A Novel Athermal 40-Channel DWDM Multi/Demultiplexer Based on the Combination of AWGs and Interleaver

An athermal 40-channel dense wavelength-division-multiplexing multi/demultiplexer using a novel combination technology is proposed. It consists of one 1times4 100- to 400-GHz spacing interleaver filter and four sub-arrayed-waveguide gratings (AWGs). The temperature-dependent wavelength shift of the combined device is successfully suppressed to 0.058 nm in the -20degC to 70degC temperature range. Moreover, the combined device's adjacent crosstalk (typically -35 dB) is much better than conventional AWGs (typically -25 dB).     

Electrical properties and positron annihilation study of (Ba<Subscript>1−<Emphasis Type="Italic">x</Emphasis></Subscript>Ho<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript>)TiO<Subscript>3</Subscript> ceramics

DC resistivity, dielectric constant, dielectric loss and positron annihilation spectra of (Ba_1−x Ho _x )TiO₃ ceramics have been measured as a function of holmium concentration x. It has been found that the DC resistivity of (Ba_1−x Ho _x )TiO₃ is strongly dependent on the Ho content: it decreases three orders of magnitude and reaches a minimum at x = 0.4%. Doping with 0.6% holmium increases the permittivity of BaTiO₃ by approximately three times (from ∼1,300 to ∼4,000), with only a slight increase in the corresponding dielectric loss. The local electron density and defect concentration estimated using positron annihilation technique conforms well to the features found in the dielectric and resistivity measurements. The results have been discussed in terms of a mixed compensation model.     

热力学相图计算技术在闪速燃烧合成氮化硅铁中的应用

将热力学相图计算技术应用于Si-Fe-O-N体系,以评估由FeSi75粉闪速燃烧合成氮化硅铁的条件和目标产物。结果表明:将闪速燃烧温度控制在1200～1500℃之间较为适宜,此时平衡态产物中除主要含有Si3N4以外,还有一定量的Fe与Si间化合物和少量稳定的SiO2存在。此计算结果与实际试验结果吻合良好。     

Web服务提供方安全模型的分析与设计

讨论了Web服务提供方的安全问题,通过对Web服务调用方式的分析,为Web服务的提供方设计了安全模型.所设计的模型不依赖于服务提供方选用的安全策略,方便策略的更改和安全检查机制的更新.该模型同样适用于Web服务的需求方.     

有机盐聚合醇氯化钾钻井液的应用

霍尔果斯背斜构造极其复杂,内应力极高,地层倾角大,断层、破碎带多,并存在高低压互层;安集海河组的灰绿色软泥岩水化严重并具有粘弹塑性.该区块重点探井霍003井三开、四开井段选用有机盐聚合醇氯化钾钻井液,同时为保证钻井液在高密度下（2.55 g/cm^3）具有好的流变性,使用活化铁矿粉、活化重晶石加重.应用结果表明,由于采用了强抑制和多元封堵的措施,该钻井液具有良好的流变性和较强的携带能力,钻进中曾携带出重2.8 kg和5.1kg的大掉块;滤失量低,泥饼质量好,封堵能力强,造壁能力强,减轻了井下阻卡程度;有良好的储层保护能力;在室内研究的基础上,经过现场合理使用和维护钻井液,霍003井提高了机械钻速,缩短了钻井周期,井身质量优于邻井.指出在高密度下,未选出适合有机盐聚合醇氯化钾钻井液的稀释剂,钻井液流动性较差.     

鸭池河水电站压力钢管外压稳定性设计

采用解析法和半解析有限元法分别对鸭池河水电站埋藏式加劲压力钢管进行外压稳定性计算。在计算分析过程中,考虑了初始缺陷因素对埋藏式加劲压力钢管抗外压稳定性的影响,使得计算结果更加接近于工程实际;从而为埋藏式加劲压力钢管的外压稳定性计算提出了一种更加行之有效的方法。     

中压变频器在宣钢炼钢厂除尘风机中的应用

本文介绍了SIMOVERT MV中压变频器在宣钢炼钢厂一次除尘风机中的应用情况。变频器现场运行表明，采用中压变频器对转炉除尘风机进行调速节能获得了成功，节能效果明显。     

Anomalous splitting in microwave mode-beating spectra of semiconductor ring lasers

Mode-beating spectra are investigated in long-perimeter (1.028 cm) monolithically integrated multiple-quantum-well semiconductor ring lasers. The beating line near 8 GHz is found to be split into two components. With increasing pumping current, a normal component shifts to lower frequencies, while an anomalous higher-frequency component shifts in the opposite direction. It is suggested the anomalous blue-shifting line results from power-induced perturbation of the refractive index in the vicinity of a strong mode.     

Effects of various post-treatments on carbon nanotube films for reliable field emission

In this report, the FE characteristics of carbon nanotubes (CNTs) treated using both thermal annealing and mechanical coatings on the as-grown CNTs systematically studied. It was found that in the high temperature annealed samples, CNTs were attacked at its root during annealing due to a small amount of oxygen, and were pulled out of the substrate in places after FE measurements because of the contact resistance. However, for the mechanically coated samples both with spin on glass (SOG) and polymethyl methacrylate (PMMA), CNTs were found to be nearly intact after FE measurements and showed reliable FE characteristics over repeatable voltage scan. The reliability of CNTs during FE could be owing to the strong adhesion of CNTs to the substrate both by SOG and PMMA coatings.     

基于Multisim7.0软件平台的电子电路设计型实验研究

介绍了EDA(电子设计自动化)技术中Multisim7.0软件平台的功能特点.利用EDA技术进行设计性实验的研究与开发,是改革传统电子电路实验教学模式的有效途径,能帮助学生掌握最先进的电子电路设计方法和技能.结合EDA技术在电子电路设计型实验中的应用实例分析,阐明了利用Multisim7.0软件平台进行电子电路设计的优越性,其方便的更改电路和元器件参数的能力,使得能够更快更好地进行电子电路设计与仿真分析,同时缩短设计电路的时间,因而是一种全新的培养学生实际动手能力的有效工具.