An Eco-Friendly Approach to the Control of Pathogenic Microbes and Anopheles stephensi Malarial Vector Using Magnesium Oxide Nanoparticles (Mg-NPs) Fabricated by Penicillium chrysogenum

The discovery of eco-friendly, rapid, and cost-effective compounds to control diseases caused by microbes and insects are the main challenges. Herein, the magnesium oxide nanoparticles (MgO-NPs) are successfully fabricated by harnessing the metabolites secreted by Penicillium chrysogenum. The fabricated MgO-NPs were characterized using UV-Vis, XRD, TEM, DLS, EDX, FT-IR, and XPS analyses. Data showed the successful formation of crystallographic, spherical, well-dispersed MgO-NPs with sizes of 7–40 nm at a maximum wavelength of 250 nm. The EDX analysis confirms the presence of Mg and O ions as the main components with weight percentages of 13.62% and 7.76%, respectively. The activity of MgO-NPs as an antimicrobial agent was investigated against pathogens Staphylococcus aureus, Bacillus subtilis, Pseudomonas aeruginosa, Escherichia coli, and Candida albicans, and exhibited zone of inhibitions of 12.0 ± 0.0, 12.7 ± 0.9, 23.3 ± 0.8, 17.7 ± 1.6, and 14.7 ± 0.6 mm respectively, at 200 µg mL⁻¹. The activity is decreased by decreasing the MgO-NPs concentration. The biogenic MgO-NPs exhibit high efficacy against different larvae instar and pupa of Anopheles stephensi, with LC50 values of 12.5–15.5 ppm for I–IV larvae instar and 16.5 ppm for the pupa. Additionally, 5 mg/cm² of MgO-NPs showed the highest protection percentages against adults of Anopheles stephensi, with values of 100% for 150 min and 67.6% ± 1.4% for 210 min.     

Interpretation of hydrogenation kinetics of spent oil distillate from u.v. spectroscopy

Hydrotreatment of spent oil distillate was carried out on a commercial Ni-Mo-alumina catalyst in the temperature range 260–340 °C, with a liquid hourly space velocity (LHSV) of 0.7–2.0 h^?1, pressure of 4.5 MPa and $\text{H}{}_2\text{oil}$ ratio of 300 NL L^?1 (normal litre of H₂ per litre of feedstock). U.v. spectra of hydrogenated and original spent oil distillates (measured in normal hexane) gave a band with a maximum at 230 nm. The change in absorbance at three selected wavelengths for original oil distillate and hydrotreated oil at different operating conditions was taken as a guide for the determination of hydrogenation reaction rates (including partial saturation of aromatics and sulphur compound hydrogenolysis). The rate constants of hydrogenation reactions (k) using a second-order equation and a model of two parallel first-order reactions (k₁ and k₂) were calculated. Finally, the apparent activation energy (E_a), enthalpy of activation ($\text{ΔH}{}^1$) and entropy ($\text{ΔS}{}^1$) were calculated based on the values of k, k₁, and k₂. The calculated values of E_a based on k, k₁ and k₂ were 81.479, 71.188 and 62.882 kJ mol^?1, respectively. The values of $\text{ΔH}{}^1$ based on the same rate constants were 76.670, 66.564 and 58.433 kJ mol^?1, while the values of $\text{ΔS}{}^1$ were ?117.150, ?133.779 and ?150.823 J mol^?1 K^?1, respectively.     

Temporal Hydrologic Alterations Coupled with Climate Variability and Drought for Transboundary River Basins

Climate change (CC) and drought episode impacts linked with anthropogenic pressure have become an increasing concern for policy makers and water resources managers. The current research presents a comprehensive methodology but simple approach for predicting the annual streamflow alteration based on drought indices and hydrological alteration indicators. This has been achieved depending on the evaluation of drought severity and CC impacts during the human intervention periods to separate the influence of climatic abnormality and measure the hydrologic deviations as a result of streamflow regulation configurations. As a representative case study, the Lesser Zab River Basin in northern Iraq has been chosen. In order to analyse the natural flow regime, 34 hydrological years of streamflow (1931–1965) prior to the main dam construction were assessed. The Indicators of Hydrologic Alteration (IHA) method has been applied to quantify the hydrological alterations of various flow characteristics. In addition, an easy approach for hydrological drought prediction in relatively small basins grounded on meteorological parameters during the early months of the hydrological year has been presented. The prediction was accomplished by implementing the one-dimensional drought examination and the reconnaissance drought index (RDI) for evaluating the severity of meteorological drought. The proposed methodology is founded on linear regression relations connecting the RDI of 3, 6, and 12 months and the streamflow drought index (SDI). The results are critical for circumstances where an early exploration of meteorological drought is obtainable. Outcomes assist water resources managers, engineers, policy makers and decision-makers responsible for mitigating the effects of CC.     

Tensile Stress Relaxation of Alumina at High Temperature

The development of a tensile testing methodology for ceramics which enables a stress vs strain-rate response to be measured at high temperature is described. The test involves a carefully controled stress relaxation test at constant total strain using an experimental procedure and phenomenological analysis previously developed for metallic materials. It is demonstrated here with preliminary tests on alumina at 1050° and 1150°C. This offers, with further development, the possibility of establishing design stresses associated with low strain-rate behavior for structural applications. The results demonstrate that data covering four decades of strain rate may be generated in tests lasting a few hours. The inelastic strain consists of substantial anelastic recoverable strain in addition to a permanent creep strain.     

Thermal conversion (visbreaking) of heavy Iraqi residue

A heavy Iraqi residue was thermally cracked using a soaker visbreaking process at temperatures between 435 and 480 °C, with a range of residence times of 43–109 s in the coil and 151–379 s in the soaker. The pressure was kept constant at 7 bar. Visbroken products were characterized, evaluated and fractionated into light, middle and heavy cuts. The stability of the visbroken products was compared with that of the original feedstock. Also an activation energy was calculated for the visbreaking process and related to the severity of the process. The results obtained show that the conditions used were not severe and could be applied to obtain a required conversion depending on the uses of the products.     

Weight loss, polarization, electrochemical impedance spectroscopy, SEM and EDX studies of the corrosion inhibition of copper in aerated NaCl solutions

This work reports results of weight loss, potentiodynamic polarization and impedance measurements on the corrosion inhibition of copper in aerated non-stirred 3% NaCl solutions in the temperature range 15–65 °C using sodium oleate (SO) as an anionic surfactant inhibitor. These studies have shown that SO is a very good ”green”, mixed-type inhibitor. The inhibition process was attributed to the formation of an adsorbed film on the metal surface that protects the metal against corrosive agents. Scanning electron microscopy (SEM) and energy dispersion X-ray (EDX) observations of the electrode surface confirmed the existence of such an adsorbed film. The inhibition efficiency increases with increasing surfactant concentration and time of immersion, while it decreases with solution temperature. Maximum inhibition efficiency of the surfactant is observed at concentrations around its critical micellar concentration (CMC). The potential of zero charge (pzc) of copper was studied by ac impedance, and the mechanism of adsorption is discussed. The sigmoidal shape of the adsorption isotherm confirms the applicability of Frumkin’s equation to describe the adsorption process. Thermodynamic functions for the adsorption process were determined.     

Synchronous receiver initiated MAC protocol for long-lived sensor networks

In this paper, we discuss the design of a new Medium Access Control (MAC) protocol, SRI-MAC (Synchronous Receiver Initiated MAC), for wireless sensor networks whose goal is to extend the lifetime of the network by avoiding major energy waste causes, such as collisions, overhearing and idle listening.     

The impact of interaction quality factors on the effectiveness of Web-based information system: the mediating role of user satisfaction

Recently, IS researchers have focused on the assessment of Web-based information system (WBIS) at the individual level as it highly contributes to the organizations’ employees. The evaluation and development of WBIS is significantly needed because the top management is in need of justifying their costly IT investment in terms of its impacts on employee performance. For this purpose, this study is primarily concerned with the development and validation of new multidimensional instrument, and also a theoretical framework for assessing the impacts of user interface quality, online communication quality, and user satisfaction on the effectiveness of Web employee portals. The effectiveness is assessed in terms of contextual performance. In a large-scale study, a sample of 384 United Nations Relief and Works Agency for Palestine Refugees respondents are gathered in order to validate and check the reliability of the adapted study instrument. The results of validity and reliability analysis provide enough confidence to proceed toward validating the proposed theoretical framework. The results of multiple-regression analysis indicate that there is a positive significant relationship between user interface quality, communication quality, user satisfaction, and effectiveness at significance level (sig. < 0.01). As another important point, the results of hierarchical regression showed that user satisfaction has a mediating role on the relationship between user interface quality, communication quality, and contextual employee performance. The findings and implications of this research are discussed. Finally, it is expected that this study would contribute to empirical studies in the fields of IS and user behavior assessment.     

Formation of Nanocrystalline Calcia by the Decomposition of Calcite

Formation of nanocrystalline calcia from calcite has been studied in situ via transmission electron microscopy. The crystallographic transformation occurred via two mechanisms: the first is by distortion of the cleaved rhombohedron of calcite, formed by {104} planes in hexagonal coordinates, into a cube. This produced a microstructure of oriented, elongated nanocrystals of calcia with planar boundaries. In the second mechanism, the micrometer-sized parent calcite particles broke up into nano-sized grains as the decomposition began, leading to irregularly shaped, randomly oriented nanocrystals of calcia.