单模光纤的传输衰减随温度变化的研究

本文从实验上测量了单模石英光纤在－50～120℃范围内的损耗。随着温度升高，光纤的损耗随之降低，在常温附近达到最小。其后损耗随着温度的继续升高而增加。损耗的变化主要是由于杂质的吸收和微弯损耗。本文对杂质的吸收以及微弯损耗进行了数值模拟，并且从理论上定性地解释了损耗对温度的依赖关系。     

定向爆破拆除高危烟囱的实践

通过对已产生纵向裂缝、倾斜和基部风化剥蚀严重的高危烟囱的定向（向倾斜相反方向）倒塌爆破实践表明：设计中选用爆破参数及施工措施是有效的。     

电致伸缩陶瓷微位移器非线性的数值方法补偿

本文通过对电致伸缩陶瓷材料的非线性进行分析。找到了补偿电致伸缩陶瓷非线性的数值方法，并对不同回程大小的电滞回线进行了分段处理，使补偿结果更为精确。     

石家庄市CATV系统网络技术指标分配初探

在ＣＡＴＶ系统网络工程设计中，技术指标的分配产关键问题。本文介绍了石家庄市在系统设计时采用的符合实际的设计程序，并对系统前端，传输及用户网各部分技术指标的确定，计算与分配方法，指标的核算等作了较详细地阐述，以供同行参考。     

The inverse mapping and distortion measures for 8-node hexahedral isoparametric elements

The inverse relations of the isoparametric mapping for the 8-node hexahedra are derived by using the theory of geodesics in differential geometry. Such inverse relations assume the form of infinite power series in the element geodesic coordinates, which are shown to be the skew Cartesian coordinates determined by the Jacobian of the mapping evaluated at the origin. By expressing the geodesic coordinates in turn in terms of the isoparametric coordinates, the coefficients in the resulted polynomials are suggested to be the distortion parameters of the element. These distortion parameters can be used to sompletely describe the inverse relations and the determinant of the Jacobian of the mapping. The meanings of them can also be explained geometrically and mathematically. These methods of defining the distortion measures and deriving the inverse relations of the mapping are completely general, and can be applied to any other two-or three-dimensional isoparametric elements.     

多级泵站老化的模糊评价模式

多级泵站是一个包括各级泵站及泵站内各种设施的复杂系统，系统内各个泵站的老化直接影响整个泵站系统的正常运行，采用单元化方法将多级泵站系统单元伦，引和泵站老化评价指标，建立了多级泵站老化的模糊评价模式，并对甘肃省景泰高扬程提水灌区多级泵站系统进行分析，提出了评价多级泵站老化程度的排序方法。     

AN EXTENDED MODELING OF TIDE-WAVE MOTION

1 .　ＩＮＴＲＯＤＵＣＴＩＯＮＴｏｓｔｕｄｙｔｈｅｍｏｔｉｏｎｏｆｔｈｅｔｉｄｅ ｗａｖｅｓ,ｔｈｅｓｈａｌｌｏｗｗａｔｅｒｅｑｕａｔｉｏｎｓ ,ｉ.ｅ .ｔｈｅｖｅｒｔｉｃａｌｉｎｔｅｒｇｒａ ｔｉｏｎｏｆｔｈｅｃｏｎｔｉｎｕｉｔｙｅｑｕａｔｉｏｎａｎｄｍｏｍｅｎｔｕｍｅｑｕａ ｔｉｏｎ ,ｉｓｃｏｎｓｉｄｅｒｅｄａｓｔｈｅｇｏｖｅｒｎｉｎｇｅｑｕａｔｉｏｎｓ.Ｂｙａｂｏｖｅｅｑｕａｔｉｏｎｓｔｗｏｅｑｕａｔｉｏｎｓｒｅｌａｔｅｄｔｏｔｈｅｈｏｒｉｚｏｎ ｔａｌｆｌｕｘｏｆｔｈｅｔｉｄｅ ｃｕｒｒｅｎｔｓａ…     

Flammability and thermal stability studies of ABS/Montmorillonite nanocomposite

Acrylonitrile–butadiene–styrene (ABS)/montmorillonite nanocomposites have been prepared using a direct melt intercalation technique by blending ABS and organophilic clay of two different particle sizes: OMTa (5 µm) and OMTb (38 µm). Their structure and flammability properties were characterized by X‐ray diffraction, high resolution electronic microscopy (HREM), thermogravimetric analysis (TGA) and cone calorimeter experiments. The results of HREM showed that ABS/5 wt% OMTa nanocomposite was a kind of intercalated–delaminated structure, while ABS/5 wt% OMTb nanocomposite was mainly an intercalated structure. The nanocomposites showed a lower heat release rate peak and higher thermal stability than the original ABS by TGA and cone calorimeter experiments. Also, the intercalated nanocomposite was more effective than an exfoliated–intercalated nanocomposite in fire retardancy. Copyright © 2003 Society of Chemical Industry     

基于B点磁探针膛内电枢电弧长度与速度分布测量的计算机控制系统的研究

基于B点磁探针的测量原理，建立了电磁轨道炮膛内三维等离子体电枢电弧长度和电弧运动速度测量的数学模型，通过对该模型的分析给出了用于测量膛内电枢电弧长度和运动速度分布的相应推论。开发了用于测量膛内等离子体电枢电弧长度和速度的多通道计算机控制诊断系统，并进行了相应的试验研究。