1，1＇－二（1，3－二氧代长链烷基）二茂铁的合成与表征

用１，１＇－二乙酰基二茂铁与酯的Ｃｌａｉｓｅｎ缩合反应合成了５个新的１，１＇－二（１，３－二氧代长链烷基）二茂铁，其通式为Ｃ５Ｈ４ＦｅＣ５Ｈ４（ＣＯＣＨ２ＣＯＣｎＨ２ｎ＋１）２，ｎ＝５～９。通过元素分析、紫外－可见光谱、红外光谱、核磁共振氢谱和质谱对这些化合物进行了表征。结果表明，这些β－二酮仅以烯醇式存在。     

雷达波吸收性聚氨酯泡沫塑料的研究

通过对碳纤维、碳纤维/纤维Ⅰ和碳纤维/纤维Ⅱ分别填充的硬质聚氨酯泡沫塑料的吸波性能的研究,探讨了纤维类型、纤维含量、样品厚度的相关变化对塑料样板吸波性能的影响。结果表明,填充碳纤维的硬质聚氨酯泡沫塑料的吸波频带较窄;纤维Ⅰ和纤维Ⅱ分别与碳纤维混杂均可展宽频带;吸波性能随塑料样板厚度的增加而增强,随纤维Ⅱ含量的增加,吸收峰向低频移动,峰值增大。     

Rheological properties of bitumen in water emulsions with added solids

Experimental work was carried out to investigate the rheological properties of bitumen in water emulsions containing solids of different shape and size. The bitumen volumetric concentration was varied up to 60%, solids free basis, and the solids volume fraction (total volume basis) was varied up to 0.2. Irregular-shaped silica sand (average diameter: 9 and 33 μm) and smooth spherical glass beads (average diameter: 27 and 44 μm) were used as the added solids. In the low shear stress range, shear thinning behavior was observed for bitumen in water emulsions. At high shear stress, the viscosity of the emulsions became fairly independent of the shear stress. The addition of solids to the bitumen emulsions increased the mixture viscosity. The addition of irregular-shaped silica sand gave a higher viscosity than a similar addition of the spherical glass beads. The viscosity of the emulsion/solids mixtures was influenced by the solids size as well; the smaller size particles gave a higher viscosity. The addition of solids to the bitumen emulsions also induced shear thickening (dilatancy) behavior at high solids volume fraction. The degree of the shear thickening increased with the oil concentration.     

碳铵法制备纳米氧化锌的研究

一种纳米氧化锌的制备方法，其过程包括：以硫酸锌和碳酸铵(或碳酸氢铵和氨水)为原料中和制备碱式碳酸锌，碱式碳酸锌经水洗除掉硫酸根后，再醇洗、干燥、煅烧，制备了纳米氧化锌。经表观密度、比表面积、孔容积和透射电镜(TEM)的测定，确定了研制的物料为纳米氧化锌，粒子峰值为10～20nm。     

从废旧聚苯乙烯泡沫塑料中回收苯乙烯

本文采用有机溶剂甲苯作为消泡剂，用热裂解法从废旧聚苯乙烯泡沫塑料中回收苯乙烯，苯乙烯收率可达８０％以上。     

Complementarity determining region residues aspartic acid at H55, serine at H95 and tyrosines at H97 and L96 play important roles in the B72.3 antibody-TAG72 antigen interaction

Structural analysis derived from the crystallographic studyof the chimeric B72.3 antibody illustrated some major atomicinteractions between complementarity determining region (CDR)residues. For example, hydrogen bonds are formed between H35/H95,L50/H97, H53/H55 and H96/L96 respectively. These CDR residuesmay play important roles in the B72.3–TAG72 (antibody-antigen)interaction either by direct interaction with the TAG72 antigenor by maintaining a CDR loop conformation through atomic interactionsbetween CDR residues. In order to confirm these assumptions,we altered these CDR residues by site-directed mutagenesis anddetermined binding affinities of these mutant chimeric antibodiesfor the TAG72 antigen in a solid-phase radioimmunoassay. Wefound that H55, H95, H97 and L96 are important CDR residuesfor the B72.3–TAG72 interaction. Single amino acid substitutionsof aspartic acid and serine by alanine at H55 of CDR2 and atH95 of CDR3 respectively and of tyrosine by phenylalanine atH97 and L96 of CDR3, significantly reduced the binding affinityfor the TAG72 antigen by 20-, 8-, 16- and 45-fold respectively.Therefore, this study reveals some of the requirements for maintainingthe integrity of the B72.3 antibody combining sites.     

多孔β-TCP陶瓷药物载体结构与性能的影响因素

本分析了影响多孔β-TCP陶瓷药物载体结构与性能的因素，确定了制备多孔β-TCP陶瓷药物载体的技术路线和工艺参数。     

近十年常温干法精脱硫专利技术发展动态

收集了近十年来国内的常温干法精脱硫专利，并分类列举出各种脱硫剂的物化性质和几种常温精脱硫工艺，重点阐述了该技术的优缺点及其未来发展方向。     

碳酸二苯酯技术发展现状及展望

综述了碳酸二苯酯多种合成技术的发展现状，重点介绍了碳酸二甲酯与苯酚酯交换法和氧化羰基化法技术，并对碳酸二苯酯技术在国内的发展进行了展望。