Effect of inoculum size, relative humidity, storage temperature, and ripening stage on the attachment of Salmonella Montevideo to tomatoes and tomatillos

The influence of inoculum populations and environmental factors on attachment of Salmonella Montevideo to the surface of tomatoes and tomatillos was evaluated. To study the effect of inoculum size, red, ripe tomatoes were spot-inoculated with bacterial suspensions (10(5) and 10(8) CFU/fruit) and stored at 22 degrees C under 100% relative humidity. The effects of temperature (12, 22, and 30 degrees C) and relative humidity (75, 85, and 97%) on attachment of the pathogen (10(7) CFU/fruit) to tomatoes (red and green) and ripe tomatillos were also evaluated. Inoculated fruits were stored for 90 min at all combinations of temperature and relative humidity, and after rinsing with water, the number of cells attached to the surface was determined. Salmonella Montevideo attached to the surface of tomatoes within 90 min. A direct correlation between the number of attached cells and the population in the inoculum was observed. The percentage of cells that attached immediately after inoculation was approximately 0.3% for the three test products. After storage for 90 min at various temperature and relative humidity conditions, the number of adhering cells ranged from 4.0 to 5.4 log CFU/fruit (1.2% of inoculum). Both the type of product and the temperature/relative humidity combination had a significant (P < 0.05) effect on attachment of Salmonella Montevideo to the surfaces of tomatoes and tomatillos. Scanning electron micrographs of the cuticles of inoculated washed tomatoes and tomatillos revealed typical skin cell patterns, and only a few randomly dispersed Salmonella Montevideo were observed. Deposition of Salmonella Montevideo on the surface of tomatoes and tomatillos could result in attachment and subsequent colonization under suitable conditions.     

AC-coupled front-end for biopotential measurements

AC coupling is essential in biopotential measurements. Electrode offset potentials can be several orders of magnitude larger than the amplitudes of the biological signals of interest, thus limiting the admissible gain of a dc-coupled front end to prevent amplifier saturation. A high-gain input stage needs ac input coupling. This can be achieved by series capacitors, but in order to provide a bias path, grounded resistors are usually included, which degrade the common mode rejection ratio (CMRR). This paper proposes a novel balanced input ac-coupling network that provides a bias path without any connection to ground, thus resulting in a high CMRR. The circuit being passive, it does not limit the differential dc input voltage. Furthermore, differential signals are ac coupled, whereas common-mode voltages are dc coupled, thus allowing the closed-loop control of the dc common mode voltage by means of a driven-right-leg circuit. This makes the circuit compatible with common-mode dc shifting strategies intended for single-supply biopotential amplifiers. The proposed circuit allows the implementation of high-gain biopotential amplifiers with a reduced number of parts, thus resulting in low power consumption. An electrocardiogram amplifier built according to the proposed design achieves a CMRR of 123 dB at 50 Hz.     

Operational Remote Sensing of Aerosols over Land to Account for Directional Effects

The assumption that the ground is a Lambertian reflector is commonly adopted in operational atmospheric corrections of spaceborne sensors. Through a simple modeling of directional effects in radiative transfer following the second simulation of the satellite signal in the solar spectrum (6S) approach, we propose an operational method to account for the departure from Lambertian behavior of a reflector covered by a scattering medium. This method relies on the computation of coupling terms between the reflecting and the scattering media and is able to deal with a two-layer atmosphere. We focus on the difficult problem of aerosol remote sensing over land. One popular sensing method relies on observations over dense dark vegetation, for which the surface reflectance is low and quite well defined in the blue and in the red. Therefore a study was made for three cases: (1) dark vegetation covered by atmospheric aerosols, (2) atmospheric aerosols covered by molecules, and finally (3) dark vegetation covered by atmospheric aerosols covered by molecules. Comparisons of top-of-the-atmosphere reflectances computed with our modeling and reference computations made with the successive-order-of-scattering code show the robustness of the modeling in the blue and in the red for aerosol optical thicknesses as great as 0.6 and solar zenith angles as large as 60 degrees . The model begins to fail only in the blue for large solar zenith angles. The benefits expected for aerosol remote sensing over land are evaluated with an aerosol retrieval scheme developed for the Medium-Resolution Imaging Spectrometer. The main result is a better constraint on the aerosol model with inclusion of directional effects and a weaker effect on the optical thickness of the retrieved aerosol. The directional scheme is then applied to the aerosol remote-sensing problem in actual Indian Remote Sensing Satellite P3/Modular Optoelectronic Scanner images over land and shows significant improvement compared with a Lambertian algorithm. Moreover, it confirms our main theoretical conclusion.     

Ab initio insights into the visible luminescent properties of ZnO

The luminescence spectrum of ZnO exhibits, besides a UV band-edge recombination line, a broad visible band around 2.2-2.4 eV whose origin has not been satisfactorily established. Recently, analysis of the luminescence of nanostructured materials with high surface-to-volume ratios has led some authors to suggest that the band could be related to surface states. This work presents a novel ab initio study of the most relevant ZnO surfaces and their intrinsic point defects. It reveals the existence of intragap surface states 0.5 eV above the valence band maximum. If additional bulk defect levels are considered, several bulk-to-surface transitions are compatible with the observed visible luminescence.     

Stress Power Dependent Self-Heating Degradation of Metal-Induced Laterally Crystallized n-Type Polycrystalline Silicon Thin-Film Transistors

Using a fluorinated high-k/metal gate stack combined with a stress relieved preoxide (SRPO) pretreatment before high-k deposition, we show significant device reliability and performance improvements. This is a critical result since threshold voltage instability may be a fundamental problem, and performance degradation for high-fc is a concern. The novel fluorinated Ta_infinC_y/HfZrO_infin/SRPO gate stack device exceeds the positive-bias-temperature-instability and negative-bias-temperature-instability targets with sufficient margin and has electron mobility at 1 MV/cm comparable to the industrial high-quality polySi/SiON device on bulk silicon.     

A unified approach to modelling the performance of concurrent systems

Quantitative design is crucial to ICT and it is therefore important to integrate performance modelling techniques into support environments that facilitate the correct construction of computer systems. We consider Performance Modelling Interchange Formats (PMIFs), which allow models to be specified in a uniform way and ported to a number of tools that solve them. We focus on extending the class of models describable in a PMIF that can be solved analytically – specifically, yielding a product-form solution for their equilibrium state probabilities. We use an extension of an established theorem, called the ‘reversed compound agent theorem’ (RCAT) as the basis of the analytical modelling tool into which the extended PMIF feeds models. We describe the RCAT methodology in practical terms, how it is integrated into an extended PMIF, and illustrate our methodology with three examples.     

Learning directed probabilistic logical models: ordering-search versus structure-search

We discuss how to learn non-recursive directed probabilistic logical models from relational data. This problem has been tackled before by upgrading the structure-search algorithm initially proposed for Bayesian networks. In this paper we show how to upgrade another algorithm for learning Bayesian networks, namely ordering-search. For Bayesian networks, ordering-search was found to work better than structure-search. It is non-obvious that these results carry over to the relational case, however, since there ordering-search needs to be implemented quite differently. Hence, we perform an experimental comparison of these upgraded algorithms on four relational domains. We conclude that also in the relational case ordering-search is competitive with structure-search in terms of quality of the learned models, while ordering-search is significantly faster.     

Response of Mythimna unipuncta Males to Components of the Sesamia nonagrioides Pheromone

Several sympatric lepidopteran species feed on maize plants, and the different components of their species-specific female sex pheromones may play a role in attracting conspecifics and/or deter heterospecific males. In this study, we analyzed the content of Mythimna unipuncta pheromone glands and tested the response of males to components of their own pheromone blend and that of Sesamia nonagrioides in the wind tunnel. Whole pheromone glands, and lures where (Z)-9-hexadecenyl acetate, Z)-11-hexadecen-1-ol or (Z)-9-hexadecenyl acetate + (Z)-11-hexadecen-1-ol were added to the major component, (Z)-11-hexadecenyl acetate, elicited significantly higher responses by M. unipuncta males than lures with main component alone, although the levels varied with concentration. In the field a rather different outcome was observed, as the addition of other compounds found in the female pheromone gland did not improve trap catch over lures with only (Z)-11-hexadecenyl acetate. The addition of (Z)-11-hexadecenal, a compound of the S. nonagrioides pheromone, to (Z)-11-hexadecenyl acetate significantly reduced attraction of M. unipuncta males both in the wind tunnel and in the field, as well as the number of sympatric clover cutworm, Discestra trifolii, under field conditions. The addition of (Z)-9-hexadecenyl acetate, a minor component of the M. unipuncta pheromone blend, reduced the number of S. nonagrioides captured in field traps that were baited with the S. nonagrioides lure. The significance of such inhibition in the reproductive isolation of sympatric species that attack maize is discussed.