聚合氯化铝铁的制备、使用及混凝机制研究

以氯化铝和氯化铁为原料制备出一系列不同铝铁物质的量比及碱化度的无机高分子混凝剂——聚合氯化铝铁（PAFC）,并应用于地表水的混凝处理过程。考察PAFC的混凝效能及产生的絮体特性,进而对其使用条件进行优化并分析混凝机制。结果表明,PAFC为多羟基桥连的铝铁聚合物,水解后发生电中和作用使胶粒脱稳,而后通过羟桥和氧桥联接产生架桥和卷扫沉淀作用,混凝效果优异。PAFC的pH适用范围较宽,但铝铁物质的量比对其水解过程影响较大,在铝铁物质的量比为7:1、碱化度为0.5、投加量为10 mg/L时,絮体的粒度及生长速度最大,此时浊度和UV₂₅₄的去除率分别达84.93%和78.52%。此外,正交实验的结果表明水力条件对PAFC的混凝效能影响显著,其最佳使用条件为：快搅时间为20 s、快搅速度为200 r/min、慢搅时间为15 min、慢搅速度为40 r/min。     

郭沫若的翻译理论与思想探析

从探讨郭沫若的生平背景入手,介绍了他的翻译成就,并对郭沫若的翻译理论和翻译思想做出了初步的剖析。郭沫若的翻译实践主要可以从郭沫若译著《英诗译稿》和《浮士德》窥见一斑,而郭沫若的翻译理论则可从罗新璋所著的《翻译论集》和方克平所著的《溯洄从美:从批判理论到文学翻译》中探出精髓。对郭沫若翻译实践和理论的研究可以发现郭沫若的"创作论"的地位固然不可撼动,但其中对于创作的维度却并没有提出很好的标准。     

Combination of heat treatment and chitosan coating to improve postharvest quality of wolfberry (Lycium barbarum)

The synergistic application of hot water dip at 42 °C for 30 min and 1% chitosan coating on differentiation in postharvest quality traits, microstructure as well as microbiological evolution of wolfberry fruits was investigated. Fresh wolfberry fruits were stored at 2 ± 0.5 °C and 90% relative humidity (RH) for 28 days. Results indicated the combination of prestorage heat treatment and chitosan coating maintained higher levels of ascorbic acid, total phenolic contents and antioxidant capacity as well as lower decay, compared with untreated wolfberry fruits. The possible mechanism was that the heat treatment almost sealed open stomata to limit the sites of pathogen penetration into fruits independently, followed by the biofilm formed by chitosan which controlled secondary infections as well as slowed changes in fruit respiration and metabolic activity in wolfberries. The synergistically treated fruit also exhibited a higher acceptability obtained by sensory analysis after cold storage. In this sense, the integrated application of heat treatment and chitosan coating could be regarded as an effective strategy to extend storage life and maintain the postharvest quality of wolfberry fruits.     

某水电厂励磁系统跨接器故障分析

本文对一起机组起励时灭磁电阻严重烧坏并最终导致停机的事故进行分析,查找出灭磁电阻严重烧坏的原因.通过一系列试验,模拟机组起励停机过程,证明此次故障是由于机械跨接器在实际运行中存在缺陷造成的.最后,为防止此类事故再次发生,提出相关技术改造意见,以保证励磁系统安全稳定运行.     

Heat propagation in thermally conductive polymers of PA6 and hexagonal boron nitride

Thermally conductive polymers offer new possibilities for the heat dissipation in electric and electronic components, for example, by a three‐dimensional shaping of the heat sinks. To face safety regulations, improved fire performance of those components is required. In contrast to unfilled polymers, those materials exhibit an entirely different thermal behavior. To investigate the flammability, a phosphorus flame retardant was incorporated into thermally conductive composites of polyamide 6 and hexagonal boron nitride. The flame retardant decreased the thermal conductivity only slightly. However, the burning behavior changed significantly, due to a different heat propagation, which was investigated using a thermographic camera. An optimum content of hexagonal boron nitride for a sufficient thermal conductivity and fire performance was found between 20 and 30 vol%. The improvement of the fire performance was due to a faster heat release out of the pyrolysis zone and an earlier decomposition of the flame retardant. For higher contents of hexagonal boron nitride, the heat was spread faster within the part, promoting an earlier ignition and increasing the decomposition rate of the flame retardant.     

脉冲高度权重技术测量197Au中子俘获截面

脉冲高度权重技术是利用C_6D_6探测器测量中子俘获截面的一种数据处理方法。在中国散裂中子源(China Spallation Neutron Source,CSNS)的反角白光中子源(Back-n)靶站上,通过测量金靶(~(197)Au)的中子俘获截面,验证了该方法的可靠性。首先利用Geant4蒙特卡罗程序模拟给出了不同靶条件下的探测器效率,脉冲高度权重函数等基本项,使得加权后的探测器效率与γ能量成正比。然后通过实验测量了~(197)Au中子俘获截面。结果表明:测量获得的中子俘获截面数据和ENDF/B-VⅢ.0评价数据相符合,同时发现随着实验靶尺寸的不同和质子束功率的增加,会使得实验本底的扣除误差越来越大。     

300M超高强钢在中性盐雾环境中的腐蚀行为及机制

摘要：为了研究300M超高强钢在中性盐雾环境中的腐蚀行为及腐蚀机制，采用失重法，宏观、微观腐蚀形貌分析，三维表面轮廓分析及电化学分析的研究方法，来表征腐蚀实验现象并进行分析。结果表明：300M超高强钢在中性盐雾环境中的腐蚀产物为FeOOH、Fe2O3、Fe(OH)3和Fe3O4；腐蚀速率随着腐蚀时间逐渐降低，腐蚀后期（72h）腐蚀速率降低50%；腐蚀初期以点蚀为主，点蚀坑通过横向扩展，逐渐发展为后期的均匀腐蚀，腐蚀表面形貌呈沟壑状；外腐蚀层对基体的保护能力很弱，Cr元素在锈层靠近基体的一侧偏聚使内腐蚀层具有一定的抗腐蚀性。     

高氯酸铵含量对高铝富燃料推进剂中重要组分高氯酸铵/铝 一次燃烧性能和铝粉团聚的影响

采用CO2激光点火装置联合高速摄影系统及扫描电子显微镜等凝聚相燃烧产物分析技术，研究了高氯酸铵(AP)含量对高Al富燃料推进剂中重要组分AP/Al一次燃烧过程中燃烧现象、引燃时间、燃烧扩散时间、燃尽时间、燃烧效率、颗粒团聚及凝聚相燃烧产物的表面形貌、粒径及其分布的影响。结果表明，各AP/Al混合粉体的燃烧过程均可分为表面引燃、燃烧扩散和火焰熄灭3个阶段，但各样品在不同燃烧阶段的燃烧现象存在明显差异。AP含量由10wt%增至30wt%，样品燃烧剧烈程度增强，燃烧过程中固相颗粒的溅射现象越加明显；在火焰熄灭阶段，各样品燃烧由以停留在样品燃面处的燃烧为主逐渐变为以溅射颗粒的燃烧为主，且随反应进行，燃面已燃固相颗粒最先熄灭，各样品表面引燃时间、燃烧扩散时间、燃烧持续时间均缩短，即燃烧反应速率逐渐加快。在AP/Al混合物中，铝粉的燃烧效率、凝聚相燃烧产物粒度及其团聚程度随AP含量增加而增加。     

Flotation Behavior,Collector Adsorption Mechanism of Quartz and Feldspar-Quartz Systems Using PEA as a Novel Green Collector

Silicon - A novel green cationic surfactant Poly (propylene glycol) bis (2-aminopropyl ether) (PEA) with multiple amine groups was utilized as a collector for flotation separation of quartz from...