An application of rapid freezing,freeze substitution–fixation for scanning electron microscopy

A combined technique of the rapid freezing, freeze substitution–fixation method and the osmium–DMSO-osmium method was devised. By this combined method we clearly observed the architecture of intracellular components in three dimensions. Morphological characteristics were generally similar to those of tissue prepared by the osmium–DMSO-osmium method but different in some respects. Mucigen droplets in intestinal goblet cells, for example, appeared as separated spheres, while in specimens prepared by chemical fixation they were observed as a mass of fused droplets. In the Golgi complex, all cisternae were extremely flat, although they usually dilated on the cis side after chemical fixation. Particles on the mitochondrial tubules of liver cells were well distinguished. They were mushroom shaped, as are those observed by negative staining. The combined method, that is, the rapid freezing, osmium–DMSO-osmium method, is thought to be effective for studying the true structure of intracellular components by scanning electron microscopy.     

Monolithic rat-race mixers for millimeter waves

In this paper, we report on fully monolithic millimeter-wave Schottky-barrier diode (SBD) down-converters with an IF amplifier using heterojunction bipolar transistors (HBT's). A rat-race circuit is used for the mixer, and is analyzed using a harmonic-balance simulator. The measured conversion gain and the isolation are 7.1 and 29 dB in the V-band design, and 8.0 and 25 dB in the W-band design, respectively. The conversion gains are matched well with the circuit simulation     

Comparison of the effect of a proteolytic enzyme dispase and a chelator for the preparation of epidermal sheet from nude mice.

Histochemical studies of epidermal Langerhans cells require well-preserved epidermal sheets. We studied the conditions for the preparation of the epidermal sheets from the skin of the ear, hind limb and trunk of nude mice. Two types of commercial dispase, and ethylenediaminetetraacetic acid (EDTA), were used at several concentrations and the effects were compared. Dermo-epidermal separation was evaluated by the preservation of ATPase activity of Langerhans cells in the epidermal sheet and by the ultrastructure of epidermal cells (Langerhans cells and keratinocytes) as well as epidermal-dermal junction. Good separation depended on the combination of the concentration of the reagent and site of the skin. The concentrations of both dispase and EDTA effective for separation of the epidermis in the nude mouse were lower than those in other mouse strains reported.     

In vivo effect of growth-inhibitor produced by Pseudomonas aeruginosa isolates and anti-pseudomonal drugs on model infection due to Pseudomonas aeruginosa

Pseudomonas aeruginosa Nos. 1 and 5, each co-existing growth-inhibitor-producing and -nonproducing cells, were used in this study. An equal number of both cells (each 10(8) CFU/mouse) was challenged intraperitoneally to mice, and these cells in the heart blood and kidneys of mice were determined. Furthermore, the effect of piperacillin, ceftazidime and sisomicin on the cell distribution in mice was studied in the model infection due to P. aeruginosa Nos. 1 and 5. As a control experiment both cells of P. aeruginosa No. 1 were each challenged intraperitoneally at a dose of 10(8) CFU/mouse to mice of two groups, but there were no marked differences between the two types in cell counts of the heart blood or kidneys 9 hours after challenge. When a concomitant challenge of both cells (each 10(8) CFU/mouse) was performed in mice, the number of growth-inhibitor-producing cells of the heart blood and kidneys was about 100 times greater than that of the non-producing cells. These in vivo results were well comparable to the previous in vitro results and indicated that the inhibitor affected the invasion of the non-producing bacteria in the body in the model infection due to P. aeruginosa isolates consisting of the two types of cells. Similar results were obtained in mice with the model infection due to P. aeruginosa No. 5. Anti-pseudomonal drugs such as piperacillin (50 mg/mouse) and ceftazidime (50 mg/mouse) and sisomicin (1 mg/mouse) were given intramuscularly to mice infected concomitantly with both cells of P. aeruginosa No. 1.(ABSTRACT TRUNCATED AT 250 WORDS)     

Geographic distribution of medical supplies and the numbers of hospital inpatients in the secondary medical areas in Japan

A secondary medical area is defined as a medical administrative area under the Medical Care Law by which every prefectural government is expected to provide general medical care supplies such as beds for inpatients. This study evaluated the distribution in medical supplies among the secondary medical areas in Japan and the correlation between medical supply and demand. The numbers of hospital inpatients (residence of patients), physicians, and general beds excluding those for mental disorders and tuberculosis were analysed in relation to the population in all secondary medical areas in Japan. Those data were obtained from surveys conducted by the Ministry of Health and Welfare. The main results were as follows; 1) The distribution of physicians and general hospital beds among the secondary medical areas was not equal. 2) Even adjusted for the sex and age distribution, the highest hospital inpatients/population ratio among the secondary medical areas was four times as large as that of the lowest. 3) With multiple regression models, two independent variables (normal hospital beds/population ratio and aged 65 and over/total population ratio) accounted about 60% of the variance in hospital inpatients/population ratio. 4) The differences in medical supplies among the secondary medical areas may cause the differences in hospital inpatients/population ratio.     

Design of pseudo-ternary and quaternary alloys by superlattices consisting of (zn,cd)(s,se) binary ii–vi compounds

Theoretical design of pseudo-ternary and quaternary alloys by superlattice structures consisting of (Zn,Cd)(S,Se) binary II–VI compounds has been studied. For pseudo-ternary ZnCdS and ZnCdSe alloys, the superlattices with two layers in a cycle, i.e., ZnS/CdS and ZnSe/CdSe are considered, and for pseudo-quaternary ZnCdSSe alloy, the two superlattice structures with more than two layers in a cycle are considered. In order to design and evaluate these superlattices, the expression for the equilibrium in-plane lattice constant of these superlattices has been derived by minimizing the total elastic strain energy in the cycle. The combinations of layer thicknesses in a cycle and the effective bandgap of these superlattices have been calculated while the elastic strain effect was included. The usefulness of these superlattice structures has been evaluated.     

OA&M framework for multiwavelength photonic transport networks

Photonic networks based on wavelength division multiplexing (WDM) and optical path technologies are expected to realize flexible, transparent, and cost-effective transport networks with a large transmission capacity. This paper explores the design framework of photonic transport networks taking into consideration the operation administration and maintenance (OA&M) functions required for the successful introduction of WDM systems based on the optical path concept. From the view point of network maintenance, clear distinction is made between the optical path layer and the optical section layer to facilitate accurate and smooth failure localization. The digital multiplexing span between physical multiplexing interfaces at the end-to-end digital nodes should have the same maintenance span as the corresponding optical path. We argue that cooperative maintenance by OA&M functions at both the digital and optical layers can be a practical way of network supervision. A supervisory (SV) signal transfer method and a configuration that is suitable for the terrestrial trunk network are also indicated. As an example, a practical SV system design methodology and an actual procedure developed for a single channel optical transmission system based on optical in-line amplifiers are introduced. Furthermore, application of the developed SV system and network restoration schemes is discussed for future WDM-based photonic networks. The OA&M aspects introduced will be valuable for creating future photonic network systems     

Oxidation behaviours of carbon/carbon composite with multi-coatings of LaB6-Si/polycarbosilane/SiO2

The influence of multi-coatings of LaB₆-Si/polycarbosilane/SiO₂ on the oxidation behaviour of carbon/carbon composite materials was investigated in the temperature range from 500 to 1400 °C. The additives of LaB₆-Si offered lower oxidation rates and accelerated increases in oxidation rates at temperatures below 900 °C. The coating of polycarbosilane (PCS) improved the compatibility of the coating on the carbon/carbon composite and lowered the oxidation rates of the LaB₆-Si coated composite below the transition temperature. With the SiO₂ coating, the cracks of the LaB₆-Si/PCS coating was sealed and a good oxidation resistance of the LaB₆-Si/PCS/SiO₂ coated composite was found at temperatures up to 1300 °C.