Impulse breakdown voltages of triggered multistage vacuum gap

Several sealed-off triggered vacuum gaps are connected in series to improve hold-off voltage. The characteristics of impulse breakdown voltage of these series-connected gaps are investigated experimentally. The sum hold-off voltage of series-connected gaps decreases to a unit hold-off voltage when the maximum value of voltage division ratio across the gaps increases to unity. Self-breakdown probability of the series-connected gaps is always higher than that of a single gap under the same conditions. Hence, stage efficiency of the multistage gap decreases with increasing number of stages. Its value is 90 percent with 2-stage gap and 75 percent with 5-stage gap, respectively, under the same voltage division ratio and the same gap length (2.0 mm) in each stage. Triggered breakdown voltage of 2- or 3- stage gap is several hundred volts when all gaps are triggered simultaneously at the peak of the main impulse wave and a working voltage range is nearly 100 percent in this case. The working voltage range decreases with number of stages. Its value is 45 percent with 3-stage gap and 15 percent with 5-stage gap, respectively, when one triggered gap is fired for switching.     

Resistive superconducting transition of κ-type BEDT-TTF organic superconductors in a magnetic field

The superconducting transition of the organic compoundsκ-(BEDT-TTF)₂ X is studied by resistive measurement in a magnetic field up to 10 T applied normal to the conducting plane. For the salts withX=Cu[N(CN)₂]Br andX=CuCN[N(CN)₂] the transition shows fanshaped broadening caused by superconductivity fluctuation. For theX=Cu(NCS)₂ salt the resistivity shows a peak in the transition region in a magnetic field below 4 T.This phenomenon is suppressed in defect-reduced samples for intralayer conduction. We discuss this peak in relation to the thermal fluctuation on the Josephson junction structures in this salt.     

Stabilization of bioethanol recovery with silicone rubber‐coated ethanol‐permselective silicalite membranes by controlling the pH of acidic feed solution

In order to produce highly concentrated bioethanol by pervaporation using an ethanol‐permselective silicalite membrane, techniques to suppress adsorption of succinic acid, which is a chief by‐product of ethanol fermentation and causes the deterioration in pervaporation performance, onto the silicalite crystals was investigated. The amount adsorbed increased as the pH of the aqueous succinic acid solution decreased. The pervaporation performance also decreased with decreasing pH when the ternary mixtures of ethanol/water/succinic acid were separated. Using silicalite membranes individually coated with two types of silicone rubber, pervaporation performance was significantly improved in the pH range of 5 to 7, when compared with that of non‐coated silicalite membranes in ternary mixtures of ethanol/water/succinic acid. Moreover, when using a silicalite membrane double‐coated with the two types of silicone rubber, pervaporation performance was stabilized at lower pH values. In the separation of bioethanol by pervaporation using the double‐coated silicalite membrane, removal of accumulated substances having an ultraviolet absorption maximum at approximately 260 nm from the fermentation broth proved to be vital for efficient pervaporation. Copyright © 2005 Society of Chemical Industry     

Optimal production-inventory policy for make-to-order versus make-to-stock based on the M/Er/1 queuing model

This paper analyzes a multi-product production / inventory system where demands for each item arrive according to a Poisson process and the production time for each product has an Erlang distribution. The paper proposes an optimality condition that specifies whether each product should be produced make-to-stock or make-to-order. In the event a product should be produced make-to-stock, an approach for computing the optimal base-stock level is proposed. Numerical examples are given for illustrative purpose.     

Color registration error reduction method compensating the influence of belt thickness variation in electrophotographic process

This paper proposes a new belt drive control method for reducing a belt velocity-fluctuation that is caused by a belt thickness-variation in the circumferential direction. A belt driving system performs feedback control with a rotary encoder-output mounted on a driven roller. This proposed method correct the reference value of the feedback control for the purpose of the belt velocity regulation. The correction includes two steps. The first step acquires the encoder-output of the driven roller and calculates the rotational angular velocity-fluctuation with one cycle of the belt rotation. The second step converts from the velocity-fluctuation to the correction value of the feedback reference. The correction value cancels a detection error of the driven roller caused by the belt thickness-variation. After these steps, the belt driving system controls the belt velocity as compensating the belt velocity-fluctuation. Experimental result showed the significant fluctuation reduction on a typical tandem-engine printer.     

Solid-Phase Syntheses of Two Deacetyl-Thymosin β4 Analogues with Substitution at Position 12 and Their Effects on Impaired Blastogenic Response of T Lymphocytes of Uremic Patients

Two deacetyl-thymosin β₄ analogues containing Phe(4Br) or D-Phe(4Br) as position 12 were synthesized by the manual solid-phase method, and their immunological effects on the impaired blastogenic response of phytohemagglutinin-stimulated T lymphocytes of uremic patients with infectious diseases were studied. Bromination of the p-position of Phe¹² resulted in a marked restorative effect on the impaired blastogenic response of T lympocytes compared with that of our synthetic deacetyl-thymosin β₄ The synthetic [Phe(4Br)¹²]deacetyl-thymsin β₄ was approximately equal in potency to our synthetic [Phe(4F)¹²]deacetyl-thymosin β₄ in uremic patients, but the other analogue, [D-Phe(4Br)¹²]deacetyl-thymosin β₄, had no effect.     

Oxidation of Fe (II) in sulfuric acid solutions with dissolved molecular oxygen

The oxidation of Fe(II) with dissolved molecular oxygen was studied in sulfuric acid solutions containing 0.2 mol . dm^-3 FeSO₄ at temperatures ranging from 343 to 363 K. In solutions of sulfuric acid above 0.4 mol . dm^-3, the oxidation of Fe (II) was found to proceed through two parallel paths. In one path the reaction rate was proportional to both [Fe²⁺]² and po₂, exhibiting an activation energy of 51.6 . kJ mol^-1. In another path the reaction rate was proportional to [Fe²⁺]², [SO_4-], and po₂ with an activation energy of 144.6 kJ . mol^-1. A reaction mechanism in which the SO_4- ions play an important role was proposed for the oxidation of Fe(II). In dilute solutions of sulfuric acid below 0.4 mol . dm^-3, the rate of the oxidation reaction was found to be proportional to both [Fe(II)]² and Po₂, and was also affected by [H⁺] and [SO_2- ⁴]. The decrease in [H⁺] resulted in the increase of reaction rate. The discussion was further extended to the effect of Fe (III) on the oxidation reaction of Fe (II).     

Manipulation of Micro Solid Particles and Induced Flows in Water by Laser Irradiation

Q-switch for pulsing laser beam and Galvano scanner for rapid scanning laser beam were adapted to manipulatemicro solid particles in a water droplet.The trapping of fine particles at micron-sized diameters by a YAG lasersystem,induced flows,and the induced motion of the particles by laser beam irradiations are discussed.Particlerotations are observed by using anisotropic micro objects,and moreover the rotational rate with clockwise direc-tion is 22 r/min.The fragments of a cover glass were mixed in a water droplet,and their size and shape are un-even.The rotation of that non-spheres without scanning by the Galvano scanner is also observed in water.     

Clinical implications of chromosomal abnormalities in 401 patients with myelodysplastic syndromes: a multicentric study in Japan

It is well known that cytogenetic analysis in patients with myelodysplastic syndrome (MDS) provides information useful in determining their prognosis. Based on the chromosomal results obtained from 401 MDS patients by a multicentric study in Japan, we studied correlations between chromosomal findings and prognosis or leukemic transformation in MDS patients. Patients with complex aberrations (cytogenetic abnormalities at more than three chromosomes), of any subtype, had a poor prognosis; for example, > 60% of patients with refractory anemia (RA) showing complex aberrations died within one year, but only 11% of them developed leukemia. In patients with RA with ringed sideroblasts (RARS), > 70% of those with complex aberrations evolved into the leukemic phase and survived for less than one year, suggesting a biologic heterogeneity in RARS patients. By contrast, about 5% of patients with RA or RARS exhibiting chromosomal findings other than -7/7q-, +8, two aberrations, and complex aberrations, developed leukemia and had a favorable prognosis. Therefore, the presence of chromosome abnormalities alone in patients with RA or RARS is not a factor in predicting leukemic transformation or poor prognosis. In patients with refractory anemia with an excess of blasts (RAEB), the presence of chromosome aberrations at MDS diagnosis affected the occurrence of leukemic transformation (24% versus 43%), however, no particular difference was noted in patients with RAEB in transformation with regard to whether they had chromosome changes or not, and about 60% of them evolved into leukemia. The poor prognosis related to complex aberrations was consistently noted in all MDS subtypes or age-matched groups, indicating that this cytogenetic anomaly is an independent risk factor for a poor prognosis in MDS patients. The duration between MDS diagnosis and development of the leukemic phase and that between the latter and death were significantly shorter in patients with complex aberrations than those without this change. Although the clinical significance of certain chromosomal abnormalities differs among subtypes of MDS, a new scoring system for predicting prognosis by cytogenetic changes, in combination with hematologic parameters, was proposed.