LD端面抽运掺Yb3+双包层光纤激光器自脉动行为的实验研究

本文对连续波半导体激光器端面抽运的Fabry-Perot腔掺Yb3 双包层光纤激光器的自脉动输出行为进行了研究．发现低Q值腔光纤激光器具有两种形式的自脉动输出，一种是饱和吸收被动调Q产生的自脉冲,另一种是与光纤中的受激Raman散射(SRS)效应相对应的阵发性巨脉冲．通过提高光纤激光器谐振腔的Q值并选择合适的抽运功率，可以有效地减小输出功率的自脉动，获得稳定的连续波激光输出．     

Improvement of AlGaInP light emitting diode by sulfide passivation

The brightness of AlGaInP light emitting diodes (LEDs) has been raised by a factor of 1.12 at 20 mA by sulfide passivation. Meanwhile, the sulfide also can decrease leakage current of AlGaInP LEDs at -2 V to nearly one thousandth of that in the as-fabricated device. The possible causes for the brightness increase of AlGaInP LEDs after sulfide treatment including surface roughness, reduction of Fresnel loss, and effective injection of carriers were demonstrated.     

洼60-H26水平井套铣打捞技术

洼60-H26井是一口中曲率水平井,设计井深1 922 m,由于地面条件的限制,设计采用三维井眼轨道。该井水平段在钻至井深1 801 m时,发生卡钻事故。在卡钻事故处理过程中,采用测卡、爆炸松扣技术取出上部钻具后,应用了不同规格的套铣管对被卡钻具进行套铣,采用间歇式套铣方式实现了大斜度井段(45°-90°)的安全套铣,采用短套铣管完成了时水平井段内φ215．0 mm稳定器的套铣,采用φ228．6 mm套铣管成功套铣水平井段被卡LWD仪器,最后通过震击器震击成功解卡。详细介绍了洼60-H26水平井卡钻事故的处理过程,分析了在水平段处理卡钻事故的难点。该井处理卡钻事故的经验,对以后水平井施工中处理井下事故、打捞贵重仪器具有借鉴价值。     

布帮鞋无浆贴合工艺技术

本工艺是对原有工艺的改进，突破了原有布帮鞋不能采用无浆贴合的局限性，对原有工艺中的不足有了很大的改进，提高了生产效率，改善了鞋子外观质量，增加了鞋子的美观性。     

Suppression control method for torque vibration of three-phase HB-type stepping motor utilizing feedforward control

This paper proposes a method to reduce the vibration of the three-phase HB-type stepping motor with cogging torque by the feedforward compensation control. The compensation signal to suppress the vibration of the motor frame is obtained by the repetitive controller installing an online Fourier transformer and utilizing an acceleration sensor attached to the motor frame or an acoustic sensor such as a microphone placed close to the frame. The sensor is used only for the acquisition of the feedforward compensation data. The feedforward compensation signal at an arbitrary operating point is derived from the amplitude and phase data of the frequency components and the operating point data. Compensation data obtained by the repetitive controller is applied to the operating point changed by reference frequency and load condition in steady state. The compensation signal for the new operating point will be generated from compensation data utilizing polynomial equation approximation and linear interpolation method. The effectiveness of this proposed method is confirmed by the experimental results.     

Effect of alendronate treatment on the osteoclastogenic potential of bone marrow cells in mice

The expression of cytokeratins (CK), involucrin, vimentin, CD34, and alpha-smooth-muscle actin was studied in fetal and adult hair follicles. The first stage of the developing hair follicle is characterized by palisaded, elongated epithelial cells budding from the epidermal basal layer. These cells express CK5/6, CK14, CK17, CK19, and vimentin. During the following weeks of gestation, different structures in the developing hair follicle can be identified and characterized. The matrical cells display only CK19. The keratinocytes of the outer root sheath express CK5/6, CK14, CK17, CK19, and involucrin; those of the inner root sheath, CK4, CK18, and involucrin; those of the isthmus, the same profile as the ORS. In the infundibulum, the basal-layer keratinocytes express CK5/6, CK14, CK17, and CK19, whereas in the suprabasal layers CK1, CK4, CK10, CK14, and CK17 are seen. The adult hair follicle in anagen fails to express CK19 in the matrical cells and isthmus and both CK17 and CK19 in the infundibulum. These profiles of intermediate filaments and other markers appear to be potentially useful in categorizing neoplasms with apparent follicular differentiation.     

Purification of the cardiac sarcoplasmic reticulum membrane protein phospholamban from recombinant Escherichia coli

Phospholamban (PLN) was expressed in Escherichia coli as a protein fusion with glutathione S-transferase (GST). GST-PLN was mostly present in the insoluble protein fraction and accounted for approximately 50% of total insoluble protein. Attempts to suppress inclusion body formation or to use GST as an affinity-purification tag failed. A successful purification method is based on preparative SDS/PAGE and electrodialysis. From 1 g cells we typically purified 13.5 mg fusion protein with a PLN content of 2.8 mg. We genetically inserted an enterokinase (EK) protease site just in front of the PLN sequence and demonstrated the proteolytical liberation of PLN from the carrier protein. The approach described represents a substantial advancement in PLN expression and purification.     

射频板条CO_2激光器并联谐振技术的研究

本文利用周期性网络模型计算了射频板条CO2激光器电极的纵向电压分布．探讨了并联谐振技术在板条器件中获得成功运用的原因．提出了利用并联谐振技术进一步提高电压分布均匀性的两个途径．