Sol–Gel‐Derived High‐Performance Stacked Transparent Conductive Oxide Thin Films

Single‐ and multi‐layer transparent conductive oxide (TCO) thin films exhibiting high performance, good packing density and low surface/interface roughness are deposited on silica glass substrates by the sol–gel method. The crystal and microstructural properties of the TCO thin films are evaluated as an alternate to films prepared by ultra‐high vacuum deposition. Tin‐doped indium oxide (ITO) thin films produced using a two‐step drying process showed low surface roughness because of dense packing structure not only horizontal but also vertical directions. As a result, electrical conductivity, carrier concentration, carrier mobility, and optical transmittance of 2.3 × 10³ S/cm, 8 × 10²⁰ cm^?3, 18 cm²/Vs, and over 98% at 500 nm, respectively, were achieved. A multilayer ZnO/ITO stacked structure was also fabricated using the sol–gel process. Our findings suggest that solution‐based methods show promise as an alternative to existing ultra‐high vacuum methods to fabricate TCO thin films.     

Effect of Ultrasonication on the Microstructure and Tensile Elongation of Zirconia-Dispersed Alumina Ceramics Prepared by Colloidal Processing

To obtain dense, fine-grained ceramics, fine particles and advanced powder processing, such as colloidal processing, are needed. Al₂O₃ and ZrO₂ particles are dispersed in colloidal suspensions by electrosteric repulsion because of polyelectrolyte absorbed on their surfaces. However, additional redispersion treatment such as ultrasonication is required to obtain dispersed suspensions because fine particles tend to agglomerate. The results demonstrate that ultrasonication is effective in improving particle dispersion in suspensions and producing a homogeneous fine microstructure of sintered materials. Superplastic tensile ductility is improved by ultrasonication in preparing suspensions because of the dense and homogeneous fine microstructure.     

Effect of sintering additive on crystallographic orientation in AlN prepared by slip casting in a strong magnetic field

The preparation of oriented AlN bulk ceramics with and without additives was achieved by slip casting in a high magnetic field. The a and b axes of the AlN were aligned parallel to the direction of the magnetic field. The degree of crystallographic orientation was controlled by the viscosity of the slurry and the grain growth during sintering attributed to the sintering additives. The mechanical properties of the textured AlN depended on the direction of the crystallographic orientation.     

Mobilization and Leaching of Natural and Water Dispersible Colloids in Aggregated Volcanic Ash Soil Columns

Colloid-facilitated transport enhances migration of strongly sorbing compounds (e.g., radionuclides, phosphorus, heavy metals) in soil and groundwater. Mobilization, transport and deposition of soil colloids are the underlying processes governing colloid-facilitated contaminant transport. Although significant progress has been made in simulating mobilization and transport/deposition of model colloids in different collector systems, it may be inadequate for the prediction of natural colloidal behavior in the subsurface. This study quantifies the leaching of natural volcanic ash soil colloids (NC) as well as the simultaneous transport of applied water dispersible soil colloids (WDC) in aggregated volcanic ash soil columns. Two water-saturated soil columns were irrigated with artificial irrigation water (AIW) at an intensity of 80 mm/hr for 60 hours. Two additional columns were irrigated at the same intensity, but a colloidal suspension of 5 mg/L was applied after 20 hours for a period of 20 hours. Effluent colloid concentrations were measured in each experiment. HYDRUS-1D was used for the simulation and estimation of colloid transport parameters. The results clearly showed different kinetics for applied colloid transport and natural colloid leaching. Transport of applied WDC followed first-order attachment kinetics, while the two-site equilibrium/kinetic model with equal fractions of equilibrium and kinetic sites best described the leaching of NC. Coupling these best model approaches well predicted the simultaneous leaching of natural and applied colloids, hereby providing a useful tool for the design of colloid-based in-situ soil remediation systems.     

Gas Transport Parameters for Compacted Reddish-Brown Soil in Sri Lankan Landfill Final Cover

Gas exchange through the compacted final cover soil at landfill sites plays a vital role for emission, fate, and transport of toxic landfill gases. This study involved measuring the soil-gas diffusivity (Dp/Do, the ratio of gas diffusion coefficients in soil and free air) and air permeability (ka) for differently compacted soil samples (reddish-brown soil) from the final cover at the Maharagama landfill in Sri Lanka. The samples were prepared by either standard Proctor compaction or hand compaction to dry bulk densities of 1.60–1.94??g?cm-3. Existing and modified models for predicting Dp/Do and ka were tested against the measured data. The simple, single-parameter Buckingham model predicted measured Dp/Do values across compaction levels equally well or better than a dry bulk density (DBD) dependent model and a soil-water retention (SWR) dependent model. The measured ka values for differently compacted samples were highly affected by the compaction level and the sample moisture preparation method. Also, for air permeability, a single-parameter Buckingham-type ka model was most accurate in predicting ka in the differently compacted soil samples. Equivalent air-filled pore diameters (the effective diameter of the drained pores active in leading air through the sample) for gas flow, deq, were calculated from the measured Dp/D0 and ka values. The deq increased with compaction level, suggesting that a very high compaction level creates well-connected macropores in the reduced total pore space of the cover soil. This is an important consideration when designing cover soils for optimally low water and high oxygen exchange while minimizing climate and toxic gas emissions from the waste layer to the atmosphere.     

Switched capacitor circuit for 1/f noise generation using a power-law circuit

A simple switched capacitor (SC) circuit is given which realizes a one-dimensional discrete dynamical system X_n+1 = X_n + ux^z generating intermittent chaos with a 1/f-shaped power spectrum. an integrated circuit with a pair of logarithmic and antilogarithmic amplifiters can easily realize the power-law term x^z which plays a key role in generating l/fnoise. an inevitable small offset voltage ? in the SC circuit governs the cut-off frequency of 1/f noise, and when the dynamical system is modified by introducing an effective ?, the ‘indirect method’ enables us to get the precise power spectrum in the modified system.     

Interactive segmentation of the cerebral lobes with fuzzy inference in 3T MR images.

Measurement of volume and surface area of the frontal, parietal, temporal and occipital lobes from magnetic resonance (MR) images shows promise as a method for use in diagnosis of dementia. This article presents a novel computer-aided system for automatically segmenting the cerebral lobes from 3T human brain MR images. Until now, the anatomical definition of cerebral lobes on the cerebral cortex is somewhat vague for use in automatic delineation of boundary lines, and there is no definition of cerebral lobes in the interior of the cerebrum. Therefore, we have developed a new method for defining cerebral lobes on the cerebral cortex and in the interior of the cerebrum. The proposed method determines the boundaries between the lobes by deforming initial surfaces. The initial surfaces are automatically determined based on user-given landmarks. They are smoothed and deformed so that the deforming boundaries run along the hourglass portion of the three-dimensional shape of the cerebrum with fuzzy rule-based active contour and surface models. The cerebrum is divided into the cerebral lobes according to the boundaries determined using this method. The reproducibility of our system with a given subject was assessed by examining the variability of volume and surface area in three healthy subjects, with measurements performed by three beginners and one expert user. The experimental results show that our system segments the cerebral lobes with high reproducibility.     

Purification and characterization of sea squirt alpha-N-acetylgalactosaminidase

Sea squirt alpha-N-acetylgalactosaminidase was purified to homogeneity. Its molecular weight was estimated to be approximately 160,000 by gel filtration and 40,000 by SDS-polyacrylamide gel electrophoresis (SDS-PAGE) under reducing condition. The chromatographic and electrophoretic behaviors indicated that the enzyme was composed of four subunits. The optimum pH of the enzyme reaction was about 4.0 at 37 degrees C, while the enzyme was stable in the range of pH 5.0 to 6.0 during 4 h preincubation at 37 degrees C. Although the enzyme (0.1 unit) was stable at 0 degrees C for 30 min in the presence of 7.5 mM metal ions (Al3+, Ba2+, Ca2+, K+, Mn2+, Pb2+, Sr2+, and Zn2+), almost 40% of the enzyme activity was lost in the presence of Cu2+, Hg2+, monoiodoacetic acid, and EDTA. The enzyme hydrolyzed aryl N-acetyl-alpha-D-galactosaminide as well as GalNAcalpha1(-->4GalNAcalpha1-->)n 4GalNAc-p-aminobenzoic acid ethyl ester (ABEE) (n = 1-4), but GalNAcalpha1-->4GalNAc-ABEE only scarcely. Furthermore, an allergenic pentasaccharitol ABEE derivative, GalNAcalpha1-->2Fucalpha1-->3(GalNAcbeta1-->4) GlcNAcbeta1-->2(3-acetoamido-3-deoxy)L-threose-ABEE, the minimum structural unit for the sea squirt allergenicity was hydrolyzed to 95 mol% for 72 h incubation with the enzyme. The enzyme could be utilized as a powerful tool for the structural analyses of the carbohydrate epitopes of the sea squirt allergen molecules.     

Allelic diversity in the merozoite surface protein-1 and epidemiology of multiple-clone Plasmodium falciparum infections in northern Tanzania

Allelic diversity in the merozoite surface protein-1 (MSP-1) of Plasmodium falciparum, a major malaria vaccine candidate, was examined in clinical isolates from holoendemic northern Tanzania. The variable blocks 2, 4a, 4b, 6, and 10 of the MSP-1 gene were typed by allelic type-specific polymerase chain reaction. Twenty-four possible MSP-1 gene types were defined as unique combinations of allelic types detected in each variable block. Thirteen gene types were identified, and 187 P. falciparum populations were fully typed among 79 isolates. In contrast with recent findings in Vietnam, we were unable to detect nonrandom associations between allelic types in the typed variable blocks. Most patients (60%) harbored more than 1 genetically distinct parasite population (average: 2.37 populations per isolate) and, in 1 patient, 6 different versions of this single-copy gene were found. Statistical analysis suggests that parasites carrying different MSP-1 gene types are not independently distributed in the host population. The epidemiological consequences of these findings are discussed.