Flight-vehicle structures education in the united states—Assessment and recommendations

An assessment is made of the technical contents of flight-vehicle structures curricula at 41 U.S. universities with accredited aerospace engineering programs. The assessment is based on the technical needs for the new and projected aeronautical and space systems as well as on the likely characteristics of the aerospace engineering work environment. A number of deficiencies and areas of concern are identified and recommendations are presented for enhancing the effectiveness of flight-vehicle structures education. A number of government supported programs that can help aerospace engineering education are listed in the appendix.     

Diazepam alters caffeine-induced effects on beta-endorphin levels in specific rat brain regions

The present study was conducted to evaluate the effects of caffeine and the benzodiazepine agonist diazepam, and a combination of both on beta-endorphin (beta-EN) levels in specific rat brain regions. Male Sprague-Dawley rats (150-200 g) adapted to a 12-hour light: 12-hour dark illumination cycle were used in this study. Caffeine (10 mg/kg), diazepam (2 mg/kg) or a combination of caffeine (10 mg/kg) and diazepam (2 mg/kg) were administered intraperitoneally to rats at 11:00 hr. Control animals were injected with saline. Animals were sacrificed by decapitation 1 h after injection, the brains were immediately removed; the cortex, hippocampus, hypothalamus and midbrain were dissected and their B-EN levels measured by radioimmunoassay. Caffeine administration significantly increased B-EN levels in the cortex. Similarly, administration of diazepam alone resulted in a significant increase of B-EN levels in cortex. However, concurrent administration of diazepam and caffeine resulted in higher increase of B-EN levels in cortex. No significant changes in B-EN levels were detected in hippocampus and midbrain after administration of either caffeine or diazepam alone. On the other hand, when diazepam and caffeine were concurrently administered a significant increase of B-EN levels were observed in the midbrain. Moreover, administration of diazepam alone resulted in a significant increase of B-EN levels in hypothalamus. This increase was still observed following concurrent administration of diazepam and caffeine. These results clearly indicate that diazepam alters caffeine-induced effects on B-EN in specific rat brain regions.     

Boundary element analysis of thin plates internally bounded by rigid patches

Procedures are described for modelling a structural system consisting of thin Kirchhoff plates with internal patch areas capable of displacing as rigid flat surfaces. The physical prototype for these patches could be interconnection points for one-dimensional frame type elements of various shapes and layout, rigidly connected at these finite size 'joints' in the plate. The numerical procedure for modelling the thin plate is the Direct Boundary Element Method (DBEM) and a simple overview of this procedure is provided. Potential trouble spots, of which the user should be aware, are described. The paper will be of interest to structural engineers for analysis of frames having both plate and simple frame elements, for example, building frames; and also to researchers seeking the greater detail that this refined procedure can provide. As a practical tool, the methods described are computationally competitive with existing procedures, including the more rugged approaches used by building structural engineers for dynamic and torsional analysis.     

Optical properties of evaporated Ge20Se80−x Tl x thin films

Chalcogenide glasses with composition Ge₂₀Se_80–x Tl _x (x=10, 15, 20, 25, 35%) have been prepared by the usual melt-quenching technique. Thin films of the mentioned compositions have been prepared by the electron beam evaporation. In addition, another set taken from the composition ofX=30 at % with different thicknesses (d=14.7, 30.0, 56.5, 70.0, 101.0, 180.0 nm) have been taken into consideration. The X-ray diffraction (XRD) analysis revealed the amorphous nature of the prepared films. It was found that, in contrast to the optical gap (E _op), both the extent of the band tailing (B), and the band gap (E _e) increase with increasing thallium content. In other side,E _op showed thickness independency. The refractive index (n) showed obvious dependence on both composition and thickness also on the energy of the incident radiation.     

A 50-MS/s (35 mW) to 1-kS/s (15 /spl mu/W) power scaleable 10-bit pipelined ADC using rapid power-on opamps and minimal bias current variation

A novel rapid power-on operational amplifier and a current modulation technique are used in a 10-bit 1.5-bit/stage pipelined ADC in 0.18-/spl mu/m CMOS to realize power scalability between 1 kS/s (15 /spl mu/W) and 50 MS/s (35 mW), while maintaining an SNDR of 54-56 dB for all sampling rates. The current modulated power scaling (CMPS) technique is shown to enhance the power scaleable range of current scaling by 50 times, allowing ADC power to be varied by a factor of 2500 while only varying bias currents by a factor of 50. Furthermore, the nominal power is reduced by 20%-30% by completely powering off the rapid power-on opamps during the sampling phase in the pipeline's sample-and-holds.     

Targeting optimum resource allocation using reverse problem formulations and property clustering techniques

Decoupling the constitutive equations from the balance and constraint equations allows for reformulating a conventional forward problem into two reverse problems. The first reverse problem is the reverse of a simulation problem, where the process model is solved in terms of the constitutive (synthesis/design) variables instead of the process variables, thus providing the synthesis/design targets. The second reverse problem (reverse property prediction) solves the constitutive equations to identify unit operations, operating conditions and/or products by matching the synthesis/design targets. Visualization of the problem is achieved by employing recently developed property clustering techniques, which allows a high-dimensional problem to be visualized in two or three dimensions. The clusters by definition satisfy intra-stream and inter-stream conservation through linear “mixing” rules, which allows for the development of consistent additive rules along with their ternary representation.     

Analysis and Optimization of Noise in Bipolar RF Harmonic Mixers

A noise analysis of bipolar harmonic mixers (BHM) used for direct-conversion receivers is presented in this paper. Analytical and simulated results for the transfer function of the mixer are presented. Simple analytical expressions describing noise contribution from all sources are derived. Estimation of flicker noise quite agrees with harmonic-balance simulation results. Based on the derived expressions, total time average noise power spectral density (PSD) at the output is compared with simulation results. For the recommended regions of operation, error is less than 20%. The overall BHM noise figure (NF) is calculated and optimized based on a simple extracted formula. Errors introduced by analysis remain within a 1.5-dB margin with respect to simulation results. The validity of analysis for high frequencies is justified. The effect of flicker noise coefficient on the overall mixer NF is compared for different available processes.     

Risk Assessment in Construction

This study is concerned with the assessment of risk for major construction activities. Risk has been defined as a measure of the probability, the severity, and the exposure of all hazards of an activity. A risk assessor model (RAM) was developed and computerized to determine the risk associated with a particular activity and the justification factor for a proposed remedy. Knowing the value of risk would help contractors identify the high risk of major construction activities and would enable them to allocate safety precautions in a more efficient manner.