Absorption by rats of tocopherols present in edible vegetable oils

The absorption of tocopherols (α, γ, and σ) and fatty acids from rapeseed (RO), soybean (SOO), and sunflower (SUO) oil, both from the natural oils and from the oils following moderate heating (180°C for 15 min), was measured in lymphcannulated rats. Oils were administered as emulsions through a gastrostomy tube, and lymph samples were collected for 24 h. The composition of tocopherols in oils and lymph fractions was measured by high-performance liquid chromatography, and fatty acids were measured by gas-liquid chromatography. The highest accumulated transport of α-tocopherol was observed after SUO administration, the lowest after SOO, with RO in between, corresponding to their relative contents (41.6±8.8, 32.7±5.0, and 24.9±4.3 μg at 24 h after administration of SUO, RO, and SOO, respectively). The calculated recoveries (in %) 24 h after oil administration were 21.4±4.5, 45.7±7.0, and 78.8±13.5 for SUO, RO, and SOO, respectively, suggesting that the absorption efficiency decreased when the α-tocopherol concentration increased. The recovery of α-tocopherol was higher than the recoveries of γ-and σ-tocopherol, indicating that the different tocopherols were not absorbed to the same extent or with similar rates. No differences between unheated and heated oils were observed in the absorption of tocopherols, whereas heating led to lower absorption of fatty acids, thus showing no direct association between absorption of tocopherols and fatty acids.     

Dehydrogenation of Light Alkanes Over Rhenium Catalysts on Conventional and Mesoporous MFI Supports

Recently, Re/HZSM-5 (Si/Al = 15) was shown to be an efficient catalyst for ethane dehydrogenation and aromatization at 823 K and atmospheric pressure. In this reaction, the major initial products were benzene, toluene and xylene (BTX), but increasing amounts of ethene were produced with time on stream due to deactivation of the catalyst. We show that by use of rhenium impregnated MFI supports with very few or no acidic sites (Si/Al > 500), highly selective ethane dehydrogenation catalysts are obtained with ethene selectivities of 98%. By use of mesoporous MFI supports (Si/Al >500) the lifetime of the catalyst appears to be slightly improved compared to conventional MFI crystals. The beneficial effect of a mesoporous MFI support is convincingly demonstrated in propane dehydrogenation, where both conversion and selectivities on the mesoporous MFI (Si/Al > 500) impregnated with Re are significantly higher than on Re supported on a comparable conventional MFI support.     

Sludge Pre-Treatment through Ozone Application: Alternative Sludge Reuse Possibilities for Recirculating Aquaculture System Optimization

Recirculating Aquaculture Systems (RAS) reduce water consumption by efficient filtration to maintain appropriate levels of accumulating compounds and sludge. Sludge is mechanically separated by drum filters and disposed of to the detriment of overall system water budgets. Dissolved nitrogen compounds are reduced via nitrification–denitrification filters, requiring commercial external carbon sources. The reuse of sludge after ozone pre-treatment may represent the next step in RAS optimization. The present study analyzes the content of sludge from RAS and tests ozonation as a pre-treatment for recycling as carbon source. The dissociative effect of ozone and the physicochemical changes due to ozonation lead to a significant increase in soluble carbon availability. Predominantly long-chain fatty acid (FA) (saturated and unsaturated) with 16 and 18 carbon atoms independently of the treatment were found in the profiles. Saturated FA concentrations in solution increased after 20, 40, and 60 min ozonation. The solid content of the sludge was practically unaffected by ozonation in terms of FA profile: only saturated FA slightly increases after 40 min treatment. The implications of these findings for denitrifying bacteria are discussed.

Abbreviations: Recirculating Aquaculture Systems (RAS); Advanced Oxidation Processes (AOPs)     

Synthesis and characterization of dehydroabietic acid derivatives suitable for surfactant synthesis

The syntheses of derivatives of dehydroabietic acid suitable for further manipulation into surfactants are presented. The compounds are produced at very high yields and purity. They contain several different functional groups, e.g., carboxylic acid, amine, ester, alcohol, and an aromatic group. The functional groups are useful as the linking unit to the hydrophilic part in synthesizing surfactants.     

Molecular thermodynamics of solutions in the normal and critical regions — II. Activity coefficients for the ArN2, C2H6C2H4 and C3H6CO2 systems

Activity coefficients for the ArN₂, C₂H₆C₂H₄, and C₃H₆CO₂ systems are calculated from published vapour-liquid equilibrium compositions at various pressures and temperatures. The activity coefficients are correlated using a two parameter model based on the principles of molecular thermodynamics. The method is used both in the normal liquid and critical regions. The parameters of the model are shown to be reasonably independent of the temperature for the three systems.     

Expectations and Experiences With MyLabourParty: From Right to Know to Right to Participate?

Social media are often argued to change political communication, decreasing the distance between politicians and citizens, and increasing citizens' influence on policymaking. This paper presents findings from a study of how the Norwegian Labour Party uses social media, focusing on the community platform MyLabourParty. Interviews with politicians and a survey with citizens as respondents were conducted to examine the experiences of online political discussions. Findings show that citizens and politicians expect MyLabourParty to strengthen citizen participation. Yet, citizens still experience communication asymmetry and politicians may find it challenging to participate to the extent citizens expect. Means for bridging the gap between expectations and experiences are called for, in particular redefinition of the offering, changes of user‐practices, and system improvements.     

DMTO – a method for Discrete Material and Thickness Optimization of laminated composite structures

This paper presents a gradient based topology optimization method for Discrete Material and Thickness Optimization of laminated composite structures, labelled the DMTO method. The capabilities of the proposed method are demonstrated on mass minimization, subject to constraints on the structural criteria; buckling load factors, eigenfrequencies, and limited displacements. Furthermore, common design guidelines or rules, referred to as manufacturing constraints, are included explicitly in the optimization problem as series of linear inequalities. The material selection and thickness variation are optimized simultaneously through interpolation functions with penalization. Numerical results for several parameterizations of a finite element model of a generic main spar from a wind turbine blade are presented. The different parameterizations represent different levels of complexity with respect to manufacturability. The results will thus give insight into the relation between potential weight saving and design complexity. The results show that the DMTO method is capable of solving the problems robustly with only few intermediate valued design variables.     

A simple chromatographic method for purification of egg lecithin

Egg lecithin was purified from the CdCl₂-lecithin complex by column chromatography on Alumina. The yield from 5 eggs was 2.8 g. The purified lecithin had correct chemical values for pure lecithin and a fatty acid composition similar to lecithin prepared by other methods. The method probably can be adapted for purification of other lipids containing the phosphocholine moiety and for purification of synthetic lecithin.     

Constrained regression in chemical engineering practice

Absolute equality constraints in multiple regression are shown to introduce only minor modifications in the normal equations by a subset of the regression parameters. It is essential that these are ordered such that the subset is observable through the constraints. The constraints are shown to give greater residuals about the regression, but the precision in the parameter estimation is improved.In general power function curve fitting, a quadratically convergent iterative computation of the optimal exponents uses the normal equations as equality constraints. The correlations between the coefficients and the exponents in a sum of power functions become very high, when the number of terms increases such that their individual observability is being greatly reduced. The effect is shown to be a very poor precision in the parameter estimation and a heavy oscillation in the coefficients.The algorithms suggested are illustrated by curve fitting of some binary equilibrium data, where the relative volatility model gives a superior fit to the data.