3.5代通信中链路自适应技术的研究和仿真

3.5代移动通信中的链路自适应技术使用自适应调制编码和快速混合重传技术替代了3代中使用的功率控制技术。仿真结果比较了这两种新技术与功率控制技术的性能,证明了这两个新技术显著地提高了网络平均的吞吐量。     

ANALYSIS AND PROCESSING OF LMF－COSTAS STEPPED FREQUENCY RADAR SIGNAL

Linear Modulated Frequency (LMF) Costas Stepped Frequency Radar (SFR) signal is introduced. Its ambiguity function is derived and analyzed in detail and its feasibility is validated in theory. The scheme of the proposed signal processing is also presented. The results of theoretic analysis and simulation show that, by using the proposed signal and increasing the bandwidth of the total stepped frequency, the ambiguity sidelobe is well suppressed and the range-velocity coupling in the stepped frequency radar is also greatly weakened.     

Low surface energy films based on partially fluorinated isocyanates: the effects of curing temperature

Self-stratification strategy can be used to prepare films in which both bulk and surface properties can be optimized. By using this approach, only a very small quantity of fluorinated species is needed to generate a surface with low surface energy. When cross-linking is involved during film formation, we are dealing with a competition behavior between the diffusion of fluorinated species and the formation of cross-linked network. In this study low surface energy polymeric films were prepared on the basis of partially fluorinated polyisocyanates, in combination with hydroxyl-end-capped three-armed solventless liquid oligoesters and modified hyperbranched polyesters. At a fluorine concentration of only 0.5 wt.%, contact angles of water and hexadecane can reach 120° and 80°, respectively. A surface energy as low as 10–15 mN/m can be obtained upon the addition of less than 1 wt.% of fluorine in the films. It was shown, from real time ATR-FTIR and contact angle measurements, that the curing temperatures demonstrated significant effects on the cross-linking rate as well as on the wettability of the films.     

长江口北支水道水沙特性分析

从实测资料出发,结合水流数值计算成果,对长江口北支水道的水流、泥沙和含盐度等资料进行分析,得出了北支水道的水沙特性,并分析了水沙变化与河床变化的相互关系.北支水道在1958年南通河段河势控制后,径流分流比逐年下降,并渐趋稳定于3%左右.北支水道受径流影响越来越小,主要受潮流作用.随着水沙特性的逐年变化,北支水道0 m以下槽蓄容量逐年减小,并渐趋稳定,北支上段为逐年淤积最快的区域.由此反过来影响了水沙条件的进一步变化,使北支上段平均潮差增加,北支的会潮点由崇头附近下移至青龙港附近.     

Bioprocess applications of model-based estimation techniques

The last decade has seen the development of a number of approaches for estimating those variables which are difficult to measure on-line in industrial process situations. Whilst a range of techniques is available, a common element is the use of process knowledge in the form of a system model. In the case of bioprocess systems, although a large range of models has been presented in the literature, their use in estimation schemes on an industrial scale has been limited. A number of reasons can be identified for their low level of utilisation. Of particular significance is the uncertainty which exists in quantifying system performance and the process-model mismatch which inevitably results. The level of ‘pre-defined model’ uncertainty, together with the knowledge gained during the course of the fermentation, serves to dictate estimator structure. The paper considers a range of estimation strategies and contrasts, through industrial applications, their performance characteristics and utility.     

Using thermally stimulated currents to find defective capacitors

BaTiO₃ multilayer capacitors with a nominal capacitance of 3.5nF have been carefully measured using the thermally stimulated current (TSC) technique. When a 300V polarization voltage is applied at room temperature, a new TSC peak appeared in defective sample A after it has been immersed in water. No new peak was found in good-quality sample B after a similar treatment. The accelerated life test shows that sample A hasa much shorter life than sample B in terms of insulation resistance.     

Effects of α‐form or β‐form nuclei on polymorphic crystalline morphology of poly(butylene adipate)

The effects of α‐form and β‐form nuclei on polymorphic morphology of poly(butylene adipate) (PBA) upon recrystallization from the molten state up to various T_max values were examined by differential scanning calorimetry (DSC), wide‐angle X‐ray diffraction (WAXD) and polarized light microscopy (PLM). In this study, PBA with complex melting and polymorphism behaviour was used as a model for examining different types and extents of residual nuclei. As the PBA initially containing the sole α‐crystal was brought to a molten state of various T_max, the extents of trace α‐form crystal nuclei varied and were dependent on T_max. Furthermore, it did not matter whether, initially, the PBA contained α‐ or β‐form crystals (or both) because only a single type of α‐nuclei could be left upon treatment to the molten liquid state at T_max. Therefore, only the α‐crystal in PBA had ‘memory capacity’ in the molten liquid state while the β‐crystal did not. This was so because the latter had been completely transformed into the solid state prior to being heated into a liquid. PBA crystallized before α‐nuclei could be packed into α‐crystal, regardless of the crystallization temperature (T_c). For recrystallization from molten PBA without any nuclei, the crystalline polymorphism was correspondingly influenced by T_c. Copyright © 2005 Society of Chemical Industry     

德国大型设备的出口包装

一、前言德国作为全球几大工业国之一,是世界上有名的机械电子设备出口国。这些年来大量的德国大型设备和生产线成套设备漂洋过海出口到了中国,这些设备涉及到汽车、石油、化工、钢铁、机械、电子等行业。怎样保证这些大型设备和成套设备安全抵达中国或其它国家用户所在地,是摆在德国有关生产企业与运输包装企业面前的重要课题。本文结合作者在德国汉堡出口包装有限责任公司——塞库瑞塔斯公司(Securitas)看到的情况,介绍一下有关德国大型设备出口包装的方法。     

CdSe量子点的制备与荧光特性研究

主要讨论了CdSe量子点的制备及荧光特性。CdSe量子点由化学方法制备，通过选择不同的反应时间得到不同尺度的量子点样品。用荧光方法研究了量子点样品在石英衬底和有机溶剂中的荧光特性。实验表明，这些量子点都有良好的荧光特性。还用无限深球方势阱模型分析了量子点样品的电子态，并根据荧光参数估算了量子点的尺度．各样品荧光峰具有一致的半峰宽，表明CdSe量子点的成核过程在反应开始时同时完成。     

TiO2纳米薄膜的微结构控制

通过有机酸修饰的水基so1-gel法，分别制备了由层状、针形和球形纳米粒子构成的纳米二氧化钛薄膜，采用SEM、XRD、红外光谱进行了表征.研究发现，调节水解过程中钛酸四丁酯：醋酸的摩尔比，可以控制薄膜的微结构，并对其机理进行了分析.该方法可以应用于sol-gel法制备其他纳米薄膜过程中的材料微结构控制.