Numerical analysis of heat transfer due to slot jets impingement onto two cylinders with different diameters

A numerical investigation has been performed two-dimensional slot impingement onto two heated cylinders with different diameters turbulent flow conditions. Height of slot jet is taken as constant for all cases. The study is performed to see the effects of effective parameters on heat and fluid flow as jet Reynolds number (11,000 ≤ Re ≤ 20,000), diameter ratio of cylinders (0.5 ≤ D₁/D₂ ≤ 1.5) and ratio of distance between cylinders to slot jet high (L/S). Streamlines, isotherms, local and mean Nusselt numbers and Cd coefficient were obtained. These results were compared with earlier experimental and numerical works and good agreement was obtained. It is found that diameter ratios of cylinders can be a control element for heat and fluid flow.     

Effect of hydrogen addition using on-board alkaline electrolyser on SI engine emissions and combustion

In this study, an electrolyser was used to supply hydrogen to the SI engine. Firstly, the appropriate operation point for the electrolyser was determined by adjusting the amount of KOH in the electrolyte to 5%, 10%, 20% and 30% by mass, and applying 12 V, 16 V, 20 V, 24 V and 28 V voltages. Tests were first carried out with the gasoline without the use of an electrolyser, followed by operating the electrolyser at the appropriate point and sending obtained H₂ and O₂ to the engine in addition to the gasoline. The SI engine was operated between 2500 rpm and 3500 rpm engine speeds with and without hydrogen addition. Cylinder pressure, the amount of gasoline, H₂ and O₂ consumed by the engine and the emission data were collected from the test system at the aforementioned engine speeds. Furthermore, indicated engine torque, indicated specific energy consumption, specific emissions and HRR values were calculated. According to the results obtained, improvement in ISEC values was observed, and CO and THC values were improved by up to 21.3% and 86.1% respectively. Even though the dramatic increase in NO_x emissions cannot be averted, they can be controlled by equipment such as EGR three-way catalytic converter.     

Determination of industrial pollution effects on citrus honeys with chemometric approach

The aim of this study was to determine the levels of essential, trace and toxic elements, such as K, Ca, Fe, Cu, Al, Ni, Sn, Pb and Cd in citrus honeys from different regions (industrialized and nonindustrialized) of Hatay, Turkey. K, Ca, Na and Mg were the most abundant elements, with mean contents of 363.5, 256.6, 88.1 and 37.7 mg/kg, respectively. The trace element mean contents ranged between 0.032 and 15.58 mg/kg. Significant differences in Fe, Cu, Al, Ni, Sn, Pb, Cd, Co and Sr levels were observed between two different regions. The findings that Fe, Cu, Al, Ni, Sn, Pb, Cd, Co and Sr contents in citrus honeys from industrialized regions were higher than citrus honeys from non-industrialized regions indicate that the honeys were affected by industrial pollution. Chemometric methods were applied to classify honey according to mineral content. Cluster analysis showed three clusters corresponding to the three different regions.     

On the mechanics of functional asymmetry in bipedal walking

This paper uses two symmetrical models, the passive compass-gait biped and a five-link 3-D biped, to computationally investigate the cause and function of gait asymmetry. We show that for a range of slope angles during passive 2-D walking and mass distributions during controlled 3-D walking, these models have asymmetric walking patterns between the left and right legs due to the phenomenon of spontaneous symmetry-breaking. In both cases a stable asymmetric family of gaits emerges from a symmetric family of gaits as the total energy increases (e.g., fast speeds). The ground reaction forces of each leg reflect different roles, roughly corresponding to support, propulsion, and motion control as proposed by the hypothesis of functional asymmetry in able-bodied human walking. These results suggest that body mechanics, independent of neurophysiological mechanisms such as leg dominance, may contribute to able-bodied gait asymmetry.     

FEM modeling of SAR distribution and temperature increase in human brain from RF exposure

The assessment of radiofrequency exposure level and the exposure setup are critical, because if the exposure levels (related to frequency, power, position, and other variables) are not known, the biological results are not meaningful. In this regard, this study aims to design, implement, and analyze numerical setups for the simulations of radiofrequency exposure related specific absorption rate and temperature increase in the human brain and head. For this purpose, specific models for human head and telephone antenna are chosen, and the FEM is selected for solving PDEs related to electromagnetic wave equations and bioheat equation. After the verification of the methodology chosen by achieving comparable results with the literature, the scope of the study is then turned to the effects of different parameters on the exposure levels. In the end, comprehensive information can be obtained from the simulation results so that risk management policies for electromagnetic radiation can be reevaluated to minimize the possible health hazards. Copyright © 2012 John Wiley & Sons, Ltd.     

Vacuum-processed polyethylene as a dielectric for low operating voltage organic field effect transistors

We report on the fabrication and performance of vacuum-processed organic field effect transistors utilizing evaporated low-density polyethylene (LD-PE) as a dielectric layer. With C₆₀ as the organic semiconductor, we demonstrate low operating voltage transistors with field effect mobilities in excess of 4 cm²/Vs. Devices with pentacene showed a mobility of 0.16 cm²/Vs. Devices using tyrian Purple as semiconductor show low-voltage ambipolar operation with equal electron and hole mobilities of ～0.3 cm²/Vs. These devices demonstrate low hysteresis and operational stability over at least several months. Grazing-angle infrared spectroscopy of evaporated thin films shows that the structure of the polyethylene is similar to solution-cast films. We report also on the morphological and dielectric properties of these films. Our experiments demonstrate that polyethylene is a stable dielectric supporting both hole and electron channels.     

Enhancing impedance imaging through multimodal tomography

Several noninvasive modalities including electrical impedance tomography (EIT), magnetic induction tomography (MIT), and induced-current EIT (ICEIT) have been developed for imaging the electrical conductivity distribution within a human body. Although these modalities differ in how the excitation and detection circuitry (electrodes or coils) are implemented, they share a number of common principles not only within the image reconstruction approaches but also with respect to the basic principle of generating a current density distribution inside a body and recording the resultant electric fields. In this paper, we are interested in comparing differences between these modalities and in theoretically understanding the compromises involved, despite the increased hardware cost and complexity that such a multimodal system brings along. To systematically assess the merits of combining data, we performed 3-D simulations for each modality and for the multimodal system by combining all available data. The normalized sensitivity matrices were computed for each modality based on the finite element method, and singular value decomposition was performed on the resultant matrices. We used both global and regional quality measures to evaluate and compare different modalities. This study has shown that the condition number of the sensitivity matrix obtained from the multimodal tomography with 16-electrode and 16-coil is much lower than the condition number produced in the conventional 16-channel EIT and MIT systems, and thus, produced promising results in terms of image stability. An improvement of about 20% in image resolution can be achieved considering feasible signal-to-noise ratio levels.     

Transmission Power Control Aware Routing in Cognitive Radio Ad Hoc Networks

Abstract—Cognitive radio technology has drawn much attention since it is a promising candidate to efficiently utilize the scarce radio resources. However, cognitive radio introduces new challenges in the protocol stacks in wireless networks. This paper proposes a routing protocol for Cognitive Radio Ad Hoc Networks (CRAHNs), called Transmission Power Control aware AODV (TPC-AODV). TPC-AODV is based on Ad hoc On Demand Distance Vector (AODV) routing protocol. The main objectives of TPC-AODV are to avoid interruption of primary users’ communication and to support basic Quality of Service for secondary users. TPC-AODV takes inputs from both secondary users’ application requirements and the channel condition after spectrum sensing. These inputs enable secondary users’ communication with specific transmission power on the selected channel. Our simulation results show that TPC-AODV improves network performance in terms of throughput and delay compared to AODV in CRAHNs.