Diffusion bonding of an aluminium-lithium alloy (AA8090) using aluminium-copper alloy interlayers

Diffusion bonds have been produced between sheets of an Al-Li-Cu-Mg-Zr alloy using aluminium-4% copper vapour deposited metallic interlayers. Microstructural changes occurred both in the parent alloy and in the bond interface after diffusion bonding cycles and post-bonding heat treatments were analysed. Different metallographic techniques (light microscopy, scanning and transmission electron microscopy) have been used. Diffusion bonding trials were carried out using the same alloy (AA8090), both in non-superplastic (T6) and superplastic conditions. Differences in their behaviours in relation to diffusion bonding were observed.     

利用FPGA快速开展新一轮设计

设计工程师面临的挑战 在今天的市场上，产品迅速上市的压力愈来愈大，但产品的使用寿命却不断缩短。产品设计稳定于12-18个月的周期不再存在，取而代之的是产品每6个月便会更新。缩短的使用寿命给OEM厂商带来更大的压力，需要更迅速及高效地把新设计推向市场。有研究指出，产品的推出若延迟4周，便会失去约14％的市场份额。     

Determination of site-specific carbon isotope ratios at natural abundance by carbon-13 nuclear magnetic resonance spectroscopy.

Site-specific natural isotope fractionation of hydrogen studied by deuterium NMR (SNIF-NMR) spectroscopy is a powerful source of information on hydrogen pathways occurring in biosyntheses in natural conditions. The potential of the carbon counterpart of this method has been investigated and compared. Three typical molecular species, ethanol, acetic acid, and vanillin, have been considered. Taking into account the requirements of quantitative 13C NMR, appropriate experimental procedures have been defined and the repeatability and reproducibility of the isotope ratio determinations have been checked in different conditions. It is shown that the carbon version of the SNIF-NMR method is capable of detecting small differences in the carbon-13 content of the ethyl fragment of ethanols from different botanical or synthetic origins. These results are in agreement with mass spectrometry determinations of the overall carbon isotope ratios. Deviations with respect to a statistical distribution of 13C have been detected in the case of acetic acid and vanillin. However, since the method is very sensitive to several kinds of systematic error, only a relative significance can be attached at present to the internal parameters directly accessible. Isotope dilution experiments have also been carried out in order to check the consistency of the results. In the present state of experimental accuracy, the 13C NMR method is of more limited potential than 2H SNIF-NMR spectroscopy. However it may provide complementary information. Moreover it is particularly efficient for detecting and quantifying adulterations that aim to mimic the overall carbon-13 content of a natural compound by adding a selectivity enriched species to a less expensive substrate from a different origin.     

Model Driven Architecture

Bei der Model Driven Architecture (MDA) bilden Modelle die zentralen Elemente des Softwareentwicklungsprozesses. Ziel ist es, plattformspezifische Modelle möglichst automatisiert aus plattformunabhängigen Modellen abzuleiten. Dadurch soll der Aufwand der Softwareentwicklung verringert und die Adaptierung an neue Technologien erleichtert werden.*Vorschläge an Prof. Dr. Frank Puppe oder Dieter Steinbauer Alle „Aktuellen Schlagwörter“ seit 1988 finden Sie unter: www.ai-wuerzburg.de/as     

A survey of the training of computer users in Swedish companies

This study concerns how user training on newly introduced computer application programs is carried out. Questionnaire data from the computer managers of 265 Swedish companies were analysed. The results show that formal training, i.e., teacher-directed group instruction, and self-studies using instruction manuals represented nearly two-thirds of all reported training forms. For the most recently introduced program, classes (group instruction) with simultaneous computer exercises was the form of formal training that was nearly always used. When formal training was given it was compulsory in over half of the cases. However, substitutes for users attending a training course were only provided by the company in very few of these cases. The implications of these findings for effective user training are discussed.     

Controlled undercooling of liquid iron in contact with ZrO2 and MgO substrates under varying oxygen partial pressures

The objective of this study is to determine the conditions under which the inclusions present in liquid steel can act as heterogeneous nucleants for solidification. In order to study the factors that define the undercooling of a given metal/oxide couple, the undercooling of a pure iron sessile droplet in contact with Al₂O₃, ZrO₂, and MgO substrates was measured under controlled oxygen partial pressures by observing droplet recalescence. The results showed that the undercooling of iron, in contact with a particular substrate, did not have a unique value, but was significantly affected by the oxygen content on the gas phase. For oxygen partial pressures between 10⁻²¹ and 10⁻¹⁹, the undercooling of iron on ZrO₂ substrates was stable and around 290 °C. In the same range of oxygen partial pressure, the undercooling of iron on MgO substrates remained below 100 °C due to the low stability of this oxide. At lower oxygen contents, substrate decomposition might be the cause for the observed drop in the undercooling of iron on ZrO₂ substrates to below 100 °C. The undercooling also decreased for increasing oxygen content as verified when the gas was changed from gettered Ar/Ar-H₂ to CO/CO₂ mixtures. The variation in undercooling was related to the wetting of the substrate by the liquid metal, where the deep undercooling observed in the ZrO₂ experiments occurred when the highest contact angle between the liquid metal and the substrate was achieved.     

IPv6 delay and loss performance evolution

Although packet delay and loss are two important parameters of the Internet performance, to the best of our knowledge, the evolution of large‐scale IPv6 delay and loss performance has previously not been studied. In this paper, we analyze more than 600 end‐to‐end IPv6 paths between about 26 testboxes of RIPE Network Coordination Centre over two years, and compare the delay and loss performance over time with their IPv4 counterparts. We present and discuss the measurement methodologies and show that IPv6 paths have a higher delay and loss than their IPv4 counterparts. The main reason for the worse performance stems from IPv6‐in‐IPv4 tunnels rather than from native IPv6 paths and such tunnels are still widely used today. Copyright © 2007 John Wiley & Sons, Ltd.     

Factor structure of the SOCRATES in a clinical sample of adolescents.

This study investigated the Stages of Change Readiness and Treatment Eagerness Scale (SOCRATES: W. R. Miller & J. S. Tonigan, 1996) in adolescents presenting for treatment of alcohol use disorder (AUD). The participants were 80 males and 43 females (mean age=16.8 years) who presented for AUD treatment (95.1% outpatient, 4.9% inpatient). Participants completed assessments at baseline and 1 year and provided information on alcohol use and related variables monthly between these 2 assessments. Principal-components and confirmatory factor analyses of the baseline SOCRATES identified 2 factors, Taking Steps and Recognition, which showed good internal consistency and concurrent and predictive evidence of validity. The results were interpreted as supporting the use of the SOCRATES with clinical samples of adolescents. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

What do we know about innovation in nanotechnology? Some propositions about an emerging field between hype and path-dependency

This contribution formulates a number of propositions about the emergence of novel nanoscience and nanotechnology (N&N). Seeking to complement recent work that aims to define a research agenda and draws on general insights from the innovation literature, this paper aims to synthesize knowledge from innovation-related studies of the N&N field. More specifically, it is suggested that N&N is often misconstrued as either a field of technology or an area of (broadly) converging technologies while evidence to date suggests rather that N&N be considered a set of inter-related and overlapping about not necessarily merging technologies. The role of instrumentation in connecting the various N&N fields is underlined. Finally, the question is raised whether change in N&N tends to be incremental rather than discontinuous, being the result of technological path-dependencies and lock-ins in industry-typical search regimes that are only slowly giving way to more boundary-crossing activities.