for the wavelength drift of±5GHz. At the end of this letter, the principles are given for designing long haul recirculating systems with dispersion compensation CFBG.     

DS90C363/DS90CF364 LVDS发送/接收器在数字RGB液晶屏上的应用

通过在FPD铁路上使用LVDS技术可使具有数字RGB接口的液晶显示屏的工作距离大大增加。文章通过一个具体应用环境介绍了21位LVDS发送器/接收器DS90C363/DS90CF364传输套片的主要特性、引脚功能、工作原理，同时指出了在具体设计使用时的注意事项。     

基于三电平中心削波自关分析的钢琴音准测量

论文介绍三电平中心削波自关分析法原理、这种方法应用于钢琴音准检测遇到的困难及改进的方法。由此实现的钢琴音准计算机检测系统,能够对经过人工粗调的钢琴进行音准的自动检测并以表格形式给出钢琴上各键的音准偏差值,为钢琴的音准指标提供了定量的依据。     

基于交会图和多元统计法的神经网络技术在火山岩识别中的应用

针对火山岩储层的特殊性(复杂性、离散性和随机性),应用BP神经网络技术对火山岩测井解释中岩性识别问题进行了研究。该方法的技术关键是样本集和初始权重的建立,以及模型的优选。本文提出了一种基于交会图和多元统计法的学习样本生成方法,即根据取心岩样的地球化学和岩石学研究,用交会图技术建立样本集,采用聚类分析和距离判别法确定初始权重。将研究方法应用在松辽盆地杏山地区火山岩岩性识别问题中,取得了很好的效果,岩性解释符合率高于90%。文中通过四种岩性识别处理模式的对比研究,表明赋权重处理模式为最优处理模型。在神经网络模型预测过程中,需充分利用已有的地质经验和测井曲线信息建立典型可靠的样本文件,同时考虑神经网络方法中各种因素的影响,优选模型和计算参数才能使预测结果符合实际情况。     

川东北飞仙关组碳酸盐岩气藏产能影响因素及压裂酸化新技术探讨

川东北地区飞仙关组碳酸盐岩气藏的储集层条件起好，不论直井还是水平井均可获高产工业气流，投产前的解堵酸化均可实现大幅度增产。在分析介绍该地区气藏地质特征的基础上，全面剖析了影响产能的主要因素，并对多功能深部酸化技术方案和稠化酸加砂压裂技术方案进行了具体探讨。     

腐蚀引起钻柱刺漏的机理分析及预防措施

详细分析了腐蚀引起钻柱刺漏的机理，得知：造成钻柱刺漏的主要原因是空气中的O2、地层中的硫化氢和二氧化碳、钻井液残液、钻井液中的盐类对钻柱的腐蚀和钻井液对钻柱的冲蚀。针对引起钻柱刺漏的原因，制定了去除钻井液中的O2、监测钻井液腐蚀性并加入相应的添加剂去除CO2和H2S、定期对钻杆进行检测、对存放的钻杆进行防腐处理、使用厚过渡区改进型钻杆等措施。在苏丹某区块现场实践证明，采取这些措施，由腐蚀引起的钻柱刺漏事故大大减少，在该区块的T-1井和D-1井钻进的3个月中，仅发生一次钻柱刺漏事故。