Hemodynamic response to in situ latissimus dorsi muscle stimulation: implications in dynamic cardiomyoplasty

Dynamic cardiomyoplasty (DCM) involves the electrical stimulation of a pedicled latissimus dorsi muscle flap wrapped around the falling ventricle as a means of cardiac assist. To further elucidate a potential neurohumoral mechanism for improvement of cardiac output after myoplasty, we evaluated the hemodynamic effects of in situ stimulation of the latissimus dorsi muscle (in the absence of cardiomyoplasty). In seven mongrel dogs, a nerve cuff electrode (Medtronic 6901) was placed around the left thoracodorsal nerve (TDN). This was attached to a pulse generator (Medtronic, Itrel 7420), delivering a 4.0 volt, 0.19 second on, 0.81 second off, 33 Hz, 210 microsecond pulse width, cyclic bursts similar to that used in DCM. Stroke volume index (SVI) and other hemodynamic parameters as well as plasma norepinephrine (NE) levels were measured at five stages: baseline, stimulator on at 0, 2, and 5 minutes, and stimulator off at 30 minutes after. The animals were then subjected to 4 weeks of rapid pacing at 240 beats/min (Medtronic 8329) to induce heart failure, and as the rapid pacing was discontinued, measurements were repeated as above. After rapid pacing, cardiac function was significantly depressed, and NE was elevated (133 +/- 69 versus 500 +/- 353 pg/mL, p < 0.05). In the normal hearts, TDN stimulation increased SVI, heart rate, systemic pressure, and NE levels. In heart failure, however, no significant changes in cardiac function and NE levels were noted. In conclusion, our data indicate that in the normal hearts, afferent impulses from TDN stimulation alone may augment cardiac function by means of a neurohumoral effect that is not seen in severe heart failure. The implications of these findings in DCM are discussed.     

Ruthenium dye-sensitized SnO2/TiO2 coupled solar cells

The photoelectrochemical behaviors of RuL₂(NCS)₂ dye-sensitized SnO₂/TiO₂ coupled solar cell was studied and compared with TiO₂ single system. The coupled system shows higher incident photon-to-current conversion efficiency (IPCE) value than the single system. A maximum IPCE value in the coupled system with 3.5 μm-thick SnO₂ and 7 μm-thick TiO₂ attained 82.4% at 530 nm wavelength. The higher IPCE value in the coupled system is attributed to the charge separation by fast electron transfer process from the excited RuL₂(NCS)₂ dye to TiO₂ to SnO₂ in the system with different energy level.     

Natural quality two-band LPC coding of speech at 880 bit/s withframe interpolation

A novel frame interpolation technique for two-band linear predictive coding (LPC) vocoders is proposed for maintaining natural speech quality at bit rates below 1 kbit/s. Experimental results show that the speech quality of the proposed vocoder is quite natural at bit rates 880 bit/s and comparable to that of 4.8 kbit/s CELP     

Re-examination of analytical models for microwave scattering from deciduous leaves

This paper presents an examination of classical scattering models for radar cross sections of deciduous leaves, such as the generalised Rayleigh-Gans (GRG) model and the physical optics (PO) model. The PO model employs the resistive sheet approximation in this study. The validity regions of the analytical models for microwave scattering from deciduous leaves are investigated by comparison with the precise numerical results of the method of moment. It was found that the GRG and PO models extend their validity regions for estimating the scattering amplitudes as the thickness of a lossy dielectric disk decreases. The GRG and PO models can be used alternatively for computing the scattering matrices of natural deciduous leaves at microwave frequencies regardless of the size of the leaves, because of the very small thickness of the leaves (0.2-0.4 mm)     

High-gain pseudomorphic InGaAs base ballistic hot-electron device

A high-gain ballistic hot-electron device is described. The GaAs-AlGaAs heterostructure device, with a 21-mm-thick pseudomorphic In _0.12Ga_0.88As base, had a current gain of 27 at 77 K and 41 at 4.2 K. As characteristically seen in ballistic devices, transfer into the L valley limited the maximum gain. The Γ-L valley separation in the strained In_0.12Ga_0.88As was estimated to be about 380 meV     

Broadly wavelength-tunable external cavity lasers with extremely low power variation over tuning range

Tunable external-cavity lasers with low power variation over a broad tuning range are demonstrated using asymmetric multiple quantum-wells with a wide and flat gain. For a 2.8-/spl mu/m-wide ridge waveguide laser of cavity length 380 /spl mu/m, when used in a grating external cavity and with an antireflection coating on one facet of laser diode chip, the power variation of less than -1 dB is obtained over a range of 80 nm. This extremely low power variation is a direct result of the spectrally flat gain.     

Investigation into Polarization of Unloaded and Loaded Microstrip Square-Ring Antennas

The polarization characteristic of unloaded and loaded square-ring microstrip antennas is investigated. Several different loading types like single-stub, dual-stub, notch, gap and shorting-pin are considered and their effects are studied. Loading enables feeding using a 50-Omega probe. The simulation and measurement results show that the loading techniques excite a loaded TMy ₁₁ mode that is orthogonal to the unloaded TMx ₁₁ mode. This indicates that by loading the ring antenna its polarization can be switched adaptively. However, the purity of the loaded and unloaded modes depends on the loading type. For some loading types like gap and shorting-pin, the excitation of the unloaded mode seems negligible, in comparison to the loadings by stub and notch. For the stub and notch loaded antennas the unloaded mode is also present, and its excitation efficiency is frequency dependent. Thus, their polarization plane, which is due to both loaded TMy ₁₁ and unloaded TMx ₁₁ modes, also becomes frequency dependant. The results of this investigation can be useful in selecting the loading methods for high-impedance microstrip ring antennas, and control of their impedance and polarization. The knowledge of the antenna polarization is essential in communications, and its dependence on the loading type can be used as an important parameter in design of adaptive antennas and sensors.     

Simultaneous degradation of nitroaromatic compounds TNT,RDX, atrazine,and simazine by Pseudomonas putida HK‐6 in bench‐scale bioreactors

BACKGROUND: Environmental contamination by nitroaromatic compounds such as 2,4,6‐trinitrotoluene (TNT), hexahydro‐1,3,5‐trinitro‐1,3,5‐s‐triazine (RDX), atrazine, and/or simazine (TRAS) generated as waste from military and agricultural activities is a serious worldwide problem. Microbiological treatment of these compounds is an attractive method because many explosives and herbicides are biodegradable and the process can be made cost‐effective. We explored the feasibility of using cultures of Pseudomonas putida HK‐6 for simultaneous degradation of TRAS with the aim of microbial application in wastewater treatment in bench‐scale bioreactors. RESULTS: Experiments were conducted to study the effects of supplemental carbons, nitrogens, and Tween‐80 on the degradation of Ps. putida HK‐6 in media containing TRAS as target substrate(s). The most effective TRAS degradation was shown in the presence of molasses. Addition of nitrogen sources produced a delayed effect for the target substrate(s). Tween‐80 enhanced the degradation of target substrate(s). Simultaneous degradation of these compounds proceeded to completion within the given period. CONCLUSIONS: Ps. putida HK‐6 was capable of growth with TRAS, and the effects of supplements on TRAS degradation and simultaneous TRAS degradation were evaluated in bench‐scale bioreactors. The results of this study have practical applications in the processes of industrial waste stream treatment where the disposal of TRAS may be problematic. Copyright © 2008 Society of Chemical Industry     

Performance modeling and evaluation of data/voice services in wireless networks

Application-level performance is a key to the adoption and success of the CDMA 2000. To predict this performance in advance, a detailed end-to-end simulation model of a CDMA network is built to include application traffic characteristics, network architecture, network element details using the proposed simulation methodology. We assess the user-perceived application performance when a RAN and a CN adopt different transport architectures such as ATM and IP. To evaluate the user-perceived quality of voice service, we compare the end-to-end packet delay for different vocoder schemes such as G.711, G.726 (PCM), G.726 (ADPCM), and vocoder bypass scheme. By the simulation results, the vocoder bypass scenario shows 30% performance improvement over the others. We also compare the quality of voice service with and without DPS scheduling scheme. We know that DPS scheme keep the voice delay bound even if the service traffic is high. For data packet performance, HTTP v.1.1 shows better performance than that of HTTP v.1.0 due to the pipelining and TCP persistent connection. We may conclude that IP transport technology is better solution for higher FER environment since the packet overhead of IP is smaller than that of ATM for web browsing data traffic, while it shows opposite effect to the small size voice packet in RAN architecture. We show that the 3G-1X EV-DO system gives much better packet delay performance than 3G-1X RTT. The main conclusion is that end-to-end application-level performance is affected by various elements and layers of the network and thus it must be considered in all phases of the development process. Jae-Hyun Kim He received the B.S., M.S., and Ph.D. degrees, all in computer science and engineering, from Hanyang University, Ansan, Korea, in 1991, 1993, and 1996 respectively. In 1996, he was with the Communication Research Laboratory, Tokyo, Japan, as a Visiting Scholar. From April 1997 to October 1998, he was a post-doctoral fellow at the department of electrical engineering, University of California, Los Angeles. From November 1998 to February 2003, he worked as a member of technical staff in Performance Modeling and QoS management department, Bell laboratories, Lucent Technologies, Holmdel, NJ. He has been with the department of electrical engineering, Ajou University, Suwon, Korea, as an assistant professor since 2003. His research interests include QoS issues and cross layer optimization for high-speed wireless communication. Dr. Kim was the recipient of the LGIC Thesis Prize and Samsung Human-Tech Thesis Prize in 1993 and 1997, respectively. He is a member of the Korean Institute of Communication Sciences (KICS), Korea Institute of Telematics and Electronis (KITE), Korea Information Science Society (KISS), and IEEE. Hyun-Jin Lee received the B.S. degree in electrical engineering from Ajou University, Suwon, Korea, in 2004, and is working toward the M.S. degree and Ph. D. degree in electrical engineering at Ajou University. He has been awarded Samsung Human-Tech Thesis Prize in 2004. His research interests QoS, especially network optimization and wireless packet scheduling. He is a member of the KICS. Sung-Min Oh received the B.S. and M. S. degrees in electrical engineering form Ajou University, Suwon, Korea, in 2004, and is working toward the Ph. D. degree in electrical engineering at Ajou University. His research interests QoS performance analysis and 4G network. He is a member of the KICS. Sung-Hyun Cho received his B.S., M.S., and Ph.D. in computer science and engineering from Hanyang University, Korea, in 1995, 1997, and 2001, respectively. From 2001 to 2005, he has been with Samsung Advanced Institute of Technology, where he has been engaged in the design and standardization of MAC and upper layers of B3G, IEEE 802.16e, and WiBro systems. He is currently a MAC part leader in the telecommunication R&D center of Samsung Electronics. His research interests include 4G air interface design, radio resource management, cross layer design, and handoff in wireless systems.