Comparison of two techniques for reliable characterization of thin metal-dielectric films

In the present study we determine the optical parameters of thin metal-dielectric films using two different characterization techniques based on nonparametric and multiple oscillator models. We consider four series of thin metal-dielectric films produced under various deposition conditions with different optical properties. We compare characterization results obtained by nonparametric and multiple oscillator techniques and demonstrate that the results are consistent. The consistency of the results proves their reliability.     

Ellipsometric study of thermally induced redistribution and crystallization of Ge in Ge:SiO2 mixture layers

Mixture layers of Ge:SiO₂ of 40:60 mol% respectively, have been prepared by co-sputtering. The thermally induced change of optical properties of the layers was studied by variable angle spectroscopic ellipsometry. The mixture was modelled as an unknown material with optical constants described by multiple oscillators. The optical parameters determined from ellipsometric measurements can be well correlated with structural changes in the mixture. The results indicate that Ge in the mixture deposited or annealed up to 600 °C is in an amorphous state and it redistributes with increase of temperature, changing refractive index through the layer. The crystallization starts between 600 and 650 °C, at first next to the substrate. Crystallites size grows with temperature. Results were compared with findings of grazing incidence wide angle X-ray scattering measurements and a good agreement was found. Ellipsometry has been shown to be an appropriate non-invasive technique for characterization of this kind of layers.     

The effect of the mass ratio of hard and soft segments on some properties of thermoplastic poly(ester‐siloxane)s

A series of thermoplastic elastomers based on soft polydimethylsiloxane (PDMS) and hard poly(butylene terephthalate) (PBT) segments was synthesized using a two‐step transesterification reaction in the melt. The molar mass of the soft PDMS component was constant (M?_nPDMS = 1056 g mol^?1) while the starting reaction mixture compositions were varied to obtained copolymers with a mass ratio of hard to soft segments in the range from 70/30 to 40/60. The structure and composition of the copolymers was verified by ¹H NMR spectroscopy. It appeared that there was a pronounced molar mass maximum when the PBT content of the copolymers was approximately 60 mass%, whereas all samples were considerably inhomogeneous with respect to the distribution of the lengths of the hard segments. Differential scanning calorimetry (DSC) thermograms showed that the melting and crystallization temperature increased with increasing PBT content, as did the total degree of crystallinity, which was confirmed by wide‐angle X‐ray scattering (WAXS) analysis. Thermogravimetric analysis (TGA) performed in nitrogen gave subtle differences for samples of different composition, including that of the PBT homopolymer, whereas in oxygen these differences were more pronounced in the way the thermo‐oxidative stability of the obtained copolymers decreased with decreasing PBT content. Finally, it was shown that the hardness depended directly on the PBT content, ie the higher the PBT content, the greater the hardness of the corresponding copolymer. Copyright © 2004 Society of Chemical Industry     

Evaluation of a Novel Plasmid for Simultaneous Gene Electrotransfer-Mediated Silencing of CD105 and CD146 in Combination with Irradiation

Targeting tumor vasculature through specific endothelial cell markers represents a promising approach for cancer treatment. Here our aim was to construct an antibiotic resistance gene-free plasmid encoding shRNAs to simultaneously target two endothelial cell markers, CD105 and CD146, and to test its functionality and therapeutic potential in vitro when delivered by gene electrotransfer (GET) and combined with irradiation (IR). Functionality of the plasmid was evaluated by determining the silencing of the targeted genes using qRT-PCR. Antiproliferative and antiangiogenic effects were determined by the cytotoxicity assay tube formation assay and wound healing assay in murine endothelial cells 2H-11. The functionality of the plasmid construct was also evaluated in malignant melanoma tumor cell line B16F10. Additionally, potential activation of immune response was measured by induction of DNA sensor STING and proinflammatory cytokines by qRT-PCR in endothelial cells 2H-11. We demonstrated that the plasmid construction was successful and can efficiently silence the expression of the two targeted genes. As a consequence of silencing, reduced migration rate and angiogenic potential was confirmed in 2H-11 endothelial cells. Furthermore, induction of DNA sensor STING and proinflammatory cytokines were determined, which could add to the therapeutic effectiveness when used in vivo. To conclude, we successfully constructed a novel plasmid DNA with two shRNAs, which holds a great promise for further in vivo testing.     

Design of Mobile Phones for Older Adults: An Empirical Analysis of Design Guidelines and Checklists for Feature Phones and Smartphones

Design guidelines and checklists are suggested as a useful tool in the development and evaluation of interface design of mobile phones for older adults. Given the intense evolution of mobile phone design, understanding how the design guidelines and checklists have taken into account the advances in mobile phone usability for older adults is important for their correct application and future development. Thus, this study explores the usability dimensions of mobile phone design for older adults and the related changes in terms of time and the type of device (feature phones vs. smartphones) based on an expert coding of the eight mobile phone design guidelines and checklists for older adults published between 2006 and 2014. The results of the expert coding show that design guidelines and checklists most frequently deal with visual and haptic issues (e.g., high contrast, button type, and button size), whilst they hardly ever address various elements of textual interface (e.g., ease of text entry, a button’s feedback, and font type). Over time, the design guidelines and checklists have become more complex in terms of the average number of included usability categories and dimensions. For smartphones, the guidelines, on average, put more emphasis on the screen, touchscreen, text, and exterior related issues, whereas the design guidelines for feature phones stress the usability of the keypad and menus. Besides revealing potential usability dimensions that could be further expanded in the guidelines, this study also highlights the need for research that would empirically validate the design guidelines and checklists in the future.     

Sensitivity Analysis of a Physically Based Distributed Model

The objective of this study is to perform a sensitivity analysis of the SHETRAN model on the example of the torrential Lukovska River catchment in Serbia. The sensitivity analysis of the model was performed for the following parameters: the vertical saturated hydraulic conductivity of the subsurface soil, the horizontal saturated hydraulic conductivity in the saturated zone, the Strickler roughness coefficients for overland flow and for streams, the available water content in the soil and the erodibility coefficients due to rain and due to overland flow. It can be concluded that the water and sediment discharge are very sensitive to the values of the vertical saturated hydraulic conductivity of the subsurface soil in the range of 0.001 to 0.1 m/day; to the values of the horizontal saturated hydraulic conductivity in the saturated zone in the range of 0.01 to 5 m/day and to the values of the Strickler’s coefficients for overland flow and for rivers in the range of 0.1 to 100 m1/3s-1 and 15 to 40 m1/3s, respectively. The sediment concentrations in a flow and sediment discharge are very sensitive to the values of erodibility coefficient due to overland flow in the range of 0.5 to 1.5 mg/m2s and to the values of erodibility coefficient due to rain in the range between 0.1 and 40 J-1. The obtained results could be used to simplify the parameter calibration procedure and to facilitate estimation of parameters in ungauged mountainous basins of similar characteristics.     

Poly(ether-ester)s modified with different amounts of fumaric moieties

A series of novel poly(ether-ester)s modified with fumaric moieties is synthesized by transesterification in the melt of dimethyl terephthalate (DMT), dimethyl fumarate (DMF), 1,4-butanediol (BD) and poly(tetramethylene oxide) (PTMO, M?_n=1000 g/mol). The effect of the introduction of double bonds into both the hard and soft segments and their content on the structure and the thermal and rheological properties of the synthesized polymers are investigated. The introduction of double bonds into the polymer main chains increases the molecular weight of the copolyesters, but reduces the crystallinity of the hard segments and related properties such as modulus and hardness. The presence of double bonds improves the high temperature properties and thermal stability, especially the thermo-oxidative one, lowers the melting and crystallization temperature and increases the glass transition temperature. The incorporation of fumaric moieties into the macrochains improves the adhesive strength of the polymer to a metal surface.     

Antioxidant Potential,Lipid Peroxidation Inhibition and Antimicrobial Activities of Satureja montana L. subsp. kitaibelii Extracts

The antioxidant activity of different Satureja montana L. subsp. kitaibelii extracts was tested by measuring their ability to scavenge reactive hydroxyl radical during the Fenton reaction, using ESR spectroscopy. Also, the influence of these extracts on lipid peroxyl radicals obtained during lipid peroxidation of: (I) sunflower oil (37 ºC, 3h) induced by 4,4′-azobis(4-cyanovaleric acid) (ACVA) and (II) liposomes induced by 2,2′-azobis(2- amidino-propane)dihydrochloride (AAPH) was studied. n-Butanol extract had the best antioxidant activity (100% at 0.5 mg/mL in Fenton reaction system; 89.21% at 5 mg/mL in system I; 83.38% at 5 mg/mL in system II). The antioxidant activities of the extracts significantly correlated with total phenolic content. The antimicrobial activity of Satureja montana L. subsp. kitaibelii extracts was investigated. Petroleum ether, chloroform and ethyl acetate extracts expressed a wide range of inhibiting activity against both grampositive and gram-negative bacteria.     

Total mercury,methylmercury and selenium in mercury polluted areas in the province Guizhou,China

The province of Guizhou in Southwestern China is currently one of the world's most important mercury production areas. Emissions of mercury from the province to the global atmosphere have been estimated to be approximately 12% of the world total anthropogenic emissions. The main objective of this study was to assess the level of contamination with Hg in two geographical areas of Guizhou province. Mercury pollution in the areas concerned originates from mercury mining and ore processing in the area of Wanshan, while in the area of Quingzhen mercury pollution originates from the chemical industry discharging Hg through wastewaters and emissions to the atmosphere due to coal burning for electricity production. The results of this study confirmed high contamination with Hg in soil, sediments and rice in the Hg mining area in Wanshan. High levels of Hg in soil and rice were also found in the vicinity of the chemical plant in Quingzhen. The concentrations of Hg decreased with distance from the main sources of pollution considerably. The general conclusion is that Hg contamination in Wanshan is geographically more widespread, due to deposition and scavenging of Hg from contaminated air and deposition on land. In Quingzhen Hg contamination of soil is very high close to the chemical plant but the levels reach background concentrations at a distance of several km. Even though the major source of Hg in both areas is inorganic Hg, it was observed that active transformation of inorganic Hg to organic Hg species (MeHg) takes place in water, sediments and soils. The concentration of Hg in rice grains can reach up to 569 microg/kg of total Hg of which 145 microg/kg was in MeHg form. The percentage of Hg as MeHg varied from 5 to 83%. The concentrations of selenium can reach up to 16 mg/kg in soil and up to 1 mg/g in rice. A correlation exists between the concentration of Se in soil and rice, indicating that a portion of Se is bioavailable to plants. No correlation between Hg and Se in rice was found. Exposure of the local population to Hg may occur due to inhalation of Hg present in air (in particular in Hg mining area) and consumption of Hg contaminated food (in particular rice and fish) and water. Comparison of intake through these different routes showed that the values of Hg considerably exceed the USA EPA Reference Concentration (RfC) for chronic Hg exposure (RfC is 0.0004 mg/m(3)) close to the emission sources. Intake of Hg through food consumption, particularly rice and fish, is also an important route of Hg exposure in study area. In general, it can be concluded that the population mostly at risk is located in the vicinity of smelting facilities, mining activities and close to the waste disposal sites in the wider area of Wanshan. In order to assess the real level of contamination in the local population, it is recommended that biomonitoring should be performed, including Hg and MeHg measurements in hair, blood and urine samples.