Studies on synthetic-polymer plates with high surface energy. II. Diethylene glycol bis(allyl carbonate)–unsaturated carboxylic acid system

Polymer plates with high surface energy were prepared by the procedure described in the previous paper, using diethylene glycol bis(allyl carbonate) as a substrate polymer and acrylic acid or methacrylic acid as a hydrophilic monomer. By the alkali treatment (immersing in an aqueous 0.1N NaOH solution for 2 h), the resulting polymer plates had good water wettability (contact angle for water = 10°) and sufficient mar resistance (the scratching hardness = 45–50 g) in a dry state, and their clarities were higher than those for DAP systems previously reported. The surface densities of carboxyl groups on the polymer plate estimated by use of the McBain's equation were 0.18–0.46 molecule/Ų.     

Polymerization of ethylene and propylene initiated by milled alumina powder

Generation of free radicals (mechano-radicals) by the milling of alumina powder at 77 K was demonstrated by ESR. After milling of alumina in the presence of ethylene (simultaneous milling) at 77 K, polyethylene-propagating radicals instead of the alumina mechano-radicals were detected by ESR. Also the contact of ethylene with the milled alumina converted alumina mechano-radicals into polyethylene propagating radicals at a temperature above the melting point of ethylene. The products extracted by hot toluene from the simultaneous milling were identified by IR to be polyethylene, and their molecular weights were roughly 10,000. The residues after the extraction were bonded with the alumina. Polypropylene was also produced by a similar method of milling of alumina in the presence of propylene. The obtained polyproylene was atactic, and its molecular weight was about 400.     

Investigation of UV-A light irradiation on tomato fruit injury during storage

We investigated the effect of UV-A light (wavelength 315 to 400 nm) irradiation during storage on tomato fruit injury. Mature green tomato fruit (cv. House Momotaro) were exposed to UV-A at doses of 0.02, 0.5, and 2 mW x cm(-2) throughout storage at 25 degrees C. The physiological disorders, fruit ripening, superoxide dismutase (SOD) activity, and increases in fruit temperature were evaluated. All UV-A-irradiated and nonirradiated tomatoes developed a full red color at the same time (2 weeks). Irradiated fruit ripened normally, and exposure of tomato fruits to UV-A did not lead to the discoloration of ripe tomato fruit at any dosage. The fruit temperature did not increase in response to various UV-A light doses and exposure times, and none of the UV-irradiated fruits showed physiological disorders (dull skin blemish, pitting). The SOD activity of UV-A-irradiated fruit exposed to the various UV-A doses did not significantly (P = 0.05) differ from that of fruit stored in dark conditions. The SOD results imply that UV-A light might not induce reactive oxygen species in UV-A-irradiated fruit.     

Defective bone remodelling in osteoprotegerin-deficient mice

Previous studies have reported enhanced osteoclastogenesis, increased bone resorption and osteoporosis in osteoprotegerin (OPG)-deficient mice. In the present study, we show that the tibial epiphyses contain abundant, thin trabeculae lined with numerous osteoclasts and cuboidal osteoblasts. The increase in osteoblasts and osteoclasts was associated with a dramatic increase in calcein labelling of the mineralization fronts and replacement of much of the intertrabecular marrow with numerous alkaline phosphatase-positive preosteoblasts. Furthermore, the discrete, linear cement lines seen in wild-type mice were replaced by a randomly oriented meshwork of cement lines that were stained intensely for tartrate-resistant acid phosphatase and osteopontin in the OPG-/- mice. These indices of accelerated bone remodelling in mutant bone were associated with irregular trabecular surfaces, a disorganized collagen matrix interspersed with amorphous ground substance and numerous fissures between old and new bone. In total, these observations indicate that enhanced osteoclastic activity in OPG-/- epiphyses led to a coupled increase in osteoblast differentiation and activity and an increase in bone remodelling. The high bone turnover, disorganized matrix and impaired attachment of new to old bone in the cement lines in OPG-/- mice appear to cause bone fragility.     

Microassembly of semiconductor three-dimensional photonic crystals

Electronic devices and their highly integrated components formed from semiconductor crystals contain complex three-dimensional (3D) arrangements of elements and wiring. Photonic crystals, being analogous to semiconductor crystals, are expected to require a 3D structure to form successful optoelectronic devices. Here, we report a novel fabrication technology for a semiconductor 3D photonic crystal by uniting integrated circuit processing technology with micromanipulation. Four- to twenty-layered (five periods) crystals, including one with a controlled defect, for infrared wavelengths of 3-4.5 microm, were integrated at predetermined positions on a chip (structural error <50 nm). Numerical calculations revealed that a transmission peak observed at the upper frequency edge of the bandgap originated from the excitation of a resonant guided mode in the defective layers. Despite their importance, detailed discussions on the defective modes of 3D photonic crystals for such short wavelengths have not been reported before. This technology offers great potential for the production of optical wavelength photonic crystal devices.     

Novel vitamin E derivative with 4-substituted resorcinol moiety has both antioxidant and tyrosinase inhibitory properties

A novel vitamin E derivative, (6″-hydroxy-2″,5″,7″,8″-tetramethylchroman-2″-yl) methyl 3-(2′,4′-dihydroxyphenyl)propionate (TM4R), which has a chromanoxyl ring and 4-substituted resorcinol moieties, was synthesized; and its inhibitory effects on tyrosinase, antioxidant ability, and lightening effect of ultraviolet B (UVB)-induced hyperpigmentation were estimated. TM4R showed potent inhibitory activity on tyrosinase, which is the rate-limiting enzyme in melanogenesis. The scavenging activities of TM4R on 1,1-diphenyl-2-picrylhydrazyl and hydroxyl radicals were found to be nearly the same as those of α-tocopherol. Furthermore, an efficient lightening effect was observed following topical application of TM4R to UVB-stimulated hyperpigmented dorsal skin of brownish guinea pigs. These results suggest that TM4R may be a candidate for an efficient whitening agent, possibly by inhibiting tyrosinase activity and biological reactions caused by reactive oxygen species.     

Study on flow-induced vibration of head–disk assembly mechanisms in actual hard disk drive

Achieving ultra-high magnetic-recording density in hard disk drives (HDDs) requires clarification of flow-induced vibration issues. In particular, it is necessary to reduce the flow-induced disk vibration called disk flutter. Thus far, however, there has been no experimental research related to disk flutter in actual HDDs. For this study, therefore, the disk-flutter issues have been studied experimentally, using an actual 2.5-in. HDD with one disk and two magnetic heads. The aim was to study the effect of operating magnetic-head mechanisms on flow-induced disk flutter. This study evaluated disk flutter as well as static pressure distribution in the actual HDD, by taking measurements while changing the operating modes of the magnetic-head mechanism as well as the number of operating air-bearing sliders. The study demonstrated that the disk-flutter amplitude increases and its frequency decreases when the magnetic-head mechanisms are operating. It was also found that the amount of decrease in the disk-flutter frequency depends on the number of operating air-bearing sliders whose amplitude increase varies with the specific operating mode of the head mechanisms, such as whether it is in track-following or seek modes. In addition, operation of the magnetic-head mechanisms generated non-uniform static pressure distribution within the HDD. These factors suggest that a decrease in disk-flutter frequency results from the slider-coupled vibration and an increase in disk-flutter amplitude results from the static pressure changes as well as air-following changes, as these vary with the actual operation of the disk head mechanism. From these experimental results, it appears that the disk-flutter issues in actual HDDs should be considered as a system that includes the operation of the magnetic-head mechanisms and disk-coupled vibration.     

Co-continuous monolithic titania prepared by organic polymer monolith as pore template

We achieved preparation of co-continuous titania based monolithic materials using several organic polymer monoliths as pore templates. Firstly, the organic polymer monoliths that had well controlled structures were prepared, and filled the pores of polymer monolith with tetra-n-butyl titanate (titan monomer). The following hydrolysis of the titan monomer resulted in titanium dioxide. The polymer monolith was removed by calcination at elevated temperature. We carefully studied the utility of polymer monolithic template, filling method of the titan monomer, and calcination conditions to realize co-continuous titania monolith. In addition, by the change of domain size (size of a skeleton + size of through a pore) of template, we were able to control domain size of the resulting titania monoliths.